Résumé du contenu de la page N° 1
User's Guide
Compaq S900 Color Monitor
1Intr_en.p65 1 9/23/98, 2:30 PM
Résumé du contenu de la page N° 2
Notice The information in this guide is subject to change without notice. COMPAQ COMPUTER CORPORATION SHALL NOT BE LIABLE FOR TECHNICAL OR EDITORIAL ERRORS OR OMISSIONS CONTAINED HEREIN; NOR FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE FURNISHING, PERFORMANCE, OR USE OF THIS MATERIAL. This guide contains information protected by copyright. No part of this guide may be photocopied or reproduced in any form without prior written consent from Compaq Computer Corporation. 1998 Compaq
Résumé du contenu de la page N° 3
English8188 ENGLISH - TABLE OF CONTENTS SAFETY INSTRUCTIONS ..................................................................................2 INTRODUCTION ................................................................................................4 Package Contents ................................................................................. 5 Installing or Removing the Tilt/Swivel Base ....................................... 5 Feature Highlights .......................................
Résumé du contenu de la page N° 4
SAFETY INSTRUCTIONS 1. Carefully read all of the instructions below and keep the manual for later use. 2. Please install the swivel base onto this product before using it. 3. The voltage ratings and the rated frequency are on the overlay centered at rear side of this product. Do not connect with any source of other voltage or frequency and please follow all warnings and instructions marked on the product. 4. Unplug this product from the wall outlet before cleaning and use a damp cloth to clean
Résumé du contenu de la page N° 5
English8388 SAFETY INSTRUCTIONS Usually a suitable power cord is provided by the manufacturer when this product is sold. However, this product is sometimes resold or transported to another area with a different power system and safety requirements; please pay attention to the selection of a suitable power cord. The plug on the power cord is intended to serve as the disconnect device; therefore, the socket-outlet should be installed near the equipment and should be easily accessible. 9. Do not al
Résumé du contenu de la page N° 6
INTRODUCTION Introduction The monitor is a multiple frequency high-resolution color monitor for PC-compatible or Macintosh family and workstation systems. The monitor is equipped with microprocessor-based intelligence and multiple frequency scanning capability, allowing it to provide maximum compatibility for various system platforms. The monitor uses the latest screen technology including a 0.22 mm horizontal dot pitch, High Contrast CRT to display crisp text and vivid color graphics with a max
Résumé du contenu de la page N° 7
English8588 USER'S MANUAL COMPAQ S900 MONITOR INTRODUCTION Package Contents The following lists all of the items included in the monitor package box. Please save the original box and packing materials for future transportation or shipment of the monitor. Front View User's Manual Rear View Power Cord Installing or Removing the Tilt/Swivel Base 1. Turn off the system and all attached peripherals. 2. Carefully set the monitor upside down. Installing the Tilt/Swivel Base: 1. Align the base with
Résumé du contenu de la page N° 8
INTRODUCTION Feature Highlights Maximum Compatibility • Automatically scans all horizontal frequencies between 30 kHz and 95 kHz, and all vertical frequencies between 50 Hz and 160 Hz. • Supports multiple operating platforms such as PC-compatible or Macintosh computers (with optional adapter). • Multiple graphic standards with high refresh rates: 640 x 480/85 Hz, 800 x 600/85 Hz, 1024 x 768/85 Hz, 1280 x 1024/85 Hz, 1600 x 1200/75 Hz. • Supports wide range of graphics standards including VGA, Su
Résumé du contenu de la page N° 9
English8788 INTRODUCTION Recommended Use of the Monitor When setting up and using the monitor, pay special attention to the following for optimum performance: • Do not use your monitor against a bright background or where sunlight or other light sources will shine directly on the screen. • The monitor should be placed just below eye level (10°-15°) for optimum viewing. • Set the monitor's brightness to match the ambient room light. • For optimum focus, the contrast control should not be set to t
Résumé du contenu de la page N° 10
