Résumé du contenu de la page N° 1
Installation instructions
and User guide
Gas cooktops
CG604 models
NZ AU
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
Contents 1 Safety and warnings 2 Installation instructions 6 Introduction 16 Using your cooktop 18 Care and cleaning 22 Troubleshooting 26 Warranty and service 27 Important! SAVE THESE INSTRUCTIONS The models shown in this user guide may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please visit our local website listed on the back cover or contact your local Fis
Résumé du contenu de la page N° 4
2 Safety and warnings WARNING! Cut Hazard Beware of sharp edges when handling stainless steel appliances. Failure to use caution could result in injury or cuts. WARNING! Electrical Shock Hazard Before carrying out any work on the electrical section of the appliance, it must be disconnected from the mains electricity supply. Connection to a good earth wiring system is absolutely essential and mandatory. Failure to follow this advice may result in death or electrical shock. Important safety in
Résumé du contenu de la page N° 5
3 Safety and warnings Particular attention shall be given to the relevant requirements regarding ventilation. This product should not be sealed into the bench with silicone or glue. Doing so will make future servicing difficult. Fisher & Paykel will not be liable for costs associated with releasing such a product, nor for repairing damage that may be incurred in doing this. When this product is installed it shall not be used as a space heater, especially if installed in boats or carav
Résumé du contenu de la page N° 6
4 Safety and warnings WARNING! Hot Surface Hazard This appliance becomes hot during use. Do not touch the cooktop components, burners, trivets, pan supports or the base when hot. Before cleaning, turn the burners off and make sure the whole cooktop is cool. Failure to follow this advice may result in serious injury. WARNING! Explosion Hazard Do not use or store fl ammable materials such as gasoline near this appliance. Do not spray aerosols in the vicinity of this appliance while it is in
Résumé du contenu de la page N° 7
5 Safety and warnings Important safety instructions Operation Keep children away from the cooktop when it is in use. Household appliances are not intended to be played with by children. Children, or persons with a disability which limits their ability to use the appliance, should have a responsible person to instruct them in its use. The instructor should be satisfied that they can use the appliance without danger to themselves or their surroundings. If the electrical supply cord is damag
Résumé du contenu de la page N° 8
0 200 560 –2 580 34 6 Installation instructions Dimensions and clearances This cooktop has been designed and constructed in accordance with the following codes and specifications: AGA101 (AS 4551) Approval Requirements for Domestic Gas cooking appliances AS/NZS 60335-1 General Requirements for Domestic electrical appliances AS/NZS 60335-2-6 Particular Requirements for Domestic electrical cooking appliances AS/NZS 1044 Electromagnetic Compatibility Requirements. The installation shall comply
Résumé du contenu de la page N° 9
200 mm min 500 mm 7 Installation instructions Installation clearances and protection of combustible surfaces shall comply with the current local regulations e.g. AG 601 (AS 5601) and NZS5261 - Gas Installations code. Fig. 2 Clearances Fig. 3 Mounting the base clearance spacers 60 mm min 450 mm 750 mm 20 mm
Résumé du contenu de la page N° 10
8 Installation instructions Fastening the installation brackets (Fig. 4) Each cooktop is provided with an installation kit including brackets and screws for fastening the cooktop to benches from 20 to 40 mm thick. Turn the cooktop upside down, place it on a soft surface and fasten the brackets “F and R” to the appropriate socket holes, without tightening the screws “B” for the moment (see Fig. 4). Fastening the cooktop (Fig. 4) 1 Spread the sealing material “C” out along the edge of the cut
Résumé du contenu de la page N° 11
9 Installation instructions Connecting the cooktop to the gas supply The gas connection must be carried out by an authorised person according to the relevant standards. Before connecting the appliance to the gas main, mount the brass conical adaptor onto the gas inlet pipe, upon which the washer has been placed (Figs. 5 and 6). Conical adaptor and washer are supplied with the appliance (packed with conversion kit for use with Natural gas or LPG). This appliance is suitable for
Résumé du contenu de la page N° 12
10 Installation instructions Leak-testing and flame-testing the cooktop 1 After connecting the gas supply, check the piping and connections for leaks using a soap and water solution. The presence of bubbles indicates a leak. Tighten or replace connections as appropriate. Important! Do not use any naked flame to check for leaks. 2 The operation of the appliance MUST be tested before leaving. 3 Adjust the test point pressure or supply pressure to the value which is appropriate for the gas
Résumé du contenu de la page N° 13
11 Installation instructions Converting to a different gas type Important! The conversion procedure must be carried out only by an authorised person. This appliance is suitable for use with Natural gas or LPG (check the “gas type” sticker attached to the appliance). To convert from one gas type to another, you need to replace the injectors, and then adjust the minimum burner setting. Replacing the injectors Remove the trivets and burners from the cooktop. Using a spanner, remove t
Résumé du contenu de la page N° 14
12 Installation instructions Adjusting the minimum burner setting When changing from one type of gas to another, the minimum valve output must also be correct, considering that in this position the flame must be about 4 mm long and must re- main lit even when the knob is turned quickly from the maximum to the minimum position. The adjustment is performed with the burner lit, as follows: Turn the knob to the minimum position. Remove the knob. On gas valves provided with adjustment screw in th
Résumé du contenu de la page N° 15
13 Installation instructions Important! Installation must be carried out according to the manufacturer's instructions. Incorrect installation may cause harm and damage to people, animals or property, for which the manufacturer accepts no responsibility. If the installation requires alterations to the domestic electrical system, call a qualified electrician. The electrician should also check that the socket cable section is suitable for the power drawn by the appliance. Before
Résumé du contenu de la page N° 16
14 Installation instructions Wiring diagram PA Ignition switch A Ignition coil M Terminal block CA Spark electrode CA CA NL CA M CA A PA PA PA PA Fig. 11
Résumé du contenu de la page N° 17
15
Résumé du contenu de la page N° 18
16 Introduction About your new cooktop Thank you for buying a Fisher & Paykel gas cooktop. Once it is installed and ready to use, you will want to know everything about it to make sure you get excellent results right from the start. This guide introduces you to all its special features. We recommend you read the whole guide before using your new cooktop, for both safety and cooking success. Before using your new cooktop Before using your new cooktop, please: Read this user guide, taking specia
Résumé du contenu de la page N° 19
17 Introduction 2 2 9 8 7 5 3 Fig.12 CG604 with rapid burner 1 (no flame failure safety feature) (not available in New Zealand) 2 2 2 2 9 9 8 8 6 6 5 5 4 4 1 1 Fig.13a CG604 with wok burner Fig.13b CG604 with wok burner ( with flame failure safety feature) (no flame failure safety feature) (not available in New Zealand) 1 Auxiliary burner 6 Wok burner knob 2 Semi-rapid burner 7 Rapid burner knob 3 Rapid burner 8 Left semi-rapid burner knob 4 Triple-ring wok burner 9 Right semi-rapid burner
Résumé du contenu de la page N° 20
18 Using your cooktop Gas burners The knob (Fig. 14) controls the flow of gas through the safety valve. OFF = closed valve = maximum flow = minimum flow You can choose to cook at any heat between and , but never between and OFF. Fig. 14a Burner knob and symbols (models without flame failure safety feature) Fig. 14b Burner knob and symbols (models with flame failure safety feature)
