ページ1に含まれる内容の要旨
26980/26981
40-Channel 900MHz
Cordless Telephone
and AM/FM Clock Radio
User’s Guide
We bring good things to life.
ページ2に含まれる内容の要旨
FCC REGISTRATION INFORMATION Your telephone equipment is registered with the Federal Communications Commission and is in compliance with parts 15 and 68, FCC Rules and Regulations. 1 Notification to the Local Telephone Company On the bottom of this equipment is a label indicating, among other information, the FCC Registration number and Ringer Equivalence Number (REN) for the equipment. You must, upon request, provide this information to your telephone company. The REN is useful in determining t
ページ3に含まれる内容の要旨
TABLE OF CONTENTS FCC REGISTRATION INFORMATION .... 2 RINGER SWITCH.............................. 17 INTERFERENCE INFORMATION ............ 2 VOLUME ........................................ 17 HEARING AID COMPATIBILITY ........... 2 LOW BATTERY ................................ 17 INTRODUCTION ..................................... 4 THE MEMORY FEATURE ....................... 18 BEFORE YOU BEGIN .............................. 5 STORING A NUMBER IN MEMORY ...... 18 PARTS CHECKLIST ..................
ページ4に含まれる内容の要旨
INTRODUCTION Your 900 MHz Cordless Telephone is designed to give you flexibility in use and high quality performance. To get the most from your new cordless telephone, we suggest that you take a few minutes right now to read through this instruction manual. IMPORTANT: Because cordless phones operate on electricity, you should have at least one phone in your home that isn’t cordless, in case the power in your home goes out. CAUTION FOR AC POWER SUPPLIES WITH POLARIZING BLADES: TO PREVENT ELECTRI
ページ5に含まれる内容の要旨
BEFORE YOU BEGIN PARTS CHECKLIST Make sure your package includes the items shown here. Beltclip 900 MHz CORDLESS PHONE Headset (provided IN USE (provided with VOLUME TALK with 26981 only) 26981 only) CHARGE IN USE 1 ABC2 DEF3 NITE LITE DISPLAY TIME SET 900 MHz BEDROOM CORDLESS TELEPHONE/CLOCK RADIO SLEEP REV TIME SET FWD GHI JKL MNO 4 5 6 SNOOZE PQRS7 TUV8 WXYZ9 PAGE FIND SEEK WAKE VOLUME RADIO ON/OFF A 1 + TONE OPER STATION AM 1 0 # MUSIC ALARM * WAKE - B REDIAL MEMORY MUTE BATT 2 2 FM
ページ6に含まれる内容の要旨
INSTALLING THE BATTERY Battery compartment door In the event of a power outage, a 9-volt battery (not included) enables the phone to retain numbers stored in memory and the clock to keep accu- rate time. To install the battery: 1. Remove the battery compartment door on the bottom of the unit by removing the screw with a Phillips screwdriver. Slide the door to the right and lift it up. 2. Connect a fresh 9-volt alkaline battery (not included). The large and small contacts on the battery Battery
ページ7に含まれる内容の要旨
DESKTOP INSTALLATION 1 2 3 5 4 6 1. Set the RINGER switch on the handset to ON. 2. Place the handset in the base. 3. Raise the base antenna. 4. Set the TONE/PULSE switch to TONE for touch-tone service, or PULSE for rotary service. If you don't know which type of service you have, check with the phone company. 5. Plug the power supply cord into the base and then into an AC outlet. The CHARGE/IN USE light comes on indicating that the battery is charging. Allow the phone to charge for 12 hours befo
ページ8に含まれる内容の要旨
SETUP SETTING THE TIME AM indicator Follow these steps to set the clock manually. 1. Press and hold the TIME SET button for 2 seconds. The hour blinks on the display. 2. Use the REV or FWD TIME SET buttons to adjust the hour. The AM indicator comes on for the CHARGE IN USE NITE LITE DISPLAY TIME SET SLEEP REV TIME SET FWD 900 MHz BEDROOM CORDLESS TELEPHONE/CLOCK RADIO a.m. hours. SNOOZE PAGE FIND SEEK WAKE VOLUME RADIO ON/OFF 1 A + STATION AM 1 MUSIC ALARM WAKE 3. Press and release TIME SET. The
ページ9に含まれる内容の要旨
CLOCK RADIO OPERATION ANTENNAS AM ANTENNA ANTENNA A built-in ferrite rod antenna is used for AM reception. Rotating the unit slightly may also improve reception for distant AM stations. FM ANTENNA The AC power cord acts as the FM antenna. For best reception, be sure CHARGE IN USE NITE LITE DISPLAY TIME SET SLEEP REV TIME SET FWD 900 MHz BEDROOM CORDLESS TELEPHONE/CLOCK RADIO the power cord is stretched to its SNOOZE PAGE FIND SEEK WAKE VOLUME RADIO ON/OFF 1 full length. Do not coil or bunch the
ページ10に含まれる内容の要旨
VOLUME Use the VOLUME buttons to adjust the radio volume. CHANGING STATIONS Use the TUNE buttons to change the radio station. When you hold down either button, the radio scans the stations automatically. STORING STATIONS IN CHARGE IN USE NITE LITE DISPLAY TIME SET SLEEP REV TIME SET FWD MEMORY 900 MHz BEDROOM CORDLESS TELEPHONE/CLOCK RADIO SNOOZE PAGE FIND SEEK WAKE VOLUME RADIO ON/OFF A 1 + Use the ABC STATION buttons to AM 1 STATION MUSIC ALARM WAKE B - BATT 2 2 FM AM LOW store r
ページ11に含まれる内容の要旨
