Résumé du contenu de la page N° 1
DGC5 & HGC5 SERIES
GAS CONVECTION OVENS
MODELS
DGC5 ML-126614
HGC5 ML-126615
HGC5X ML-126618
HGC5D ML-126616
HGC5DX ML-126619
701 S. RIDGE AVENUE
TROY, OHIO 45374-0001
937 332-3000
www.hobartcorp.com
FORM 34312 Rev. E (Apr. 2005)
Résumé du contenu de la page N° 2
IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL GAS EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. POST IN A PROMINENT LOCATION THE INSTRUCTIONS TO BE FOLLOWED IN THE EVENT THE SMELL OF GAS IS DETECTED. THIS INFORMATION CAN BE OBTAINED FROM THE LOCAL GAS SUPPLIER. IMPORTANT IN THE EVENT A GAS ODOR IS DETECTED, SHUT DOWN UNITS AT MAIN SHUTOFF VALVE AND CONTACT THE LOCAL GAS COMPANY OR GAS
Résumé du contenu de la page N° 3
Installation, Operation and Care of DGC5 & HGC5 SERIES GAS CONVECTION OVENS SAVE THESE INSTRUCTIONS FOR FUTURE USE GENERAL Hobart DGC5 & HGC5 Series Gas Convection Ovens are produced with quality workmanship and material. Proper installation, usage and maintenance of your oven will result in many years of satisfactory performance. It is suggested that you thoroughly read this entire manual and carefully follow all of the instructions provided. Models DGC5, HGC5 and HGC5X feature a solid state te
Résumé du contenu de la page N° 4
INSTALLATION Before installing, verify that the electrical service and type of gas supply (natural or L.P. gases) agree with the specifications on the rating plate, located behind the top trim panel on the front of the oven. If the supply and equipment requirements do not agree, do not proceed with the installation. Contact your dealer or Hobart Corporation immediately. UNPACKING Immediately after unpacking, check for possible shipping damage. If the oven is found to be damaged, save the packagi
Résumé du contenu de la page N° 5
In Canada: 1. Local codes. 2. CSA B149.1 Natural Gas and Propane Installation Code. 3. STANDARD C22.1 Canadian Electric Code (latest edition). 4. CSA C22.1 Canadian Electric Code (latest edition). 5. CSA C22.2 No. 3 Canadian Electric Code (latest edition). 6. CSA Standard C22.2 No. 3 Electrical Features of Fuel Burning Equipment (latest edition). The above are available from the Canadian Standard Association, 5060 Spectrum Way, Suite 100, Mississauga, Ontario, Canada L4W 5N6. INSTALLING BASIC
Résumé du contenu de la page N° 6
Assembling the Legs to the Oven The legs must be installed on the bottom of the oven. Gently BACK position the oven on its side, taking care not to scratch or damage it. Attach each of the four leg assemblies to the bottom of the oven with the 24 bolts and lockwashers (six per leg). Carefully raise the oven to its normal position. ASSEMBLING THE STAND TO THE OVEN Attach each of the four leg assemblies to the bottom of the FRONT oven with the 24 bolts and lockwashers (six per leg). Carefully rai
Résumé du contenu de la page N° 7
LEVELING Ensure that the oven racks are level in the final installed position. If the oven is installed on legs, turn the adjustable feet in or out to level the oven front-to-back and side-to-side. If the oven is installed on casters, loosen set screws and turn casters in or out to level the oven front-to-back and side-to-side. Retighten set screws after leveling. GAS CONNECTION GAS DATA IE NPUT RATING MANIFOLD PRESSUR MODEL L. P. Gases L. P. Gases Natural Natural (Propane) (Propane) DGC5, 3.5"
Résumé du contenu de la page N° 8
BURNER AIR ADJUSTMENT Although main burner air is adjusted before shipment, it should be checked at the time of installation. Excessive air will cause flames to lift off a burner when cold or may cause flash-back during normal cycling of oven, particularly when propane gas is used. Insufficient air will cause flames to burn with a yellow tip and result in carbon accumulation in the flame chamber and heat exchanger tubes. Contact your local Hobart servicer if required. VENT SYSTEM Do not obstruct
Résumé du contenu de la page N° 9
ELECTRICAL DATA Minimum Circuit Ampacity MH odels V/Hz/P Maximum Protective Device AMPS 120/60/1 15 208/60/1 15 DGC5, 240/60/1 15 HGC5, HGC5X, 240/50/1 15 HGC5D, HGC5DX 220/380 (3W)/50/3 15 220/380 (4W)/50/3 15 240/415 (4W)/50/3 15 – 9 –
Résumé du contenu de la page N° 10
OPERATION WARNING: THE APPLIANCE AND ITS PARTS ARE HOT. USE CARE WHEN OPERATING, CLEANING OR PERFORMING ANY MAINTENANCE. CONTROLS (Models DGC5, HGC5 and HGC5X — Without Cook & Hold) POWER POWER ON ON OFF OFF COOL DOWN COOL DOWN ON ON HEAT HEAT IGNITION IGNITION COOK TEMPERATURE COOK TEMPERATURE 350 200 350 200 375 375 325 325 150 150 400 400 300 300 425 425 275 275 450 450 250 250 225 475 225 475 500 500 150 F 150 F 250 250 100 C 100 C COOK TIME COOK TIME 0 0 5 OFF 10 60 5 1 15 55 20 50 4 2
Résumé du contenu de la page N° 11
CONTROLS (Models DGC5, HGC5 and HGC5X — With Cook & Hold) POWER POWER ON ON OFF OFF COOL DOWN COOL DOWN ON ON HEAT HEAT IGNITION IGNITION COOK TEMPERATURE COOK TEMPERATURE 200 350 200 350 375 375 325 325 150 150 400 400 300 300 275 425 275 425 450 450 250 250 225 475 225 475 500 500 150 F 150 F 250 250 100 C 100 C COOK & HOLD TIME COOK & HOLD TIME OFF OFF 0 0 5 1 5 1 2 4 2 4 3 3 COOK TIME COOK TIME 0 0 5 OFF 10 60 1 5 15 55 20 50 25 4 2 45 30 40 35 3 LIGHTS LIGHTS COOK COOK ON ON FUNCT
