Résumé du contenu de la page N° 1
Installation Instructions
™
Distinctive 30-Inch Gas Range
For use with models DR30GS, DR30GFS, DR30GIS and DR30GIFS
THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LATEST EDITION
OF ANSI Z21.1a-2011 STANDARD FOR HOUSEHOLD GAS COOKING APPLIANCES.
Part No. 105908 Rev. D
Résumé du contenu de la page N° 2
Table of Contents Important Safety Instructions .....................................................1 Installing the Anti-Tip Bracket .........................................................9 Important Information About Safety Instructions ............................1 Backguard Kit Installation ............................................................. 11 General Safety Precautions ...........................................................2 Rear Trim Piece Installation ...................
Résumé du contenu de la page N° 3
Important Safety Instructions Important Information About Safety WARNING Instructions WARNING – NEVER use this appliance as a space heater to heat or warm the room. Doing so may result The Important Safety Instructions and warnings in this in carbon monoxide poisoning and overheating of the manual are not meant to cover all possible problems and appliance. conditions that can occur. Use common sense and caution when installing, maintaining or operating this appliance. Always contact the
Résumé du contenu de la page N° 4
Important Safety Instructions General Safety Precautions To reduce the risk of fire, explosion, electric shock, serious injury or death when installing or using this appliance, follow basic safety precautions, including the following: WARNING WARNING • Read the accompanying use and care manual • Do not leave children or pets alone or unattended completely before operating this appliance. in the area around the range. Do not allow children to play with the controls, pull on the handle or
Résumé du contenu de la page N° 5
Important Safety Instructions WARNING WARNING TO REDUCE THE RISK OF INJURY TO PERSONS IN • Do not expose the knobs to direct flame, hot utensils THE EVENT OF A RANGE TOP GREASE FIRE: or other sources of heat. a. SMOTHER FLAMES with a close-fitting lid, cookie • Always ensure that the light fixture lens cover is in sheet or metal tray, then turn off the burner. BE place when using the oven. The lens cover protects CAREFUL TO PREVENT BURNS. If the flames do not the light bulb from brea
Résumé du contenu de la page N° 6
Installation Specifications Product Dimensions All tolerances: ±1/16” (±1.6 mm), unless otherwise stated 46 3/4” (118.7 cm) Front of open door NOTE: Models DR30GS and 28 9/16” (72.5 cm) Front of handle DR30GFS are not compatible 28” (71.1 cm) Front of knobs with a raised vent. 26 1/8” (66.4 cm) Front panel 24” (61.0 cm) Rear of front panel 1 1/8” (2.9 cm) Backguard thickness 9” (22.9 cm) Backguard* Grates extend 6” (15.2 cm) 1” above trim backguard* 3” (7.6 cm) backguard* DR30GI[F]S: 1 3/4” (4
Résumé du contenu de la page N° 7
Installation Specifications Gas Supply Requirements WARNING • Be certain that the range being installed is correct for • This appliance must be installed and electrically the gas service being provided (natural gas or LP gas). grounded in conformance to local codes. • An external manual shut-off valve must be installed • In the absence of local codes, the appliance between the gas inlet and the range for the purpose of installation must conform with the National Fuel turning on or s
Résumé du contenu de la page N° 8
Installation Specifications Cabinet Layout WARNING All tolerances: +1/16” (+1.6 mm), -0 • Failure to meet or exceed the maximum unless otherwise stated and minimum dimensions/clearances stated may result in a fire hazard. B • To eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space located above surface units should be avoided. • Carefully check the location where the range is to be installed. For best performance, the range should be place
Résumé du contenu de la page N° 9
Installation Specifications Self-Rimming Installation Cutout Options (Models DR30GIS and DR30GIFS Only) For all self-rimming installations (without raised vent): Countertop height: 34 3/4” (88.3 cm) min. 36 7/8” (93.7 cm) max. Countertop thickness: 1 5/8” (4.1 cm) max. 10” min. (25.4 cm) 10” min. (25.4 cm) Rear wall or Non-combustible 3/4” min. (1.9 cm) to any combustibles to any combustibles 1 1 countertop edge rear wall required countertop overhang
Résumé du contenu de la page N° 10
Installation Specifications Raised Vent (Self-Rimming) Installation Cutout Options (Models DR30GIS and DR30GIFS Only) For all installations with a raised vent: 3/8” min. (1.0 cm) flat countertop overhang required behind cutout Countertop height: 34 3/4” (88.3 cm) min. Wall 36 7/8” (93.7 cm) max. 29 1/2” (74.9 cm) Countertop thickness: 1 5/8” (4.1 cm) max. Stiffener 10” min. (25.4 cm) Countertop Rear wall or 3/8” (9.5 mm) min. to any combustibles counter
