ページ1に含まれる内容の要旨
®
oastmaster
T
AM24SS
AM24SS and AM36SS
™
Griddles
OWNER'S OPERATING
& INSTALLATION
MANUAL
®
Toastmaster
A Middleby Company
Part No. 37813
Price $15.00
Middleby Cooking Systems Group • 1400 Toastmaster Drive • Elgin, IL 60120 • (847)741-3300 • FAX (847)741-4406
P Apr. 98 Rev B
ページ2に含まれる内容の要旨
NO QUIBBLE LIMITED WARRANTY TOASTMASTER, HEREINAFTER REFERRED TO AS THE SELLER, WARRANTS EQUIPMENT MANUFACTURED BY IT TO BE FREE FROM DEFECTS IN MATERIAL AND WORKMANSHIP FOR WHICH IT IS RESPONSIBLE. THE SELLER’S OBLIGATION UNDER THIS WARRANTY SHALL BE LIMITED TO REPLACING OR REPAIRING, AT SELLER’S OPTION, WITHOUT CHARGE, ANY PART FOUND TO BE DEFECTIVE AND ANY LABOR AND MATERIAL EXPENSE INCURRED BY SELLER IN REPLACING OR REPAIRING SUCH PART. SUCH WARRANTY SHALL BE LIMITED TO THE ORIGINAL PURCHA
ページ3に含まれる内容の要旨
WARNING: IN CASE OF FIRE Disconnect the griddle from its power source IMMEDIATELY. Shutting down the electrical heating elements allows the unit to cool, making it easier to put out the fire. WARNING: FOR YOUR SAFETY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS OR LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE CAUTION Use only a fire extinguisher filled with CO , which is suitable for electrically powered 2 equipment. Do NOT attempt to fight a grease fire by aiming the nozz
ページ4に含まれる内容の要旨
TABLE OF CONTENTS SECTION 1 DESCRIPTION............................................................................................................................................... 1 A. Features.............................................................................................................................................1 B. Component Location..........................................................................................................................1 C. Specification
ページ5に含まれる内容の要旨
SECTION 1 DESCRIPTION A. Features Models: • AM24SS, 24” (610mm) wide, two 12” (305mm) infrared heat panels • AM36SS, 36” (914mm) wide, three 12” (305mm) infrared heat panels Accu-Miser Series SS griddles are: • Electrically heated by infrared emitter panels • Temperature-controlled by solid-state thermostat • Counter-top mounted The Accu-Miser griddle employs infrared cooking technology. Infrared heat panels are located below the griddle plate. Each panel is 12” (305mm) in width, and provides
ページ6に含まれる内容の要旨
SECTION 1 - DESCRIPTION C. Specifications Griddle plate dimensions AM24SS 24” (610mm) D x 23-7/8” (606mm) W AM36SS 24” (610mm) D x 35-7/8” (911mm) W Overall dimensions AM24SS 32-1/8” (816mm) D x 24” (610mm) W x 17-7/8” (454mm) H AM36SS 32-1/8” (816mm) D x 36” (914mm) W x 17-7/8” (454mm) H Overall weight AM24SS 170 lbs. (77.2kg) AM36SS 244 lbs. (110.8kg) Shipping dimensions AM24SS 33” (838mm) D x 29” (737mm) W x 18” (457mm) H AM36SS 33” (838mm) D x 40” (1016mm) W x 17” (432mm) H Shipping weight A
ページ7に含まれる内容の要旨
SECTION 1 - DESCRIPTION 3 E. Dimensional Drawings
ページ8に含まれる内容の要旨
SECTION 1 - DESCRIPTION NOTES 4
ページ9に含まれる内容の要旨
SECTION 2 INSTALLATION A. Shipping Damage Inspection C. Installation IMPORTANT NOTE IT IS THE CUSTOMER’S RESPONSIBILITY TO IF INSTALLING THE GRIDDLE ON A STAND, REPORT ANY CONCEALED OR NON- CONSULT THE STAND INSTRUCTIONS FOR CONCEALED DAMAGE TO THE FREIGHT THE INSTALLATION PROCEDURE. ENSURE COMPANY. THAT THE LOCATION OF THE STAND ALLOWS SUFFICIENT CLEARANCE FOR THE GRIDDLE, 1. All shipping containers should be examined AS SHOWN IN THE DIAGRAM BELOW. THEN, for damage before and during unloading
ページ10に含まれる内容の要旨
SECTION 2 - INSTALLATION c. Level the griddle using a carpenter’s level. 1. The surface of the griddle plate is coated with Then, rotate the “foot” (hexagonal) portion a rust-preventive material to protect it during of the legs to adjust the griddle to a level shipment. Clean this material from the griddle position. plate with a non-flammable grease solvent. d. Ensure that the griddle is level from front- 2. Wash the griddle with warm water and a mild to-back and from side-to-side. detergent. 3
ページ11に含まれる内容の要旨
SECTION 3 OPERATION A. Controls WARNING NEVER TOUCH AN OPERATING GRIDDLE. ALWAYS WAIT UNTIL ALL This section provides a basic description of the ON/OFF SWITCHES HAVE BEEN SET location and function of the griddle operating TO “OFF” FOR AT LEAST 30 MINUTES. controls (all located on the control panel). Refer to the diagram below. 4. Turn all Thermostat Control Knobs to 0 (off). Switch the On/Off Switches to “Off.” 1. Thermostat Control Knob: Adjusts the 5. Wait at least 30 minutes for the griddl
ページ12に含まれる内容の要旨
SECTION 3 - OPERATION D. Daily Operation And Maintenance Daily Pre-Operation 2. Cleaning the exterior 1. Season the griddle before operation daily as a. Wipe down the sides of the griddle, and all described in Step B, Seasoning the Griddle. areas around the griddle, with a damp towel to remove accumulated splashed 2. Always allow 15 minutes of preheat time before grease. loading the griddle with food. This will allow the griddle surface to be saturated with heat. b. Remove any remaining grease w
ページ13に含まれる内容の要旨
SECTION 3 - OPERATION E. Troubleshooting Problem Action Griddle is not heating. 1. Check that the breaker/fused disconnect is in the ON position. Griddle zone is not heating. 1. Check that the corresponding rocker switch is turned on. 2. Check that the thermostat is set to the proper temperature. If problems persist, contact your local Authorized Service Agent. 9
ページ14に含まれる内容の要旨
SECTION 4 WIRING DIAGRAMS A. Wiring Diagram - AM24SS 10
ページ15に含まれる内容の要旨
SECTION 4 - WIRING DIAGRAMS B. Wiring Diagram - AM36SS 11
ページ16に含まれる内容の要旨
For more information on the complete line of Toastmaster products, contact your Food Service Equipment Dealer, or write to us at the address below. A Middleby Company Middleby Corp 24-Hour Service Hotline 1-800-238-8444 Toastmaster 1400 Toastmaster Drive Elgin, IL 60120 (847)741-3300 FAX (847)741-4406
