Instruction d'utilisation Fostex CD-1A

Résumé du contenu de la page N° 1

Model CD-1A
(CD-RW drive for the VF160)
Installation Manual

Résumé du contenu de la page N° 2

Introduction The Model CD-1A is designed exclusively for the VF160 digital multitracker. By installing the CD-1A to the VF160, you can; * save or load your song data to or from a CD-R/CD-RW disc, * make your original audio CD using materials recorded on the VF160, or * load song data from an audio CD. This manual describes how to install the CD-1A in the VF160. See the VF160 operation manual for details about how to save/load song data or how to make an audio CD.

Résumé du contenu de la page N° 3

• If there is a dust, dirt or fingerprints on the • Do not use a cleaner for analog discs or disc, which may cause error in playback or antistatic spray, as well as volatile solvents recording, wipe the disc with a soft, dry cloth such as benzine, which may damage the disc or alcohol from the center out. surface. Never wipe from the outside to center. • Do not expose any disc to direct sunlight, or leave it in hot, moist or cold places. • Read the attached manual packed w

Résumé du contenu de la page N° 4

Use two screws supplied with the CD-1A to fix 3 Opening/closing the tray the CD-1A to the VF160 from the front panel. • To open the tray, press the eject switch lightly. Tighten the screws with a screwdriver. Pressing the switch will open the tray slightly. Then pull out the tray gently by hand to fully open it. screw position screw position Eject switch Use the screw you removed in step 1 to fix the 4 blank panel supplied with the CD-1A to the front panel. Slant the panel slightly when insertin

Résumé du contenu de la page N° 5

Placing/removing a disc The following are some notes on placing and/ or removing a disc. When placing a disc on the tray, support the tray from the bottom by your hand. If you push the disc to fit into the pivot on the tray without supporting the tray, the tray/drive may be dam- aged or broken. Also note that the disc must be pushed until it clicks so that it is locked into the pivot securely. Closing the tray without lock- ing the disc may damage the disc.

Résumé du contenu de la page N° 6

Declaration of EC Directive This equipment is compatible with the EMC Directive (89/336/EEC) - Directive on approximation of member nation's ordinance concerning the electromagnetic compatibility. This equipment is compatible only when connected to fostex specified product. The Affect of Immunity on This Equipment The affect of the European Specification EN50082-1 (coexistence of electromagnetic waves - common immunity specification) on this equipment are as shown below. In the electrical fast