Instruction d'utilisation System Sensor FTX-P1

Résumé du contenu de la page N° 1

INSTALLATION AND MAINTENANCE INSTRUCTIONS
®
FTX-P1 Filtrex Intelligent
A Division of Pittway
3825 Ohio Avenue, St. Charles, Illinois 60174
Photoelectronic Smoke Detector
1-800-SENSOR2, FAX: 630-377-6495
Specifications
Operating Voltage Range: 15 to 32 VDC
Detector Current: 230 µ A @ 24 VDC (without communication)
285 µ A @ 24 VDC (one communication every 5 sec. with LED enabled)
Auxiliary Power Supply Voltage: 15 to 30 VDC filtered; Ripple voltage may not drop below 15 volts.
Auxilary Power Su

Résumé du contenu de la page N° 2

1(+) 2(–) 3(RA) 4(S) 1(+) 2(–) 3(RA) 4(S) Figure 1. Wiring diagram: + – AUX. POWER + SUPPLY – Wiring Instructions Testing All wiring must be installed in compliance with the Na- Before testing, notify the proper authorities that the system tional Electrical Code, applicable local codes, and any spe- is undergoing maintenance, and will temporarily be out of cial requirements of the Authority Having Jurisdiction. service. Disable the system to prevent unwanted alarms. Proper wire gauges should be

Résumé du contenu de la page N° 3

Figure 2. Rotary decade address switches: the detector still fails any test, have its filter replaced (see in- structions below) and retested. Finally, if the detector contin- ues to fail after replacing the filter, it must be returned for 4 5 4 5 repair or replacement. 3 3 6 6 When testing is complete, restore the system to normal op- eration and notify the proper authorities that the system is 2 7 2 7 back in operation. 8 Cleaning 8 1 1 The unique design of Filtrex eliminates the need for typi

Résumé du contenu de la page N° 4

If a clogged filter was the cause of the trouble condition, Figure 5: Installing Filtrex detector into base: normal detector operation should resume automatically within five minutes. If the trouble condition persists, the detector must be returned for repair or replacement. Installing Filtrex Into Base 1. Align the detector at a right angle to the base, with the five wires and connector adjacent to the connector re- ceptacle as shown in Figure 5. 2. Plug the wired connector into the receptacle.