ページ1に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 1
E
2.4 GHz Cordless Telephone
N
G
with Caller ID
L
® ™
I
Featuring Clarity Power Technology
S
H
Clarity 440 User Guide
E
S
P
A
Ñ
O
L
F
R
A
N
Ç
A
I
S
ページ2に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 2 Table of Contents Safety Instructions . . . . . . . . . . . . . . . . 3 Telephone Operations . . . . . . . . . . . . . 16 Placing a Call . . . . . . . . . . . . . . . . . 16 Features . . . . . . . . . . . . . . . . . . . . . . . 5 Answering a Call . . . . . . . . . . . . . . . 16 Getting Started . . . . . . . . . . . . . . . . . . 8 Temporary Tone . . . . . . . . . . . . . . . . 16 Choosing a Location . . . . . . . . . . . . . 8 Lighted
ページ3に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 3 Important Safety Instructions E When using your telephone equipment, basic the owner’s manual. If you are not sure N safety precautions should always be followed of the voltage in your home, consult your G to reduce the risk of fire, electric shock and dealer or local power company. L injury to persons including the following: 10.Do not place anything on the power I 1. Read and understand all instructions. cord. Install the telephone whe
ページ4に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 4 Important Safety Instructions normally by following the operating 16.Never install telephone jacks in wet instructions. Adjust only those controls locations unless the jack is specifically that are covered by the operating designed for wet locations. instructions. Improper adjustment may 17.Never touch uninsulated telephone require extensive work by a qualified wires or terminals unless the telephone technician to restore the telephone
ページ5に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 5 Features E N Handset G 11. Handset Ringer Off/On 1. 2.5 mm Headset Jack L 12. Neckloop Jack 2. Key Pad I 13. Boost Button (BOOST) 3. Handset Charging Contacts S 14. Volume Control 4. DEL/Channel Button (DEL/CH) H 15. Program Button (PROG) 5. Talk Button (TALK) 6. Mode Button (Mode) 16. Enter Button (ENTER) 7. Flash Button (FLASH) 17. Antenna/Visual Ringer 8. Mute Button (MUTE) 9. Redial/Pause Button (RD/P) 10. Temporary Tone Button (*) 17
ページ6に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 6 Features Telephone Base 1. Charging Contacts 4. In Use LED 2. Base Antenna/Visual Ringer 5. Charge LED 3. Power LED 6. Page Button (PAGE) 2 3 4 5 6 1 6
ページ7に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 7 Features E N Base Side/End/Bottom G 1. Ringer Off/On 5. BOOST On/Off L 2. Ring Style 6. AC (Electrical) Adapter Jack 3. Volume Up/Down 7. Telephone Line Jack I 4. Pulse/Tone S H 1 2 3 6 7 4 5 7
ページ8に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 8 Getting Started If at any time you have questions about your CHOOSING A LOCATION telephone please contact our Customer 1. This phone requires a modular phone Service Department at: 1-800-552-3368 or jack (RJ11C) and a standard 120V AC 423-622-7793. wall outlet. 2. Plug the AC Adapter directly into outlet. 3. Do not plug other appliances into the same outlet or have outlet controlled by a wall switch. 4. Choose a location that is out of
ページ9に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 9 Getting Started E 6. Set the TONE/PULSE switch located 5. Plug the short modular telephone line N on the back of the base to correct cord into the wall plate jack, then align G dialing mode. Please check with your the mounting bracket’s keyhole slots with L local Phone Company if uncertain of the wall plate studs and slide the base I the type of service. of the phone downward to secure it on the wall. S 7. Place handset in the cradle t
ページ10に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 10 Getting Started Handset Battery Charging BATTERY INSTALLATION 1. Place the handset in the base. The The C440 uses a 3.6Volt 600mAHr NiMH CHARGE LED on the base will light RED. rechargeable 3 cell (AAA Type) battery that is included with your unit. 2. After the batteries are fully charged, check for dial tone by pressing TALK Handset Battery Must be Connected Before on the handset. Beginning Initial Charging Low Battery When the handset
ページ11に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 11 Getting Started E Headset Jack N You can use this telephone hands-free when G you install a 2.5 mm headset (purchased L separately). To install, plug the headset into I the HEADSET JACK at the top of the handset. S While in headset mode, the volume of H headset is controlled by the telephone and the handset’s earpiece and microphone are disconnected. Ordering a Headset: In the event you wish to purchase a headset for your C440, ple
