Résumé du contenu de la page N° 1
Contents
1 INSTRUCTIONS FOR SAFE AND PROPER USE ________________________________4
2 INSTALLATION OF THE APPLIANCE__________________________________________6
3 ADAPTATION TO DIFFERENT TYPES OF GAS _________________________________9
4 FINAL OPERATIONS______________________________________________________15
5 DESCRIPTION OF FRONT PANEL CONTROLS ________________________________17
6 USE OF THE COOKING HOB _______________________________________________19
7 USE OF THE OVEN___________
Résumé du contenu de la page N° 2
Introduction 1 INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE COOKER. WE ADVISE READING THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE COOKER. ALSO KEEP THE SERIES OF NOZZLES SUPPLIED. INSTALLATION MUST BE CARRIED OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOM
Résumé du contenu de la page N° 3
Introduction LOWER THE GLASS COVER SLOWLY AND BY HAND. WARNING: THE GLASS COVER MAY SHATTER IF IT OVERHEATS. SWITCH OFF ALL RINGS AND WAIT FOR THEM TO COOL DOWN BEFORE CLOSING THE COVER. DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE NOT TO TOUCH THE HEATING ELEMENTS INSIDE THE OVEN. THE APPLIANCE IS DESIGNED FOR USE BY ADULTS. DO NOT ALLOW CHILDREN TO GO NEAR OR PLAY WITH IT. WHEN OPERATING THE GRILL ALL ACCESSIBLE PARTS COULD BECOME VERY HOT: KEEP OUT OF THE WAY
Résumé du contenu de la page N° 4
Instruction for the installer 2 INSTALLATION OF THE APPLIANCE It is the law that all gas appliances are installed by competent persons. Corgi gas installers are approved to work to safe and satisfactory standards. All gas installation, servicing and repair work must be in accordance with the gas safety regulations 1984 (installation and use) as amended 1990. It can be placed against walls higher than the hob, at a distance of at least 50 mm from the side of the appliance, as s
Résumé du contenu de la page N° 5
Instruction for the installer 2.1 Electrical connection Make sure that the power line voltage matches the specifications indicated on the rating plate located inside the storage compartment. This rating plate must never be removed. If the appliance is hooked-up to the supply by means of a fixed connection, install a multipolar cut-out device on the line, with contact opening distance equal to or greater than 3 mm, located near the appliance and in an easily reachable
Résumé du contenu de la page N° 6
Instruction for the installer 2.3 Connecting to natural and LPG gas (Please see connection diagram) Make the connection to the appliance using flexible bayonet style hose in accordance to B.S. 669. The hose connection at the rear of the appliance has a ½” BSP internal thread. Please use seal C between the flexible connection L and the appliance supply tube B. When making the connection, make sure that no stress of any kind is applied to the cooker and that the hose does not to
Résumé du contenu de la page N° 7
Instruction for the installer 3 ADAPTATION TO DIFFERENT TYPES OF GAS Before performing any cleaning or maintenance work, detach the appliance from the electrical socket. The cooker hob is set for natural gas G20 (2H) at a pressure of 20 mbar for cookers with maxi oven, and for LPG G30/G31 (3+) at a pressure of 28/37 mbar for cookers with gas-bottle compartments. In the case of functioning with other types of gas the burner nozzles must be changed and the minimum flame
Résumé du contenu de la page N° 8
Instruction for the installer 3.2 Burner and nozzle characteristics table (60 cm models) Rated heating Burner LPG – G30/G31 28/37 mbar capacity (kW) Nozzle By-pass Reduced Flowrate Flowrate diameter mm flowrate g/h G30 g/h G31 1/100 mm 1/100 (W) Auxiliary 1.0 50 30 350 73 71 Semi-rapid 1.75 65 33 450 127 125 Rapid (3) 3.0 85 45 800 218 214 Rapid (5) 2.3 75 45 800 167 164 Triple crown 3.2 91 65 1500 233 229 Oven 3.2 87
Résumé du contenu de la page N° 9
Instruction for the installer 3.3 Burner and nozzle characteristics table (80 cm models) Rated Burner heating LPG – G30/G31 28/37 mbar capacity (kW) Nozzle By-pass Reduced Flowrate Flowrate diameter mm Flowrate g/h G30 g/h G31 1/100 mm 1/100 (W) Auxiliary 1 50 30 350 73 71 Semi-rapid 1.75 65 33 450 127 125 Rapid 2.5 79 45 800 167 164 Triple crown 3.5 94 65 1500 254 250 Oven 3.2 87 48 850 233 229 Maxi oven 4.6 106 59 1200 334 328 Grill 3.7 94 // // 269 264
Résumé du contenu de la page N° 10
Instruction for the installer 3.4 Burner and nozzle characteristics table (90 cm. models) Rated Burner heating LPG – G30/G31 28/37 mbar capacity (kW) Nozzle By-pass Reduced Flowrate Flowrate diameter mm flowrate g/h G30 g/h G31 1/100 mm 1/100 (W) Auxiliary 1 50 30 350 73 71 Semi-rapid 1.75 65 33 450 127 125 Rapid 3 85 45 800 218 214 Triple crown 3.2 91 65 1500 233 229 Fish pan 1.9 68 45 800 138 136 Oven 3.2 87 48 850 233 229 Maxi oven 5.2 110 59 1200 378 371
