ページ1に含まれる内容の要旨
MODEL
UX-K01
Charge the battery for about 10 hours before initial use.
1. Introduction
2. Connecting the Cordless Handset Charger
3. Installing and Charging the Battery
4. Registering the Cordless Handset
5. Enterring a Name for the Cordless Handset
6. Maintenance
2.4GHz Cordless Handset
OPERATION MANUAL
ページ2に含まれる内容の要旨
Introduction To use the UX-K01 Thank you for cordless handset, you purchasing a UX-K01 must have a UX-CC500 cordless handset. fax machine. Specifications Frequency 2.4 GHz (2.405 to 2.475 GHz) Dimensions Width: 1.8" (46 mm) Depth: 1.7" (42 mm) Height: 7.1" (180 mm) (not including antenna) Weight Approx. 0.3 lbs. (
ページ3に含まれる内容の要旨
Important safety information Do not disassemble this product or attempt any procedures not described in this manual. Refer all servicing to qualified service personnel. Do not this product near water, or when you are wet. For example, do not use the product near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool. Take care not to spill any liquids on the product. Unplug the product from the power outlet and consult a qualified service representative
ページ4に含まれる内容の要旨
Connecting the Cordless Handset Charger 1 Connect the AC adapter to the Fit the cord into cordless handset charger. the holders. 2 Plug the AC adapter into a standard 120 V AC outlet. Important: Never cover the charger and AC adapter with a blanket, cloth, or other material. Excessive heating may result and cause fire. Installing and Charging the Battery 1 Connect the battery connector ➊, and then place the battery pack in the cordless handset. Black Red Red Black 2 Place the battery cover
ページ5に含まれる内容の要旨
3 Place the cordless handset in the charger with the dial pad facing forward. • Important! The dial pad must face forward, or the battery will not charge. • The battery charges automatically while the cordless handset is in the charger. While charging, the display shows CHARGING. Charge the battery at least 10 hours • When charging is completed the first the first time! time, the display shows PLEASE REGISTER. After the handset is registered, the display shows IN CHARGER while in t
ページ6に含まれる内容の要旨
Registering the Cordless Handset After the initial charging, To use the cordless the cordless handset handset, you must display shows: first register it using the fax machine. PLEASE REGISTER Cordless handset display: 1 On the cordless handset, hold down MODE SELECT INTER 1: HS ENTRY COM until the display at right appears. 2: HS DELETE 2 Press 1 on the cordless handset. HS ENTRY MODE • If FAX BUSY appears in the display, wait until the fax machine is no longer in use and then start from
ページ7に含まれる内容の要旨
The fax machine is identified by the number “0”, and the cordless handset that was included with the fax is identified by the number “1”. Entering a Name for the Cordless Handset Enter a name for the cordless handset in the fax machine. ♦ The fax machine will transmit the name that you enter to your cordless handset. Fax machine display: FUNCTION 1 Press once and 3 times on ENTRY MODE the fax machine. 2Press once and once. HS NAME SET 3Press once. 1=SET, 2=CLEAR 4 Press to select SE
ページ8に含まれる内容の要旨
6 Enter the name by pressing number keys for each letter as shown in the chart below. Up to 10 characters can be entered. Example: BILL = 22 444 555 555 G = SPACE = N = U = A = H = V = O = B = I = P = W = C = J = Q = X = R = D = K = Y = S = L = Z = E = T = F = M = ♦ To enter two letters in succession that require the same key, press after entering the first letter. SPEAKER ♦ To clear a mistake, press . ♦ To enter a lower case letter, continue pressing the key for the letter until the l
ページ9に含まれる内容の要旨
Maintenance Replacing the Cordless Handset Battery If LOW BATTERY continues to appear in the cordless handset display after the battery has been charged for 10 hours, replace it with the following battery: Replacement battery: Use only a Sharp UX-BA01 battery (3.6 V Ni-MH battery, capacity: 850 mAh) Caution: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufact
ページ10に含まれる内容の要旨
Deleting a cordless handset If you wish to stop using a cordless handset, follow these steps to delete it (cancel the registration in the fax machine). Cordless handset display: 1 On the cordless handset, hold down MODE SELECT INTER until the display at right appears. COM 1: HS ENTRY 2: HS DELETE Example: Cordless handset 2 2 Press on the cordless handset. 2 HS2 DELETE: OK PRESS START KEY PLEASE REGISTER START 3 Press on the cordless handset. Fax machine display: INTERCOM 4 On the fax mach
ページ11に含まれる内容の要旨
FCC regulatory information This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. WARNING - FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user’s authority to operate this equipm
ページ12に含まれる内容の要旨
END USER LIMITED WARRANTY SHARP ELECTRONICS CORPORATION warrants to the first end user purchaser that this Sharp brand product (the "Product"), when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option, either repair the defect or replace the defective Product or part thereof with a new or remanufactured equivalent at no charge to the purchaser for parts or labor for the period(s) set forth below. This warranty does not
ページ13に含まれる内容の要旨
IMPORTANT SERVICE INFORMATION If a Problem Occurs Most operational questions can be answered by referring to this "Setup Guide and Operation Manual" Also, for your convenience, you will find answers to most frequently asked questions on our website at www.sharpusa.com/, or by sending e-mail to faxsupport@sharpsec.com. Should you require further assistance, call 1-877-794-8675; a Customer Relations Specialist will assist you. Before your call, please be ready to provide the model number of your
ページ14に含まれる内容の要旨
SHARP ELECTRONICS CORPORATION Sharp Plaza, Mahwah, New Jersey 07430-2135 http://www.sharpusa.com SHARP CORPORATION FOR YOUR RECORDS Please record the model number and serial number below, for easy reference, in case of loss or theft. These numbers are located on the rear side of the unit. Space is also provided for other relevant information. Model Number UX-K01 Serial Number Date of Purchase Place of Purchase PRINTED IN THAILAND (TCADH3390XHZZ)