ページ12に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 12 Feature Set-up Setting Contrast CALLER ID DISPLAY There are 3 contrast levels and the default is Set-up Mode set to level 2. C440 handset goes into setup mode automat- ▲ 1. After setting the language, press UP( ) ic when battery is connected. key to begin setting contrast. Or press and hold MODE button for 3 sec- 2. The LCD display will show LCD onds to enter setup mode. If there is no input CONTRAST and 1 2 3. within 30 seconds, the l
ページ13に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 13 Feature Set-up E Setting LDS CODE Setting MESSAGE WAITING ON/OFF N ▲ ▲ 1. After setting Area Code 2, press UP( ) 1. After setting Voicemail No, press UP ( ) G button to set LDS Code. button to set Message Waiting function L on/off. 2. The LCD display will show LDS CODE I and X with X digit blinking. 2. The LCD display will show MESSAGE, S WAITING, and 1.ON 2.OFF with a 3. Enter the LDS number using the numeric H tick mark against the s
ページ14に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 14 Feature Set-up Clarity Power Technology TELEPHONE BASE With the Clarity Power feature, the high fre- Ringer Volume quency sounds are amplified more than the The base ringer volume adjustments are locat- low frequency sounds so words are not just ed on the side of the telephone base. louder, but clearer and easier to understand. BOOST Clarity Power On/Off The C440 has a button that controls the loud- ness of the receiver. Once the BOOST
ページ15に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 15 Feature Set-up E Visual Ringers Pulse/Tone N Visual ringers are located in both the hand- Slide the switch to the type of telephone G set antenna and the base of the telephone. service you have; tone for touch-tone service L When an incoming call is received, these or pulse for rotary dialing. Please check with I lights will flash. The handset visual ringer your local telephone company if uncertain S will also stay lit while the phone is
ページ16に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 16 Telephone Operations Placing a Call Last Number Redial: 1. Press the TALK button (TALK button The last number dialed (up to 32 digits) is will illuminate GREEN) and dial the stored in the redial memory until another number you wish to call. number is dialed. 2. To end the call press the TALK button To use this feature: or place the handset in the base. 1. Press the TALK button. Or 2. When you hear the dial tone, 1. Press the keys of the
ページ17に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 17 Telephone Operations E Security Code N 2. Press the key. Keys pressed after * this are sent as tone signals. The security code prevents your cordless G phone conversations from being accessed L 3. The phone will automatically reset by a phone on a different line. Once the to rotary (pulse) service after the I handset battery is fully charged, the handset call ends. S will automatically select the code from over H 65,000 different comb
ページ18に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 18 Memory Storage 5. If memory is available, the display will MEMORY OPERATIONS show SAVE NEW NUM and then Review Memory Information ENTER NUMBER. 1. Unit must be in standby mode only. 6. After pressing any number key, the second line will change to ENTER TO 2. Press MODE key twice. The LCD will END and the third line shows the number(s) show PHONEBOOK. pressed. Enter phone number up to 23 3. If the phonebook is empty, after 1 second
ページ19に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 19 Memory Storage E Deleting a Stored Number 1. Unit must be in standby mode only. N 1. Unit must be in standby mode and G 2. Press MODE key twice. The display will display is showing a phonebook record. show PHONEBOOK for 1 second and L then display the first available record. 2. Press DEL/CH key once. The LCD will I show DELETE? ▲ 3. Press the UP( ) or DOWN (▼) button S to go to the record to be changed, 3. Press DEL/CH to confirm. H e.
ページ20に含まれる内容の要旨
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 20 Memory Storage characters and numbers will replace the Dialing the EMERGENCY Number original phone record. 1. Unit must be in standby mode only. 11.The display will show NUMBER STORED. 2. Press the EMERGENCY key once. 3. The display will show the stored name Adding the EMERGENCY Number and number for 5 seconds. Otherwise 1. Unit must be in standby mode only. it will show -NO RECORDS-. 2. Press MODE key twice. The display will 4. Then th