Résumé du contenu de la page N° 11
Installation Specifications • Existing utility connections may be used for Gas and Electrical Locations replacement purposes, provided they meet local code • Dacor recommends that utility access for all models and fit within the utility clearance area at the back of be installed in an adjacent cabinet, as shown on page the range. See diagram, below. 6. If the utilities are installed behind the range, the installation must allow for the following: ◊ Access to the gas shut-off valve when
Résumé du contenu de la page N° 12
Installation Instructions Attaching the bracket to a concrete floor: Installing the Anti-Tip Bracket on the Floor (cont.) • Drill four (4) 3/8” diameter countersink holes through any existing floor covering to the concrete slab below. Four (4) plastic anchors are provided along with three sizes (4 each) of #8 or #12 Phillips head screws for attaching • Drill the 4 holes for the anchors 1 1/4” (3.2 cm) deep the anti-tip bracket to the floor. Use both the anchors and into the concrete slab u
Résumé du contenu de la page N° 13
Installation Instructions Installing the Anti-Tip Bracket on the Wall Top hole, indicates 1. Determine the suitability of wall mounting the anti-tip #12 x 1 3/4” bracket center line bracket. To use the wall mount option, the range front screw, panel must not be more than 27 3/8” (69.5 cm) from 4 places the wall and the bracket screws must be able to thread into the base plate inside the wall behind. The notches on the sides of the bracket indicate the minimum required height of the base pl
Résumé du contenu de la page N° 14
Installation Instructions Door Removal Side Panel Removal Remove the door to make the range easier to move during (Model DR30GIS/DR30GIFS only) the installation process. If the range will be installed with the partial side panels removed: WARNING 1. Remove the three screws just below the oven opening • Do not attempt to disengage the hinge catches with that hold the kick panel in place. the door removed from the oven. The hinge springs 2. Pull the kick panel straight out to snap it off of
Résumé du contenu de la page N° 15
Installation Instructions Rear Trim Piece Installation Gas Connection (Model DR30GIS/DR30GIFS only) WARNING For self-rimming installations, with or without a raised • Make sure the gas is turned off at the gas supply vent, install the included 1 inch deep rear trim piece to valve before connecting the gas line. overhang the countertop/raised vent in back. Use the two (2) included #8 x 1/4 screws. • Verify that the gas supply meets specifications before connection. See page 5. • Do not
Résumé du contenu de la page N° 16
Installation Instructions Moving the Range to Final Location Re-Installing the Door 1. Peel the protective plastic coating off of the range, WARNING including the range door. To avoid personal injury or damage to the door from it 2. Uncoil the power cord and route it to the electrical falling off its hinges: outlet so that it does not become trapped behind the range when it is pushed back. Do not connect • Make sure that the notch on the bottom of each hinge the power plug until you are
Résumé du contenu de la page N° 17
Installation Instructions Cooktop Assembly WARNING Never attempt to operate the range’s cooktop with any of the burner rings, burner caps or grates removed. 1. Remove the burner rings, burner caps and grates from their shipping cartons. 2. Install the burners as shown. Gently twist each piece back and forth after installation to make sure it is properly seated. A small gap below the bottom of the burner ring is normal. 3. Gently set the grates on top of the spill tray. Put the legs of e
Résumé du contenu de la page N° 18
Installation Instructions 10. Turn the oven control knob to the BROIL position. The Verifying Proper Operation bake burner should turn off. Both the oven control knob and the oven ON indicator light should be illuminated. WARNING Within 60 seconds the broil burner on the ceiling of the oven should ignite and begin to give off heat. Before operating the range, read the accompanying use and care manual completely. 11. Turn the oven knob to the OFF position. 1. Before beginning the test proc
Résumé du contenu de la page N° 19
Installation Instructions Installation Checklist WARNING To ensure a safe and proper installation, the installer must perform the following checklist to ensure that no part of the installation has been overlooked. Proper installation is the responsibility of the homeowner. □ Has the plastic coating been peeled off of the outside of the range? Have all packaging materials been removed from inside the oven? □ Are all leveling legs extended down to make contact with the floor? Is the unit l
Résumé du contenu de la page N° 20
Notes 18