CONTROLS AND ADJUSTMENTS Controls and Adjustments Once you have installed the monitor for your system, please read the instructions in this section which give you some guidelines on how to use the monitor more efficiently. It leads you through the various functions of the user controls and explains how to adjust the monitor to your personal preference. Front User Controls 44444 11 33333 55555 111 22222 1. MENU KEY Displays and selects the "Status," "Position," "Size," "Geometry," "Moire," "Colo
Résumé du contenu de la page N° 11
English8988 CONTROLS AND ADJUSTMENTS (1) Press the "MENU" key to open the On-Screen menu function. Seven adjustment functions will appear on the On-Screen menu. Press the "MENU" key to scroll selections from top-down sequence. Press "+," "–," " ," or " " to activate the preferred adjustments. Status Position Size Geometry Moire Color Language A . STATUS: 1. To display existing timing data of resolution and frequency. Status 2. To recall the factory settings of position,size and geometry. Positio
Résumé du contenu de la page N° 12
CONTROLS AND ADJUSTMENTS F. COLOR: 1. By pressing the " " key, you can select modes 1, 2, 3, or 4. Status Position 1 60 Size 2 70 The settings of modes 1,2 and 3 are fixed. Only mode 4 can be Geometry 3 60 Moire 4 adjusted by the user. Color 9300°K Language 2. To adjust the settings of mode 4, press the " " key to select of R/G/B gain contrast and the " + " key to increase or " – " to decrease its density. G . LANGUAGE: Status Press the " " or " " key to select between English, German,
Résumé du contenu de la page N° 13
English81188 CONTROLS AND ADJUSTMENTS Energy Declaration This monitor is equipped with a function for saving energy which supports the VESA Display Power Management Signaling (DPMS) standard. This means that the monitor must be connected to a computer which also supports the VESA DPMS standard to fulfill the requirements of the NUTEK specification 803299/94. The time settings for switching to a power saving mode are adjusted from the system unit by software. From the first indication of inactivi
Résumé du contenu de la page N° 14
TROUBLESHOOTING Troubleshooting Before calling the Compaq authorized service center, please check that the items below are properly connected or set. In case of using a nonstandard signal, please check the pin assignments and the signal timing of your adapter with the specifications in the section "Pin Assignment Table." 1. Screen is blank: • Check to see if the monitor is turned on. • Check to see if the signal cable and power cable are both connected properly. • The monitor may be in an energy
Résumé du contenu de la page N° 15
English81388 TECHNICAL INFORMATION Specifications Color Picture Tube 48.2 cm / 19" (18" viewable screen size) diagonal measurement, 90 degree deflection, High Contrast CRT, antiglare, antireflection, antistatic, medium short persistence phosphor, dark bulb Horizontal Dot Pitch 0.22 mm, High Contrast Input Signal Video: 0.7 Vp-p/75 ohm, analog positive Sync: Separate Sync.: TTL Level Horizontal Sync.: positive/negative Vertical Sync.: positive/negative Composite Sync.: TTL Level, positive/negativ
Résumé du contenu de la page N° 16
TECHNICAL INFORMATION Compatibility This color monitor supports multiple operating platforms such as PC-compatible and Macintosh family computers. This section provides you with detailed information on pin assignment of the D-Sub connector and the preset timing chart of the prevailing video standards. Pin Assignment 1 5 6 10 15 11 Male Mini D-15 Connector Signal 15 Pin Mini D-Sub Red Video 1 Green Video 2 Blue Video 3 Horizontal Sync 13 Vertical Sync 14 Ground 4,5,6,7,8,10,11 No Connection 9 SDA
Résumé du contenu de la page N° 17
appendix Agency Regulatory Notices Federal Communications Commission Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency en- ergy and, if not installed and used in accordance with the instruc- tions, may cause harmful interfere
Résumé du contenu de la page N° 18
Declaration of Conformity for products marked with the FCC logo - United States only This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. For questions regarding your product, contact: Compaq Computer Corporation P. O. Box 692000, Mail Stop 530113 Houston, Texas 77269-2000 Or
Résumé du contenu de la page N° 19
EPA ENERGY STAR Compliance Monitors that are marked with the ENERGY STAR Logo meet the re- quirements of the EPA ENERGY STAR program. As an ENERGY STAR Partner, Compaq Computer Corporation has determined that this product meets the ENERGY STAR guidelines for energy efficiency. Specific details on using the Energy Saving features can be found in the energy saver or power management section of the computer manual. European Notice Products with the CE Marking comply with both the EMC Directive (89/
