ページ1に含まれる内容の要旨
Register your product and get support at
www.philips.com/welcome
CD250
SE250
GB Telephone
Warning
Use only rechargeable batteries.
Charge the handset for 24 hours before use.
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Table of contents 1Important 3 4.1.6 Dialing from the phonebook 1.1 Power requirements 3 while on the phone 17 1.2 Conformity 4 4.1.7 Call using Direct Access 1.3 Using GAP standard Memory 18 compliance 4 4.1.8 Enter a Dialing Pause 18 1.4 Recycling & disposal 4 4.2 Answer a call 18 1.5 Electric, Magnetic and 4.2.1 Handsfree answering 18 Electromagnetic Fields 4.2.2 Call waiting 18 (“EMF”) 5 4.3 End a call 18 2 Your phone 6 5Use more of 2.1 What’s in the box 6 your phone 19 2.2 Overview of you
ページ4に含まれる内容の要旨
5.6.4 Delete all redial numbers 23 7.2 Register 29 5.7 Using the Call log 23 7.3 Unregister 30 5.7.1 Access the Call log 23 7.4 Select Country 30 5.7.2 Save call list entry into the 7.5 Reset Unit 30 phonebook 23 7.6 Set Prefix 31 5.7.3 Delete a call list entry 24 7.7 Change Recall time 31 5.7.4 Delete all call list entries 24 7.8 Change the Dial Mode 32 5.8 Using the Intercom 24 7.9 Set First Ring Detection 32 5.8.1 Intercom another handset 24 7.10 Default settings 32 5.8.2 Transfer an external
ページ5に含まれる内容の要旨
a very high level: make sure the 1Important handset is not too close to your ear. � This equipment is not designed to make emergency calls when the Take time to read this user manual power fails. An alternative has to be before you use your phone. It contains made available to allow emergency important information and notes calls. regarding your phone. � Do not expose the phone to excessive heat caused by heating equipment or direct sunlight. 1.1 Power requirements � Do not drop your phon
ページ6に含まれる内容の要旨
� Power supply information for charger standard irrespective of their make. Your (multihandset pack only) handset and base station are GAP Input: AC100-240V/0.3A, 50Hz/60Hz compliant, which means the minimum Output: DC6V/0.21A guaranteed functions are: register a JOD-SWR-07343 handset, take the line, receive a call and JODEN dial. The advanced features may not be � Risk of explosion if battery is replaced available if you use a handset other than by an incorrect type. the handset of one o
ページ7に含まれる内容の要旨
Do not dispose of your old product in 1.5 Electric, Magnetic and your general household waste bin. Electromagnetic Fields (“EMF”) Inform yourself about the local 1. Philips Royal Electronics separate collection system for manufactures and sells many electrical and electronic consumer oriented products which products marked by this usually, as with any electronic symbol: apparatus, have the ability to emit and receive electro magnetic signals. Use one of the following disposal options: 2.
ページ8に含まれる内容の要旨
2 Your phone Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. 2.1 What’s in the box Handset Base Station Battery door 2 AAA rechargeable Power supply Line cord* batteries User manual Guarantee Quick Start Guide Note * You may find in the box the line adaptor delivered separately from the line cord. In this case, you have to connect the line adaptor to the line cord first before plu
ページ9に含まれる内容の要旨
2.2 Overview of your phone confirm entries (for example when setting date and time). DBack/Clear key c Press to clear (delete) a character or A number when making an entry. Long press to clear all. When navigating menus, press to move to the previous menu level (BACK is displayed). B When is displayed, press to see characters/numbers to the right of those shown. C E Navigation keys n D In idle mode: Scroll up to access the Call E log and scroll down to access the F G Phonebook. During
ページ10に含まれる内容の要旨
In other modes: Long press to return to idle mode. Short press to move to the previous menu level. H Menu key m Q In idle mode: Go to the main menu. I Redial key r Access the Redial list in idle mode. When making a call, press to redial the last number dialed. H I J J Loudspeaker key l In idle mode: Turn on the loudspeaker K R and dial the number. Answer an incoming L call using handsfree mode. M N During a call: Toggle the loudspeaker on/ O P off. K Number keys During a call: Short press t
ページ11に含まれる内容の要旨
