ページ1に含まれる内容の要旨
USER’S MANUAL
Part 2
1
900 MHz Cordless
Telephone HS-8210
Fold open this manual for information about this
telephone’s installation and operation. Please
also read Part 1 — Important Product Information.
AT&T and the globe symbol are registered trademarks of AT&T Corp. licensed to Advanced American Telephones.
© 2000 Advanced American Telephones. All rights reserved.
Printed in Mexico. 850002221 Issue 1AT&T 5/00
ページ2に含まれる内容の要旨
INSTALLATION Table/Desk Installation Wall Installation Standard Modular electrical telephone Modular outlet jack telephone Short jack telephone line cord Standard electrical outlet Strain-relief groove Power cord Long telephone line cord Power cord The instructions below are for both table and wall base. Slide the base down onto the knobs until it locks installation. into place. 6 Charge the handset battery. 1 Choose a spot near an electrical outlet and a Place the handset face up or face down i
ページ3に含まれる内容の要旨
IN CASE OF DIFFICULTY If you have difficulty operating this phone, try the suggestions If the phone does not ring when you receive below. If you still have trouble, call 1 800 222–3111. a call: • Make sure the handset ringer is on. (Press to If the phone doesn’t work at all, check these turn ringer on.) items first: • Make sure the telephone line cord is connected firmly • Make sure the AC adapter is plugged into an outlet not to the base and the telephone jack. controlled by a wall switch. •
ページ4に含まれる内容の要旨
OPERATING RANGE This cordless telephone operates within the maximum If you move out of range during a phone conversation, power allowed by the Federal Communications Commission you might hear noise or interference. To improve reception, (FCC). Even so, this handset and base can communicate move closer to the base. over only a certain distance — which can vary with the If you move out of range without pressingP, your locations of the base and handset, the weather, and the phone will be left “off
ページ5に含まれる内容の要旨
TELEPHONE OPERATION Allows you to Headset jack hear caller, but caller can’t hear you Make, answer or end a call Access subscriber services Access numbers in telephone memory Redial last number called Light goes on when handset is in use Light goes on when handset is charging Temporary Tone in base Store numbers in Turn Handset Send paging tone to Ringer off telephone memory handset Change channels Adjust handset volume Turn Handset Ringer on Making a Call Redial The last number dialed on this
ページ6に含まれる内容の要旨
TELEPHONE OPERATION Handset Ringer Selection Page You can select from four different handset ringer styles. The Page feature allows you to signal someone at the You can also turn the Ringer off. handset from the base. • Make sure the HANDSET IN USE light is not lit on the 1 Make sure the PHONE light is off. base. 2 Press G, . • Press G on the base. A three-part paging 3 Press 1,2,3 or 4 to select your ringer style. You will tone will sound at the handset. hear a sample of the ringer style. 4 Pre
ページ7に含まれる内容の要旨
TELEPHONE MEMORY This cordless phone can store 10 telephone numbers that Storing a Pause in a Memory Number you can dial just by pressing m and a number button. While storing a number in memory, hold down the button of the number that comes before the pause until you hear a second beep. This inserts a two-second pause after that Storing Memory Numbers digit. To insert a longer pause, hold the button down until 1 Make sure the PHONE light is off. you hear a third or fourth beep. Each time you hea
ページ8に含まれる内容の要旨
BATTERIES Nickel Cadmium Rechargeable Batteries Charging the Handset Battery Pack must be recycled or disposed of properly. This battery should remain charged up to 15 days with the Do not dispose of in household garbage. If Ringer turned on and up to 30 days with the Ringer off. A burned, it could explode. If punctured, it fully charged battery provides an average talk time of about could release caustic material which could 10 hours. injure the skin or eyes. If swallowed, it may The battery p