USING THE PRESET STATIONS 1. Set the FM/AM switch to the setting of the desired preset station. 2. Press the memory location WAKE 1 button button where the station is stored (A, B, or C). The radio tunes to that station. WAKE ALARMS You can set two different alarm times for the radio to wake you CHARGE IN USE NITE LITE DISPLAY TIME SET SLEEP REV TIME SET FWD 900 MHz BEDROOM CORDLESS TELEPHONE/CLOCK RADIO using the WAKE 1 and WAKE 2 SNOOZE PAGE FIND SEEK WAKE VOLUME RADIO ON/OFF A 1 + buttons. Ea
ページ12に含まれる内容の要旨
1. Press and hold the WAKE 1 or WAKE 2 button for 2 seconds. The hours blinks on the display. 2. Use the REV or FWD TIME SET AM indicator buttons to adjust the hour. The AM indicator comes on for the TIME LOCK WAKE 1 button button a.m. hours. 3. Press and release the TIME SET button. The minutes blink on the display. 4. Use REV or FWD to adjust the minutes. CHARGE IN USE NITE LITE DISPLAY TIME SET SLEEP REV TIME SET FWD 900 MHz BEDROOM CORDLESS TELEPHONE/CLOCK RADIO 5. Press and release TIME SET
ページ13に含まれる内容の要旨
SNOOZE After the alarm comes on, you can use the SNOOZE button to delay the alarm from coming on again for 7 more minutes (up to 59 minutes NITE LIGHT button total). SNOOZE button SLEEP button SLEEP Use the SLEEP button to set the radio to automatically turn off after a chosen amount of time (up to 60 minutes). CHARGE IN USE NITE LITE DISPLAY TIME SET SLEEP REV TIME SET FWD 1. Make sure the radio is OFF. 900 MHz BEDROOM CORDLESS TELEPHONE/CLOCK RADIO SNOOZE PAGE FIND SEEK WAKE VOLUME RADIO ON/OF
ページ14に含まれる内容の要旨
TELEPHONE OPERATION RECEIVING A CALL Press the TALK button to answer a call. When finished, press TALK again to hang up. MAKING A CALL To make a call, press the TALK button before you dial and press it again to hang up. REDIAL 900 MHz CORDLESS PHONE IN USE Press the REDIAL button to redial VOLUME the last number you dialed (up to 32 TALK digits). If you get a busy signal, and TALK ABC DEF 1 2 3 button want to keep dialing the number, GHI JKL MNO 4 5 6 just press REDIAL again (you don't PQRS TUV
ページ15に含まれる内容の要旨
FLASH BUTTON Use the FLASH button to activate custom calling services such as call waiting or call transfer, which are available through your local phone company. TIP: Don‘t use the TALK button to activate custom calling services such as call waiting, or you‘ll hang up the phone. CHANNEL BUTTON 900 MHz CORDLESS PHONE While talking, you might need to IN USE manually change the channel in VOLUME TALK order to get rid of static. Press and ABC DEF 1 2 3 release the CHANNEL button to GHI JKL MNO 4 5
ページ16に含まれる内容の要旨
TEMPORARY TONE This feature enables Pulse (rotary) service phone users to access touch-tone services offered by banks, credit card companies, etc., by pressing the TONE button to temporarily make the phone touch- tone compatible. To get information 900 MHz about your bank account, for CORDLESS PHONE IN USE example, you would: VOLUME TALK 1. Call the bank’s information line. ABC DEF 1 2 3 2. Press the TONE button (*) after GHI JKL MNO 4 5 6 your call is answered. PQRS TUV WXYZ 7 8 9 3. Follow the
ページ17に含まれる内容の要旨
Press the PAGE/FIND button on the base. The handset beeps continu- ously for about 2 minutes or until you press any button on the handset or PAGE/FIND on the base. NOTE: You can still page the handset with the ringer off. 900 MHz CORDLESS PHONE RINGER SWITCH IN USE The RINGER switch must be ON for VOLUME TALK the handset to ring during incoming ABC DEF VOLUME 1 2 3 calls. button GHI JKL MNO 4 5 6 PQRS TUV WXYZ 7 8 9 VOLUME TONE OPER # 0 * REDIAL MEMORY MUTE The VOLUME buttons control the OFF ON
ページ18に含まれる内容の要旨
THE MEMORY FEATURE Store up to ten 16-digit numbers in memory for quick dialing. STORING A NUMBER IN MEMORY The phone must be OFF when you store numbers. 1. Press the MEMORY button. 2. Press the memory location number (0-9). 900 MHz 3. Press MEMORY again. CORDLESS PHONE IN USE 4. Use the keypad to enter the VOLUME TALK number you want to store (up to ABC DEF 16 digits). 1 2 3 GHI JKL MNO 4 5 6 5. Press MEMORY again to store PQRS TUV WXYZ 7 8 9 the number. TONE OPER # 0 * 6. Record whose number i
ページ19に含まれる内容の要旨
CHANGING A STORED NUMBER Use the same procedure to change a stored number as you do to store a number—you’re just replacing the phone number with a different one. DIALING A STORED NUMBER 1. Make sure the phone is ON by pressing the TALK button. 2. Press MEMORY. 3. Press the number (0-9) for the desired memory location. The 900 MHz CORDLESS PHONE number dials automatically. IN USE VOLUME TALK IMPORTANT: If you make test TALK ABC DEF 1 2 3 calls to emergency numbers stored button GHI JKL MNO 4 5 6
ページ20に含まれる内容の要旨
CHAIN DIALING FROM MEMORY Use this feature to make calls which require a sequence of numbers such as using a calling card for a frequently called long distance number. Basically, you dial each part of the sequence from memory. The following example shows how you can use chain dialing to make a call through a long distance service: The Number For Memory Location Long distance access number 7 Authorization code 8 Frequently called long distance number 9 1. Make sure the phone is ON. 2. Press MEMO
