Instruction d'utilisation Zenoah BC2310LE

Résumé du contenu de la page N° 1

848JL493A2 (704)
BRUSHCUTTERS
BC2310LE
BC2610LE/WE
OWNER’S MANUAL
BC3500LE/WE
BC4500WE
Thank you for purchasing a ZENOAH product.
BC530WE
Before using our brushcutter, please read this manual carefully
to understand the proper use of your unit.
1 Explanation of pictorials
(1) Read the owner's manual.
(2)Wear a helmet, ear protection and eye
protection.
(3) Warning / Attention
(4)Keep all children, bystanders and helpers
15 meters away from the brushcutter.
at least 3 meters away from fueli

Résumé du contenu de la page N° 2

• If you use a gasoline of a lower octane value ■ CONNECTING SWITCH WIRES than prescribed, there is a danger that the • Connect the switch wires between the 3 Setup engine temperature may rise and an engine engine and the main unit. problem such as piston seizing may ■ ENGINE consequently occur. ■ PROTECTOR A: BC2310LE/BC2610LE/WE • Unleaded gasoline is recommended to reduce • Wrap the protector around the outer pipe as 1. Loosen the bolts temporarily attached to the clutch the contamination

Résumé du contenu de la page N° 3

■ STOPPING THE ENGINE ■ LINE HEAD USAGE 1. Release the throttle lever. 5 Use WARNING 2. Move the engine switch to the "O" position. 1. Always wear eye protection such as ■ STARTING THE ENGINE safety goggles. Never lean over the rotating cutting head. Rocks or other Take care that the cutting head will start debris could be thrown into eyes and rotating upon the engine starts. face and cause serious personal injury. BC2610WE 2. Keep the debris guard attached in place BC3500WE A: EXCEPT BC530

Résumé du contenu de la page N° 4

Make sure that the spring and the washers ■ AIR FILTER are in place. •A clogged air filter will reduce the engine 6. While holding the spool against the housing, performance. Check periodically and clean pull the line ends to release them from the the filter element in warm, soapy water as slot. required. Dry completely before installing. If 7. Line up the slot on the bottom cap with the the element is broken or shrunk, replace Model Type of Plug Spark Gap hook on the housing, press the