ページ1に含まれる内容の要旨
TSU 600
&
TSU 600e
User Manual
Part Numbers
1202076L1
1202076L1#DC
1202076L2
1202076L2#DC
October 1998
61202076L1-1C
ページ2に含まれる内容の要旨
Trademarks: Windows is a registered trademark of Microsoft Corp. T-Watch is a trademark of ADTRAN, Inc. SLC96 is a registered trademark of AT&T 901 Explorer Boulevard P.O. Box 140000 Huntsville, AL 35814-4000 Phone: (256) 963-8000 © 1998 ADTRAN, Inc. All rights reserved. Printed in USA.
ページ3に含まれる内容の要旨
YEAR 2000 Compliance All ADTRAN transmission hardware and software products have been tested and found to be fully compliant with the YEAR 2000 requirements. This is true for all models and revisions regardless of the date of manufacture or delivery. Users who wish to independently verify that specific products are in compli- ance may contact ADTRAN Technical Support at 1-888-423-8726 for additional information
ページ4に含まれる内容の要旨
FCC REGULATIONS REQUIRE THAT THE FOLLOWING INFORMATION BE PROVIDED TO THE CUSTOMER IN THIS MANUAL 1. This equipment complies with Part 68 of the FCC rules. The required label is attached to the bottom of the chassis. 2. An FCC compliant telephone cord and modular plug is provided with this equipment. This equipment is designed to be connected to the telephone network or premises wiring using a compatible modu- lar jack which is Part 68 compliant. See installation instructions for details
ページ5に含まれる内容の要旨
FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These lim- its are designed to provide reasonable protection against harmful inter- ference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
ページ6に含まれる内容の要旨
CANADIAN EMISSIONS REQUIREMENTS This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled “Digital Apparatus,” ICES-003 of the De- partment of Communications. Cet appareil nuerique respecte les limites de bruits radioelectriques ap- plicables aux appareils numeriques de Class A prescrites dans la norme sur le materiel brouilleur: “Appareils Numeriques,” NMB-003 edictee par le m
ページ7に含まれる内容の要旨
CANADIAN EQUIPMENT LIMITATIONS The Industry Canada Certification label identifies certified equipment. This certification means that the equipment meets certain telecommu- nications network protective, operational, and safety requirements. The Department does not guarantee the equipment will operate to the user's satisfaction. Before installing this equipment, users should ensure that it is permissi- ble to be connected to the facilities of the local telecommunications com- pany. The equip
ページ8に含まれる内容の要旨
AFFIDAVIT REQUIREMENTS FOR CONNECTION TO DIGITAL SERVICES • An affidavit is required to be given to the telephone company when- ever digital terminal equipment without encoded analog content and billing protection is used to transmit digital signals containing encod- ed analog content which are intended for eventual conversion into voiceband analog signals and transmitted on the network. • The affidavit shall affirm that either no encoded analog content or billing information is being transm
ページ9に含まれる内容の要旨
AFFIDAVIT FOR CONNECTION OF CUSTOMER PREMISES EQUIPMENT TO 1.544 MBPS AND/OR SUBRATE DIGITAL SERVICES For the work to be performed in the certified territory of ______________________________(telco name) State of _________________________________ County of ________________________________ I, ___________________________________ (name), (business address), ______________________ (telephone number) being duly sworn, state: I have responsibility for the operation and maintenance of the termina
ページ10に含まれる内容の要旨
( ) B. A training course provided by the customer or authorized repre- sentative, using training materials and instructions provided by the manufacturer/grantee of the equipment used to encode analog signals; or ( ) C. An independent training course (e.g., trade school or technical institution) recognized by the manufacturer/grantee of the equipment used to encode analog signals; or ( ) D. In lieu of the preceding training requirements, the operator(s)/ maintainer(s) is (are) under
ページ11に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS When using your telephone equipment, please follow these basic safety precautions to reduce the risk of fire, electrical shock, or personal injury: 1 Do not use this product near water, such as near a bath tub, wash bowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool. 2 Avoid using a telephone (other than a cordless-type) dur- ing an electrical storm. There is a remote risk of shock from lightning. 3 Do not use the telephone to report a g
ページ12に含まれる内容の要旨
Warranty and Customer Service ADTRAN will replace or repair this product within five years from the date of shipment if the product does not meet its published specifica- tions or if it fails while in service. For detailed warranty, repair, and re- turn information refer to the ADTRAN Equipment Warranty and Repair and Return Policy Procedure. Return Material Authorization (RMA) is required prior to returning equipment to ADTRAN. For Service, RMA requests, or more information, contact ADTRA
ページ13に含まれる内容の要旨
Table of Contents Chapter 1 Introduction .......................................................................................... 1-1 TSU 600 Overview .................................................................................................... 1-1 Product Description .......................................................................................... 1-1 Standard Features in the TSU 600................................................................... 1-2 TSU Option Modules....
ページ14に含まれる内容の要旨
Table of Contents Set User Passcode .....................................................................................2-12 Set Unit Identification ..............................................................................2-12 Set Control Port ........................................................................................2-13 Chain-In (PC) ............................................................................................2-13 Chain In/Chain Out ...........................
ページ15に含まれる内容の要旨
Table of Contents Internal Timing ........................................................................................... 5-6 Secondary Timing ...................................................................................... 5-7 Normal (CSU) Timing ............................................................................... 5-8 Unit Menu .......................................................................................................... 5-9 Map Exchange (Map Xchng) Menu.......
ページ16に含まれる内容の要旨
Table of Contents Initializing the Temp Map ................................................................. 8-3 Editing the Temp Map ....................................................................... 8-4 Applying the Temp Map ................................................................... 8-4 Reviewing Maps.................................................................................. 8-4 Remote Menu Access ...........................................................................
ページ17に含まれる内容の要旨
List of Figures Figure 1-1. TSU 600 Option Modules ................................................................... 1-4 Figure 1-2. Router, PBX, Video Conferencing Application Set Up .................. 1-5 Figure 1-3. Drop and Insert, Voice, and Router Application Set Up ............... 1-6 Figure 2-1a. TSU 600 Rear Panel ............................................................................ 2-5 Figure 2-1b. TSU 600 with DC Power Rear Panel...........................................
ページ18に含まれる内容の要旨
List of Figures vi TSU 600 User Manual 61202076L1-1
ページ19に含まれる内容の要旨
List of Tables Table B-1. Alarm Conditions ................................................................................. B-2 Table B-2. TR-08 DS0 Conversion Table .............................................................. B-3 Table C-1. Network Pinouts.................................................................................. C-1 Table C-2. Control In/Chain In Pinout ............................................................... C-2 Table C-3. Chain-Out Pinout ..............
ページ20に含まれる内容の要旨
List of Tables viii TSU 600 User Manual 61202076L1-1
