ページ2に含まれる内容の要旨
Safety Information 650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page 2 General Safety Battery Caution Only use the power supply included Use only specified batteries. with the product. Only use rechargeable batteries. Do not connect the AC Adaptor to any Do not mix old and new batteries. AC outlet other than the standard AC220-240V. Do not dispose of batteries in a fire, The apparatus is approved for use they may explode. Check local waste management codes for special with PQLV19E power s
ページ3に含まれる内容の要旨
LINE 6v 650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page 3 Setting Up Location Insert the Batteries For maximum distance noise-free operation, place your base unit: -Away from electrical appliances such as TV, radio, personal computer or another phone. -In a convenient high and central location. Wall Mounting Please ensure the batteries are This unit can be mounted on a wall. inserted as shown. Insert screws into wall. The centres Connection of the screw holes should be 6cm Plug in the AC
ページ4に含まれる内容の要旨
Using the Telephone 650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page 4 Battery Charging Replacing the batteries Û Û If the icon flashes after a few (Before Initial Use) telephone calls even when the ! The batteries must be charged handset batteries have been fully for approximately 15 hours charged, the batteries must be before initial use. replaced. After the batteries have been ! Charge new batteries for inserted into the handset, place the approximately 15 hours before handset in the po
ページ5に含まれる内容の要旨
650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page 5 Making Calls Making a Call from the Z Z‰ ‰. Redial List Dial the number. The last 10 numbers dialled are After a few seconds, the call duration stored. is displayed. The dialled number is From the standby mode Z ZX X. stored in the redial memory. Z ZS S U U or to select number. When you are finished with the (To exit the redial list, Z Z± ±). call, Z Z±. Z Z‰ ‰. Alternatively, dial the number, then Z‰. This procedure Caller ID Service allo
ページ6に含まれる内容の要旨
Using the telephone 650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page 6 To add digits Z ZK K-I I. Making a Call from the To clear digits Z ZW W.. Caller ID List (cont.) Either Z Z‰ ‰ to dial or to save After you have viewed a phone Z ZY Y the number, . number, answered the call or called ssaavvee ssppeeeedd is displayed. back the caller, “⁄” is added to the Z ZY Y. caller’s number. Z ZY Y to save. After viewing all new Caller ID numbers, the call counter is reset to zero. clear To exit the
ページ7に含まれる内容の要旨
650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page 7 Speed Dialling Z ZV V. You can store up to 20 telephone numbers in the handset. eeddiitt is displayed. Z ZS S or U U to select a menu item Storing New Numbers then follow the instructions that From the standby mode Z ZY Y. follow: new speed is displayed. Z ZV V. edit Á and an index number 00 - 19 is displayed. (Edit the Speed Dial *Enter a phone number (max 24 Number): digits). Z ZV V. Z ZY Y. Z ZT T or V V to move the edit saved is displa
ページ8に含まれる内容の要旨
Using the Telephone 650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page 8 Hot Key Dialling a Hot Key Number You can assign the dialling buttons A A - I I as hot keys. You can choose 9 phone numbers from the speed dial list (See “Register a Speed Dial Number as a Hot Key”). Z Z A A I I and hold a key - . The number stored with that key is displayed. ZS or U to view other numbers stored. Z Z‰ to dial. Clearing Caller Information from a Hot Key Z Z and hold a key A A - I I. The number stored wit
ページ9に含まれる内容の要旨
650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page 9 Key Lock Dialling Pause ! This function is for PBX You can lock the handset dialling line/long distance service users. buttons. Only incoming calls are accepted while the key lock is ON. A dialling pause is used when a Turn Key Lock ON pause in the dialling of the phone Z Z and hold Y Y until a beep sounds. number is necessary using a PBX or ‘Ó’ is displayed and all dialling accessing a long distance service. buttons are locked. (see “Sele
ページ10に含まれる内容の要旨
Handset Settings 650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page 10 Handset Settings You can change the handset settings using a handset near the base unit. Before proceeding with any of the main menu items listed in this chap- ter, the following procedure must initially be carried out: Z ZV V 1 From the Standby mode, . 2 Z ZS S or U U to select sseettttiinngg hhss (Setting Handset). 3 Z ZV V. 4 Z ZS S or U U to select main menu items from below (see menus in shaded text boxes): To exit
ページ11に含まれる内容の要旨
650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page 11 Before programming, please follow steps 1 to 4 of ‘Handset Settings’. ! Time will only be displayed if tone opt the clock has been set (see (Tone Settings): “Base Unit Settings”). ZV. talk mode ZS or U. (Select Talk Mode key tone Display): (Set Key Confirmation Z ZV V. Tone ON/OFF)* Z ZS S or U U to select from ttaallkk To program see * below. ttiimmee (Length of Call) or pphhoonnee call waiting nnoo (Phone Number). Z ZV V. (Set Call Wai
