ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page III Visit us at www.telephones.att.com © 2003 Advanced American Telephones. All Rights Reserved. AT&T and the Globe Design are trademarks of AT&T Corp., licensed to Advanced American Telephones. Printed in China. Issue 1AT&T 05/03
ページ3に含まれる内容の要旨
ページ4に含まれる内容の要旨
ページ5に含まれる内容の要旨
91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page 1 About Caller Identification (Caller ID) This product has a Caller ID with Call Waiting feature that works with service from your local phone service provider. Caller ID with Call Waiting lets you see who’s calling before you answer the phone, even when you’re on another call. You may need to change your phone service to use this feature. Contact your phone service provider if: •You have both Caller ID and Call Waiting, but as separate ser
ページ6に含まれる内容の要旨
91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page 2 INSTALLATION Table/Desktop Installation NOTE: Install this telephone away from electronic equipment, such as personal computers, television sets or microwave ovens. Avoid excessive heat, cold, dust or moisture. 1 Connect the telephone line cord. 2 Connect the power cord. The ON/OFF light goes on, and CL flashes in the Message Window. Standard Modular electrical telephone outlet jack Use only the power cord supplied with this product. I
ページ7に含まれる内容の要旨
91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page 3 3Install the handset battery. Use only AT&T Battery 2401, SKU# 91077. a) Remove battery b) Align the contacts and place compartment cover by the battery pack in the pressing on the raised spot battery compartment. and sliding downward. c) Replace cover by sliding it on its track up over battery case until it snaps firmly into place. 4 Charge the handset battery. •Place the handset in the base. • Charge the battery at least 12 hours. After
ページ8に含まれる内容の要旨
91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page 4 About Handset Registration 1 The cordless handset that came with your system is automatically registered as Handset 1.There is no need to re-register. 2 You may register up to a total of six Expansion Handsets to this telepnone system.(Model 5800 handset sold separately). 3 Additional handsets will be assigned Handset 2, Handset 3, Handset 4, Handset 5, and Handset 6. 4 When you install the handset battery pack, the handset will disp
ページ9に含まれる内容の要旨
ページ10に含まれる内容の要旨
91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page 6 Spare Battery/Power Failure Backup You can buy a spare handset battery (AT&T Battery 2401, SKU# 91077, sold separately) and keep it charged in the base at all times. In the event of a power failure, a fully charged battery in the spare battery compartment will allow you to make and receive calls from the cordless 1 handset only for up to 2 / hours. 2 The spare battery will fully charge in 24 hours. 7 INSTALLATION INSTALLATION
ページ11に含まれる内容の要旨
ページ12に含まれる内容の要旨
ページ13に含まれる内容の要旨
91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page 9 Clock Mode You can choose to display the time when the phone is idle, or you can turn this feature off. The default setting is ON. 1Press MENU . 2Press until the screen highlights VOICE ANNOUNCE HANDSET SETTINGS SET TIME CLOCK MODE CLOCK MODE ▲ ▼ OK OK 3Press . The screen displays CLOCK ENABLE ON OFF OK ON OFF ON 4Press or . OK 5Press to save the displayed setting. 10 FEA FEA TURE SETUP – HANDSET TURE SETUP – HANDSET
ページ14に含まれる内容の要旨
91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page 10 Sound Select This telephone uses the latest acoustic receiver design, providing you with four different sound quality settings. During a call, you can adjust the quality of the sound. Pressing repeatedly will cycle you through four different responses. NOTE: The mid-boost setting is hearing-aid compatible. BASS – Low frequency sounds enhanced. MID – Mid-range sounds enhanced. TREBLE – High frequency sounds enhanced. NATURAL – No fre
ページ15に含まれる内容の要旨
ページ16に含まれる内容の要旨
ページ17に含まれる内容の要旨
91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page 13 Vibrate Control When this feature is on, the handset vibrates when you have an incoming call. The default setting is OFF. 1Press MENU , then until the screen highlightsHANDSET SETTINGS. OK 2Press , then until the screen highlights VIBRATE CONTROL. OK 3Press . The screen displays VIBRATE OFF OFF OK ON OFF ON 4Press or . OK 5Press to save the displayed setting. NOTE: Vibrate and Ringer Volume settings are independent. Adjusting Vi
ページ18に含まれる内容の要旨
ページ19に含まれる内容の要旨
91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page 15 Range T one You can set the handset to sound a tone when you are approaching the range limit, or you can turn this tone off. The default setting isON. 1Press MENU , then until the screen highlightsHANDSET SETTINGS. OK 2Press , then until the screen highlightsRANGE TONE. OK 3Press The screen displays . RANGE TONE ON OFF OK ON OFF ON 4Press or . OK 5Press to save the displayed setting. 16 FEATURE SETUP – HANDSET FEATURE SETUP – HAN
ページ20に含まれる内容の要旨
91-5431-10-00_ATT5870_R0JUN040 2/5/03 4:03 PM Page 16 Keypad T one When this feature is on, each key press makes a sound. The default setting is ON. 1Press MENU , then until the screen highlights handset settings. OK 2Press , then until the screen highlights keypad tone. OK 3Press The screen displays . KEYPAD TONE ON OFF OK ON OFF ON 4Press or . OK 5Press to save the displayed setting. 17 FEA FEA TURE SETUP – HANDSET TURE SETUP – HANDSET