Résumé du contenu de la page N° 11
Instruction for the installer 3.5 Arrangement of burners on cooking hob BURNERS 1. Auxiliary 2. Semi-rapid 3. Rapid (60 X 60) 4. Triple crown 5. Rapid (60 X 50) 3.6 Arrangement of burners on cooking hob BURNERS 1. Auxiliary 2. Semi-rapid 3. Rapid 4. Triple crown 5. Large electric hob (1500W) 6. Small electric hob (1000W) 7. Fish pan 8. Triple crown 13
Résumé du contenu de la page N° 12
Instruction for the installer 3.7 Adjustment of the oven burner (only for gas oven models) To adjust the oven burners follow the procedure described below from inside the oven: • Open the oven door; • Remove the oven dish and shelf. • Lift up the oven floor and remove. 3.7.1 Replacement of the oven and grill burner nozzles • Loosen the fixing screws A on the oven burner. • Push the burner B towards the right to get to the nozzle. • Use a 13 socket wrench to c
Résumé du contenu de la page N° 13
Instruction for the installer 4 FINAL OPERATIONS After replacing the nozzles, reposition the flame-spreader crowns, the burner caps and the grids. Following adjustment to a gas other than the preset one, replace the gas adjustment label fixed to the appliance with the one corresponding to the new gas. This label is in the packet together with the nozzles. 4.1 Regulation of the hob burner minimum level for natural gas Light the burner and turn it to the mi
Résumé du contenu de la page N° 14
Instruction for the installer 4.4 Mounting the rear top skirtboard (where applicable) • Loosen screws A located beneath the skirt. • Loosen nuts B. • Position the skirt above the top, taking care to align pins C with holes D. • Secure the skirt to the top by tightening screws E. 4.5 Positioning and levelling of the appliance (Depending on models) Having carried out the electricity and gas hook-up, level the appliance using the four adjustable legs. For best cook
Résumé du contenu de la page N° 15
Instruction for the user 5 DESCRIPTION OF FRONT PANEL CONTROLS All the oven controls are grouped together on the front panel. The table below provides a description of the symbols used. FRONT RIGHT BURNER FRONT CENTRAL BURNER BACK RIGHT BURNER CENTRAL BURNER BACK LEFT BURNER GAS OVEN THERMOSTAT KNOB FRONT LEFT BURNER OVEN LIGHT / ROTISSERIE / GRILL SWITCH BACK CENTRAL BURNER BURNER IGNITION BUTTON OVEN LIGHT SWITCH
Résumé du contenu de la page N° 16
Instruction for the user GAS OVEN THERMOSTAT KNOB (CERTAIN MODELS ONLY) This knob is used to ignite the gas burner inside the oven. The cooking temperature is selected by turning the knob anticlockwise to the desired setting, between Min. and 275°C. For information on how to ignite the gas oven, see point “ 7.3 Use of the gas oven ”. OVEN LIGHT / ROTISSERIE / GRILL SELECTOR KNOB (CERTAIN MODELS ONLY) This knob allows the user to activate the Grill / Rotisserie
Résumé du contenu de la page N° 17
Instruction for the user 6 USE OF THE COOKING HOB 6.1 Lighting of the cooking hob burners Before lighting the hob burners check that the flame caps are in the correct position and that their burner caps are in place, making sure that the holes A in the flame caps correspond to the spark plugs and thermocouples. Before lighting the burners lift the glass cover; before lowering the cover, turn off all the burners and wait for them to cool down. The optional grid
Résumé du contenu de la page N° 18
Instruction for the user 6.3 Diameter of containers (60 cm. models) BURNERS Ø min. and BURNERS Ø min. and (60 X 50) max. (in cm.) (60 X 60) max. (in cm.) 1. Auxiliary 12 – 14 1. Auxiliary 12 – 14 2. Semi-rapid 16 – 22 2. Semi-rapid 16 – 24 5. Rapid 18 – 24 3. Rapid 18 – 26 4. Triple crown 18 – 26 6.4 Diameter of containers (90 cm. models) BURNERS Ø min. and max. (in cm.) 1. Auxiliary 12 – 14 2. Semi-rapid
Résumé du contenu de la page N° 19
Instruction for the user 6.6 Switching on the electric hob 6.6.1 Switching on the electric hobs The cookers are equipped with hobs of different diameters. These are controlled by a switch and are turned on by turning the knob to the desired position. On the front panel above each knob a small drawing shows which hob corresponds to each knob. A yellow warning light lights up when the hob is switched on. 6.6.2 How to use the electric hobs The rapid hobs offer
Résumé du contenu de la page N° 20
Instruction for the user 7 USE OF THE OVEN For those models with electronic programmer, before using the oven make sure that the display shows the symbol . For those models with analogue clock and timer, place on the symbol . 7.1 Warnings and general advice Using the oven and the grill for the first time, heat them to the maximum temperature (260°C for electric oven and 275°C for gas oven) for as long as it takes to burn off any production oil residues which c