ページ12に含まれる内容の要旨
Handset Settings 650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page 12 Before programming, please follow steps 1 to 4 of ‘Handset Settings’. battery type set direct (Set Battery Type Ni-MH / (Set Direct Call ON/OFF): Ni-Cd): Z ZV V. Select the type of battery installed. If Z ZS S or U U to select oonn (On) or the battery type selected is not the ooffff (Off). same as the type of battery installed, Z ZV V. the battery level icons will not be cor- If ON is selected, Ë is displayed. rect. Z ZV
ページ13に含まれる内容の要旨
650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page 13 Base Unit Settings You can change the base unit settings using a handset near the base unit. Before proceeding with any of the base settings listed in this chapter, the following procedure must initially be carried out: 1 From the standby mode, Z ZV V. 2 Z ZS S or U U to select sseettttiinngg bbss (Setting Base). 3 Z ZV V. iinnppuutt ccooddee is displayed. From this display, follow the instructions after each heading. Please note: Where
ページ14に含まれる内容の要旨
Base Unit Settings 650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page 14 Before programming, please follow steps 1 to 3 of ‘Base Unit Settings’. Select Pause Timing Set Call Restriction You can set the pause timing to 3 or You can restrict selected handset(s) 5 seconds, depending on your PBX from dialling selected phone requirements (see “Dialling Pause”). numbers. You can assign up to 6 call restriction numbers (up to 8 digits). Z ZC C. Z ZF F. Enter PIN. Enter PIN. Z ZC C. All registered h
ページ15に含まれる内容の要旨
650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page a A basic guide to operations & features. Pull out centre pages for quick reference Quick Guide & Useful Information Batteries Insert the Batteries Important! Charge the batteries for approx. 15 hours before initial use. Batteries reach peak performance after several full charge/discharge cycles. For further information on Please ensure the batteries are batteries, please refer to main inserted as shown. Operating Instructions. Network Depe
ページ16に含まれる内容の要旨
650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page b Location of Controls Handset controls # # - Receiver $ - Function/OK Button % - Talk Off/Power Button & - Cancel Button ) ' - Intercom Button ( - Charge Contact * ) - Display $ * - Speed Dial Button + % + - Talk Button , , - Navigator Key - & - - Redial/Pause Button . - Recall Button / - Charge Contact 0 - Microphone . ' Base unit controls / ( 0 - Page button Handset Display Icon Displays Flashes Î Within range of a base unit Out of range
ページ17に含まれる内容の要旨
650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page c Quick Guide Function Action Switch handset on / off Z± until a confirmation tone sounds. Answer a call Z‰. Make a call Dial the number and Z‰. Hang up Z±. Turn Key Lock on/off ZY and hold for more than 2 seconds. Redial last number Z‰, ZX. Store a number ZY. ZV enter number, ZY. Dial a stored number ZÁ. ZS/U to select a number, Z‰. Dial from the Redial List ZX. ZS/U to select a number, Z‰. Adjust Receiver volume ZS/U during a call. Call an
ページ18に含まれる内容の要旨
650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page d Y Yo ou ur r G Gu uiid de e t to o t th he e D Diis sp plla ay y Note: The LCD display of the handset can display up to 7 segments and each character will be displayed as shown in the following table. Some characters will be displayed in a different way; for example, the character M is displayed n.This is not a defect of the handset display, it is simply the representation of the characters used in this kind of display. The LCD descrip
ページ19に含まれる内容の要旨
650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page 15 Before programming, please follow steps 1 to 3 of ‘Base Unit Settings’. Cancel Call Restricted Numbers Z ZF F. Enter PIN. Z ZV V . Z ZW W to cancel number. Z ZY Y. Set the Clock Z ZJ J. Enter a new time (4 digits) (24 hour time) (Z ZK K - I I). Z ZY Y . ! After a mains power failure the clock needs to be reset. Reset the Base Unit You can reset all of the base unit settings to their initial factory settings. (see “Base Unit Initial Setti
ページ20に含まれる内容の要旨
Initial Settings 650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page 16 Handset Initial Settings To reset handset to initial settings refer to “Handset Settings”. Function Initial Setting Time Alarm Mode OFF Alarm Time Clear Handset Ringer Volume 3 Handset External Ringer Pattern 1 Handset Internal Ringer Pattern 1 Handset Paging Tone Pattern 1 Handset Alarm Tone Pattern 1 Key Tone ON Call Waiting Tone ON Range Warning Alarm OFF Battery Low Alarm ON Standby Mode Display Base Unit Number Talk
ページ1に含まれる内容の要旨
650e eng Baseline TXT 23 4 02 23/4/02 12:25 pm Page 1
Model No:
KX-TCD650E
Digital Cordless Phone
Operating Instructions
& Quick Guide
Centre Page Pullout
Safety Information . . . . . . . . . . . .2
Accessories . . . . . . . . . . . . . . . . .2
Setting Up . . . . . . . . . . . . . . . . . .3
Using the Telephone . . . . . . . . . .4
Additional Features . . . . . . . . . . .9
Handset Settings . . . . . . . . . . . .10
Base Unit Settings . . . . . . . . . . .13
Initial Settings . . . . . . . .