Résumé du contenu de la page N° 1
Ovens Humidity with
FL-2267
Microprocessor Controls
5925 Heisley Road • Mentor, OH 44060-1833
Rev. 8 (1/05) Page 1 of 13
877/CRES COR (273-7267) • 440/350-1100
Fax: 440/350-7267 • www.crescor.com
INSTALLATION, OPERATION and MAINTENANCE
MANUAL for Cres Cor AQUA-TEMP HUMIDITY
CONVECTION and RETHERM OVENS with
MICROPROCESSOR CONTROLS
CO151FWUA12B CO151XWUA5B CO151FPWUA12B
RO151FWUA18B CO151HWUA6B RO151FPWUA18B
RO151FW1332B
Résumé du contenu de la page N° 2
Ovens Humidity with FL-2267 Microprocessor Controls 5925 Heisley Road • Mentor, OH 44060-1833 Rev. 8 (1/05) Page 2 of 13 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com TABLE OF CONTENTS SUBJECT PAGE INSTALLATION INSTRUCTIONS 3 OPERATING INSTRUCTIONS 4, 5 Illustration, Figure 1 4 MAINTENANCE INSTRUCTIONS How to Clean the Unit 6 Trouble Shooting Guide 7, 8 Replacement Parts 8, 9 Illustrations; Hot Unit 10 Wiring Diagrams (Single Phase) 11 (
Résumé du contenu de la page N° 3
Ovens Humidity with FL-2267 Microprocessor Controls 5925 Heisley Road • Mentor, OH 44060-1833 Rev. 8 (1/05) Page 3 of 13 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com INSTALLATION INSTRUCTIONS VENTING YOUR OVEN: 1. The purpose of ventilating hoods is to direct and 3. Most jurisdictions consider our low-temperature capture smoke, grease-laden vapors, heat, odors, or ovens (maximum temperature is 350°F/177°C) as fumes. low-heat appliances not req
Résumé du contenu de la page N° 4
Ovens Humidity with FL-2267 Microprocessor Controls 5925 Heisley Road • Mentor, OH 44060-1833 Rev. 8 (1/05) Page 4 of 13 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com OPERATING INSTRUCTIONS Figure 1: Control Panel HOW TO START UNIT: COOKING TEMPERATURE: (for first-time operation only) 1. Press the COOK button and the display will A new oven needs to “burn off” factory oils and show the cook/retherm temperature. glue before it’s first us
Résumé du contenu de la page N° 5
Ovens Humidity with FL-2267 Microprocessor Controls 5925 Heisley Road • Mentor, OH 44060-1833 Rev. 8 (1/05) Page 5 of 13 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com OPERATING INSTRUCTIONS, continued: HOW TO SET THE CONTROL, continued 6. Place the food into oven. Close door and FOR PROBE COOK OPERATION: double check cooking time and Press the SELECT button to choose the probe temperatures. Then press the START button mode. to start the cooking/rethe
Résumé du contenu de la page N° 6
Ovens Humidity with FL-2267 Microprocessor Controls 5925 Heisley Road • Mentor, OH 44060-1833 Rev. 8 (1/05) Page 6 of 13 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com OPERATING INSTRUCTIONS, continued HOW TO OPERATE WITH FOOD, continued HOW TO OPERATE WITH HUMIDITY: HOW TO SET HOLD-ONLY MODE: 1. Push power switch to “ON”. Air is VERY HOT when door is opened. 2. Press the STOP button and oven will switch Humidity control is on the right
Résumé du contenu de la page N° 7
Ovens Humidity with FL-2267 Microprocessor Controls 5925 Heisley Road • Mentor, OH 44060-1833 Rev. 8 (1/05) Page 7 of 13 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com MAINTENANCE INSTRUCTIONS HOW TO CLEAN THE UNIT: MAINTENANCE: CABINET MAINTENANCE: WATER PAN 1. Wipe the inside of cabinet after daily use. Drain, wipe and fill water pan daily. 2. Leave doors slightly open to fully dry (Clear vinyl drain-hose is provided). interior. 1. Push hose
Résumé du contenu de la page N° 8
Ovens Humidity with FL-2267 Microprocessor Controls 5925 Heisley Road • Mentor, OH 44060-1833 Rev. 8 (1/05) Page 8 of 13 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com MAINTENANCE INSTRUCTIONS TROUBLE-SHOOTING GUIDE If unit gets too hot or won’t shut off, disconnect power at branch panel. DO NOT UNPLUG CORD! If hot unit is NOT working, first check the following causes: 1. Cord is unplugged from wall outlet. 3. Switch is turned off. 2. Circuit brea
Résumé du contenu de la page N° 9
Ovens Humidity with FL-2267 Microprocessor Controls 5925 Heisley Road • Mentor, OH 44060-1833 Rev. 8 (1/05) Page 9 of 13 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com MAINTENANCE INSTRUCTIONS TROUBLE-SHOOTING GUIDE, continued HOW TO ADJUST THE DOOR LATCH: 1. For vertical (up and down movement) adjustment: a. Loosen (2) screws located in magnetic strike. b. Move strike up or down for alignment to magnet on latch. c. Tighten screws to se
Résumé du contenu de la page N° 10
Ovens Humidity with FL-2267 Microprocessor Controls 5925 Heisley Road • Mentor, OH 44060-1833 Rev. 8 (1/05) Page 10 of 13 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com REPLACEMENT PARTS: Include all information on nameplate when ordering parts. Figure 2: Control Panel Hot Unit Replacement Parts ITEM DESCRIPTION CMP Part No. ITEM DESCRIPTION CMP Part No. 1. Switch (On/Off) 0808-113-01 PARTS for 8200W, 1-PH UNITS 2. Microprocessor Contr
Résumé du contenu de la page N° 11
Ovens Humidity with FL-2267 Microprocessor Controls 5925 Heisley Road • Mentor, OH 44060-1833 Rev. 8 (1/05) Page 11 of 13 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com REPLACEMENT PARTS For “PASS-THRU” OVENS CO or RO151FPWUA SERIES: Include all information on nameplate when ordering parts. FIGURE 3; Hot Unit w/o top cover (For parts description, refer to page 10) FIGURE 4; Bottom of Hot Unit, Cover Removed (For parts description, r
Résumé du contenu de la page N° 12
Ovens Humidity with FL-2267 Microprocessor Controls 5925 Heisley Road • Mentor, OH 44060-1833 Rev. 8 (1/05) Page 12 of 13 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com REPLACEMENT PARTS For OVENS CO or RO151FPWUA SERIES: Include all information on nameplate when ordering parts. FIGURE 5; Hot Unit w/o top cover (For parts description, refer to page 10) FIGURE 6; Bottom of Hot Unit, Cover Removed (For parts description, refer to page
Résumé du contenu de la page N° 13
Ovens Humidity with FL-2267 Microprocessor Controls 5925 Heisley Road • Mentor, OH 44060-1833 Rev. 8 (1/05) Page 13 of 13 877/CRES COR (273-7267) • 440/350-1100 Fax: 440/350-7267 • www.crescor.com WIRING DIAGRAM
