Instruction d'utilisation Peavey 5150

Résumé du contenu de la page N° 1

OPERATING GUID E

Résumé du contenu de la page N° 2

amount of overdrive/sustain you INPUTS 1 want for the LEAD channel. Then, The 5150’s input block features with the POST GAIN control adjust HIGH [l] and NORMAL [2] gain for overall volume. inputs. The HIGH gain input has 3 twice the gain of the NORMAL gain input and should be used RHYTHMPRE& POSTGAIN when maximum overdrive is The RHYTHM channel PRE [4] and desired. When both inputs are POST GAIN [12] operate in the used simultaneously, the 5150 same manner as the LEAD channel automatically switc

Résumé du contenu de la page N° 3

4 5 8 9 11 12, 13 14 I5 FRONT PANEL CRUNCH 1 0 HIGH NORMAL I PRE GAIN PRE GAIN HIGH POST GAIN POST GAIN RESONANCE PRESENCE GAIN GAIN 1 3 6 RESONANCE / PRESENCE FUSE GROUND SWITCH J4 2l? 22 Unique to the 5150, the A 5 amp fuse is located within the Three position, rocker-type switch RESONANCE [14] control can be cap of the fuseholder. It must be which, for most applications, should A set to boost the gain of the power replaced with the same type and be operated in the center (zero) 15 A’ amp in

Résumé du contenu de la page N° 4

17 18 27 28 BACK PANEL POWER ON ON 0 0 m STANDBY POWER PEAVE” ELECTRONICS PATENT 19 REMOTE FOOTS WITCH JACK sr SNAKER OUTPUT S 28 : f IMPiEDAUCE SELECTOR SW/TCH 26 ..* Provided for the connection of the ; 1. Paralleled VV’ output jacks for .,... . . I’.,, Use to select the appropriate supplied remote footswitch. When connecting speaker enclosure(s) to impedance of the speaker the footswitch is plugged into the the amplifier (minimum: 4 ohms). enclosure(s). If two enclosures of A remote footsw

Résumé du contenu de la page N° 5

Features and specifications subject to change without notice. 00 00 OHMS SPEAKER CONNECTION 00 1 0 0 SET SWITCH u make sure to set the impedance selector switch on the rear TO 4 OHMS When two enclosures of equal impedance are used, set the 00 OHMS 16 ohm enclosures: set switch to 8 ohms; two 8 ohm 00 BACK PANEL RACK MOUNT EFFECTS UNIT EFFECTS PATCHING USING THE EFFECTS FROM 5150 LOOP TO PATCH FROM OUTPUT OF EFFECTS SEND FROM OUTPUT OF EXTERNAL, NON ND EFFECTSPEDAL OUTPUT TO INPUT OF RACK EFFECT

Résumé du contenu de la page N° 6

EXPOSURE TO EXTREMELY HIGH NOISE LEVELS MAY CAUSE A PERMANENT HEARING LOSS INDIVIDUALS VARY CONSIDERABLY IN SUSCEPTIBILITY TO NOISE HEARING LOSS BUT NEARLY EVERYONE WILL LOSE SOME HEARING IF EXPOSED TO SUFFICIENTLY INTENSE NOISE FOR A SUFFICIENT TIME THE u S GOVERNMENT’S OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION (OSHA) HAS SPECIFIED THE FOLLOWING PE RMI SSIBLE NOISE LEVEL EXPOSURES DURATION PER DAY IN “OURS SOUND LEVEL SLOW RESPONSE 8 90 6 92 4 95 3 97 2 1 1 105 110 THIS LIMITED WARRANTY