2.3 Display icons Indicates that the battery is fully Indicates that the handset is charged. This icon blinks during registered and within range of charge and when the battery is the base station. Icon blinks low. when the handset is out of When the Icon is empty the range or is searching for a base. battery is practically discharged. Appears to request Note confirmation of an operation. Press the key directly below to If WARNING BATT appears confirm. together with a blinking b
ページ12に含まれる内容の要旨
2.4 Overview of the base station A APaging key a Page handset. Long press to start registration procedure. Your phone 10
ページ13に含まれる内容の要旨
Note 3 Getting started The line adaptor may not be attached to the line cord. In this case, you have to connect the line adaptor to the line cord 3.1 Connect the base station first before plugging the line cord to the 1 Place the base station in a central line socket. location near the telephone line Warning socket and electricity socket. Avoid placing the base station too close 2 Connect the line cord and the to large metal objects such as filing power cable to their corresponding cabinet
ページ14に含まれる内容の要旨
bracket and ➁ rotating the bracket 6 Slide the base down into place. outward. 5.20 83.00 17.00 5.20 2 Turn the bracket around. 3.3 Install your phone Before using the handset, the batteries 3 Attach the bracket to the opposite have to be installed and fully charged. side of the base station. Warning When the batteries are inserted for the first time, the unit will not be able to start normally due to the low battery. You must charge the batteries on the base station before you can use the
ページ15に含まれる内容の要旨
3 The battery icon becomes steady when the handset is fully charged. Note Optimal battery life is reached after 3 2 Place the batteries in the correct cycles of complete charging (over 15 polarity as indicated and replace the hours) and discharging, allowing cover. approximately 12 hours of talk-time and 150 hours of stand-by time. The indoor and outdoor range of the phone is up to 50 metres and 300 metres respectively. When the handset moves beyond the operation range, the antenna ic
ページ16に含まれる内容の要旨
3 Press o to confirm your 2 Install the batteries supplied into the selection. handsets. (WAITING will be displayed while 3 Place the handsets on the chargers the default line settings and menu to charge the batteries. language for the selected country are automatically configured.) 4 The product now goes to the DATE/TIME selection menu. Enter the current date (DD/MM) and press o to confirm. 5 Enter the time (HH-MM) and press o to confirm. (The time format, 12 hour or 24 hour, depends on
ページ17に含まれる内容の要旨
3.6 Menu structure The chart below shows the menu tree of your phone. Press the menu key m to enter each option. Press c to go to the previous level in a menu. Use navigation keys n to navigate within the menus. Menus PHONEBOOK NEW ENTRY ENTER NAME ENTER NUMBER LIST Entry list displayed EDIT ENTRY DELETE DELETE ALL DIRECT MEM. KEY 1 EDIT DELETE KEY 2 EDIT DELETE PERSONAL SET HANDSET NAME Enter name: HANDSET TONE RING VOLUME RINGER OFF LEV
ページ18に含まれる内容の要旨
CLOCK&ALARM DATE/TIME Enter date Enter time SET FORMAT TIME FORMAT 12 HOURS 24 HOURS DATE FORMAT DD/MM MM/DD ALARM OFF ON ONCE ON DAILY ALARM TONE MELODY 1 MELODY 2 MELODY 3 ADVANCED SET CHANGE PIN REGISTER UNREGISTER SEL. COUNTRY List of countries RESET AUTO PREFIX DETECT DIGIT PREFIX RECALL TIME SHORT LONG DIAL MODE TONE PULSE FIRST RING ON OFF Getting started 16
ページ19に含まれる内容の要旨
the caller’s number or name in the call 4 Using your phone log. (See “Access the Call log” on page 23.) 1 Press u in idle mode. 2 Scroll n to an entry in the call list. 4.1 Make a call 3 Press t. � The call is initiated. 4.1.1 Predialling 1 Dial the number (maximum 24 digits). 4.1.5 Call from the phonebook 2 Press t. 1 Press d in idle mode. � The call is initiated. 2 Scroll n to a phonebook entry. Tip 3 Press t. You may insert a prefix number to the � The call is initiated. beginning of your
ページ20に含まれる内容の要旨
4.1.7 Call using Direct Access very high level. Make sure the handset is Memory not too close to your ear. In idle mode, long press 1 or 2 to When the phone rings, press l. dial a stored direct access memory � The handset loudspeaker is activated. number. Note See section 5.5.6 for instructions on how 4.2.2 Call waiting to store, edit, and delete direct access If you have subscribed to Call Waiting memory numbers. services, the earpiece will emit a beep tone to inform you that there is a seco
