Instruction d'utilisation Valcom VIP-822

Résumé du contenu de la page N° 1

ISSUE 1
VIP-822
DUAL NETWORKED TRUNK PORT
INTRODUCTION
The VIP-822 Dual Networked Trunk Port allows
most loop start terminal devices to be connected to
a managed IP-based LAN/WAN.
SPECIFICATIONS
Access Methods
• PBX, FXS Port
Features
Nominal Power Requirements
• RJ-45 for network connection
Via back panel barrel connector:
• 2 RJ-11 FXO connections
Voltage: 24VDC
• 2 RJ-11 failover telephone connections
Current: 325mA
• Decode Caller ID signals
Via 802.3af PoE Ethernet Switch:
• Front panel

Résumé du contenu de la page N° 2

INSTALLATION Mounting NOTE: The telephone system referred to in this The VIP-822 is designed for wall, table or rack manual is the customer premise equipment mounting. such as an electronic key system, a PBX or a dedicated single line telephone sets. The Table: Provided with the VIP-822 are four rubber VIP-822 is not intended for direct or indirect stick on feet. Peel these feet off their carrier connection to the public telephone network. backing and place at the four corners of the bottom W

Résumé du contenu de la page N° 3

LINK: Indicates 100 Mbit Ethernet connection Signal Connections when illuminated. No activity indicates 10 Mbit Trunk Connections: connection. Connect standard analog telephones to the VIP-822 via the rear panel RJ-11 jacks labeled ACT: Indicator flashes to indicate network activity. Port 1 Line or Port 2 Line. Tip and Ring appear on pins 3 and 4 of these jacks. ED TECHNICAL ASSISTANCE Failover Telephone Connections: When trouble is reported, verify power is being Connect standard analog telep