Résumé du contenu de la page N° 12
BEFORE FIRST USE Before using the oven for the first time, it must be "burned in" to release any odors that might result from heating the new surfaces in the chamber. 1. Using a clean, damp cloth, wipe the inside of the oven including the racks. 2. Close the oven doors. 3. Push the Power switch ON 4. Turn the Cook Temperature to 300°F (149°C), and allow the oven to cycle for 2 hours or until no odor is detected before pushing the Power switch OFF. LIGHTING THE DGC AND HGC SERIES OVENS 1. Turn th
Résumé du contenu de la page N° 13
Cook & Hold (When Equipped) 1. Turn the oven ON. 2. Set the oven Cook Temperature to the desired setting. 3. Position the Function switch to C & H. 4. Set the Cook & Hold Time to the desired Cooking time. • The oven will roast the product for the chosen set time and temperature. The oven controller will automatically switch from the cooking thermostat to the holding thermostat at the end of the preset cooking time. In holding mode the oven will maintain a temperature of 160°F (71°C) until the ov
Résumé du contenu de la page N° 14
PROGRAMMABLE CONTROLS (Models HGC5D AND HGC5DX) Always displays [HR:Min] when setting the time. Displays [HR:Min] if the countdown time is more than 1 hour. Displays [Min:Sec] if the countdown time is less than 1 hour. Displays temperature in °F. C & H Indicates the oven is in the Cook & Hold Mode. C & H OVEN OVEN MODE MODE READY HEATING MENU SELECT PRIMARY OVEN Indicates the oven is preheated and ready for cooking. READY SECONDARY OVEN Indicates the oven is preheating or burners have cycled o
Résumé du contenu de la page N° 15
MANUALLY SETTING THE TEMPERATURE AND COOK TIME To Set the Temperature 1. Press the SET button. Press the TEMPERATURE button; StPt displays to indicate Setpoint. 2. Use the Up and Down arrow keys to increase or decrease the displayed temperature value. 3. Press the SET button again to save the temperature setpoint in the computer. To Set the Cook Time 1. Press the SET button. Press the TIME button. Tine displays to indicate time. 2. Use the Up and Down arrow keys to increase or decrease the displ
Résumé du contenu de la page N° 16
Always Set the Temperature Before Setting the Time 1. Open the door; door will display. 2. Place the desired product on any of the five racks. 3. Close the door. The display should return to the set temperature or the GROWING BAR. 4. Press the MENU key once for primary or twice for secondary to select a menu item cook time. 5. Press the START/STOP button. Pressing the START/STOP button after making a menu selection will time all racks for the selected menu time. 6. The timer will count down the
Résumé du contenu de la page N° 17
SETTING THE OVEN FOR COOK & HOLD 1. Press the COOK & HOLD button to select cook & hold. 2. Set the first stage temperature and the cook time as described in MANUALLY SETTING THE TEMPERATURE AND COOK TIME. Press START/STOP to begin cooking. 3. The hold temperature is preset by the computer control at 150°F (66°C). 4. The low fan speed is present during Cook & Hold. Use Cook & Hold to select low fan speed. COOK & HOLD OPERATION — (When Equipped) Cook & Hold roasts the product in two stages. Duri
Résumé du contenu de la page N° 18
RACK ARRANGEMENTS All models are supplied with five racks and have a maximum operating capacity of six racks per oven. The 11-position rack supports provide for maximum flexibility and proper rack spacing. The following arrangements are recommended. The position #11 numbers are in numerical sequence starting at the bottom #10 (Fig. 4). #9 #8 Arrangement #1 — Five racks in positions #2, #4, #6, #8 #7 and #10 are for cookies or reconstitution of frozen lunches #6 at maximum capacity. These are als
Résumé du contenu de la page N° 19
RECOMMENDED TEMPERATURES AND TIMES FOR ROASTING Meat roasting is most satisfactory at temperatures of 225 to 325°F (107 to 163°C) for beef, lamb, poultry and ham; 325°F (163°C) for fresh pork as recommended by USDA and American Meat Institute. A pan, approximately 12 x 20 x 1" (30.4 x 50.8 x 2.5 cm) full of water, may be placed in the oven bottom. This water supplies humidity to reduce shrinkage. Water should be added if necessary during roasting. 1 Roasting pans should be no deeper than necessa
Résumé du contenu de la page N° 20
RECOMMENDED TEMPERATURES, TIMES AND NUMBER OF RACKS FOR BAKING TEMP. TIME IN NO. OF PRODUCT °F (°C) MINUTES RACKS Cakes Sheet Cakes 18 x 26 x 1" (45.7 x 66.0 x 2.5 cm) pan 1 Scaled 4 /2 to 6 lb (2 to 2.7 kg)/pan 325-360 (163-182) 20 to 23 5 1 Scaled 6 to 7 /2 lb (2.7 to 3.4 kg)/pan 335-350 (168-177) 22 to 25 4 Sheet Cakes 18 x 26 x 2" (45.7 x 66 x 5 cm) pan 300-325 (149-163) 25 to 35 4 Scaled 10 to 12 lb (4.5-5.4 kg)/pan Or, two 12 x 18 x 2" (30.5 x 45.7 x 5 cm) pans 300-325 (149-163) 25 to 35
