Instruction d'utilisation Dell FE500-IA64 SYSTEMS

Résumé du contenu de la page N° 1

N5828bk1.book Page 1 Tuesday, June 15, 2004 4:50 PM
Dell™ PowerEdge™ Cluster
FE500-IA64 Systems
Platform Guide
www.dell.com | support.dell.com

Résumé du contenu de la page N° 2

N5828bk1.book Page 2 Tuesday, June 15, 2004 4:50 PM

Résumé du contenu de la page N° 3

N5828bk1.book Page 1 Tuesday, June 15, 2004 4:50 PM Dell™ PowerEdge™ Cluster FE500-IA64 Systems Platform Guide www.dell.com | support.dell.com

Résumé du contenu de la page N° 4

N5828bk1.book Page 2 Tuesday, June 15, 2004 4:50 PM Notes, Notices, and Cautions NOTE: A NOTE indicates important information that helps you make better use of your computer. NOTICE: A NOTICE indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. CAUTION: A CAUTION indicates a potential for property damage, personal injury, or death. COMMENT ____________________ Information in this document is subject to change without notice. © 2004 Dell In

Résumé du contenu de la page N° 5

N5828bk1.book Page 3 Tuesday, June 15, 2004 4:50 PM Contents Supported Cluster Configurations. . . . . . . . . . . . . . . . . . . . . . 5 High-Availability Cluster Configurations . . . . . . . . . . . . . . . . . . 6 Service Pack Support . . . . . . . . . . . . . . . . . . . . . . . . . 6 HBA Support for PowerEdge Cluster FE500W-IA64 Configurations . . . . 6 Fibre Channel Switches . . . . . . . . . . . . . . . . . . . . . . . . 6 Rules and Guidelines . . . . . . . . . . . . . . . . . .

Résumé du contenu de la page N° 6

N5828bk1.book Page 4 Tuesday, June 15, 2004 4:50 PM 4 Contents

Résumé du contenu de la page N° 7

N5828bk1.book Page 5 Tuesday, June 15, 2004 4:50 PM This document provides information for installing and connecting peripheral hardware, storage, and storage area network (SAN) components to your Dell™ PowerEdge™ Cluster FE500W-IA64 ® ® solution. The configuration information in this document is specific to the Microsoft Windows Server 2003, Enterprise Edition for 64-bit Itanium-based Systems operating system. This document covers the following topics:  Configuration information for ins

Résumé du contenu de la page N° 8

N5828bk1.book Page 6 Tuesday, June 15, 2004 4:50 PM High-Availability Cluster Configurations This section provides information about the supported operating systems, HBAs, and HBA drivers for your cluster configuration. NOTICE: All cluster nodes in a Cluster FE500W-IA64 solution must run the same operating system. NOTICE: HBAs must be identical if they are installed in clusters using redundant paths. Cluster configurations are tested and certified using identical HBAs installed in all of

Résumé du contenu de la page N° 9

N5828bk1.book Page 7 Tuesday, June 15, 2004 4:50 PM Rules and Guidelines When configuring your cluster, all cluster nodes must contain identical versions of the following:  Operating systems and service packs  Hardware drivers, firmware, or BIOS for the NICs, HBAs, and any other peripheral hardware components  Systems management software, such as Dell OpenManage™ systems management software ® and EMC Navisphere storage management software Maximum Distance Between Cluster Nodes Table 1-2

Résumé du contenu de la page N° 10

N5828bk1.book Page 8 Tuesday, June 15, 2004 4:50 PM Table 1-3. PCI Slot Assignments for PowerEdge Cluster Nodes PowerEdge PCI Buses/Segments HBA DRAC III RAID Controller System 7250 PCI-X bus 0: PCI slot 1 For dual HBA Install the new or Install the RAID through 3 are 64-bit, 100 MHz configurations, existing DRAC III controller in PCI install the HBAs in slot 1. slot 1, 2, 3, or 4. PCI-X bus 1: PCI slots 4 and 5 on separate 64-bit are 64-bit, 100 MHz; PCI slot 6 PCI buses to is 64-bit,

Résumé du contenu de la page N° 11

N5828bk1.book Page 9 Tuesday, June 15, 2004 4:50 PM Table 1-4. Direct-Attached Clusters Rules and Guidelines (continued) Rule/Guideline Description Dell | EMC CX700 2.06.700 or later; however, Access Logix™ Option 01.01.5 or later must be core software installed and enabled if two clusters or a mix of clustered and nonclustered hosts are direct-attached to the CX700. Additional software EMC Navisphere Agent 6.6 or later. application programs EMC Navisphere Manager 6.6 or later. ® EMC PowerP

Résumé du contenu de la page N° 12

N5828bk1.book Page 10 Tuesday, June 15, 2004 4:50 PM Table 1-5. SAN-Attached Clusters Rules and Guidelines (continued) Rule/Guideline Description Operating system Each cluster attached to the SAN must run Windows Server 2003, Enterprise Edition for 64-bit Itanium-based Systems. Dell | EMC CX300 core 2.06.300 (with Access Logix Option 01.01.5 or later installed and Access software Control enabled) or later. Dell | EMC CX500 core 2.06.500 (with Access Logix Option 01.01.5 or later installed a

Résumé du contenu de la page N° 13

N5828bk1.book Page 1 Tuesday, June 15, 2004 4:50 PM Printed in the U.S.A.