Instruction d'utilisation Spin Master Air Hogs RC Gyro Havoc

Résumé du contenu de la page N° 1

® TM
INSTRUCTIONS
Check to make sure contents are complete:
®
• 1 Air Hogs Gyro Havoc™ • 1 Wind Ribbon
• 1 Charger/Controller • 1 Instruction Sheet
Antenna
Rotors
Charge
LED
ON/OFF/CHARGE
Switch
Vertical Power
Tail Wing LED
Throttle
Propeller
Left/Right
Toggle
Wing
Fuselage
Charge Door
Propeller
Steering
(to access Charge Nozzle)
Trim Knob
TM
Gyro Havoc Charger/Controller
®
Experience radio-controlled flight with the Air Hogs RC Gyro Havoc™! The Gyro Havoc™ is half airplane and half helicopte

Résumé du contenu de la page N° 2

CHARGING YOUR GYROCOPTER Important Charging Information: • Before taking your initial flight, charge the Gyro Havoc™ for a complete charge cycle on your charger. • Depending upon the length of future play, you will not need to complete a full charge before each flight. NOTE: A shortened charge results in a shorter play time (may take up to 1/2 hour to fully charge). 1. Push the aircraft’s 2. Set the 1 2 ON/OFF switch to charger/ the left to set the controller aircraft to OFF. switch to OFF. 4. P

Résumé du contenu de la page N° 3

CONTROLLING AIRCRAFT FLIGHT Charger/Controller NOTE: The Gyrocopter’s rotors are not powered Throttle (Helicopters have powered rotors) – the rotors spin due to interaction with the air as the Gyrocopter moves. To increase the height or gain altitude, increase throttle (left stick). LEFT TURN RIGHT TURN Tap or pulse the steering stick (right Tap or pulse the steering stick (right stick) to the left, this will result in a stick) to the right, this will result in a gentle turn, for a steep turn, h

Résumé du contenu de la page N° 4

TROUBLESHOOTING GUIDE PROBLEM CAUSE SOLUTION Aircraft will not start or 1. Aircraft not charged. 1. Charge aircraft for a complete charge cycle. has low power. 2. Battery power is drained. 2. Replace the charger/controller batteries after 20 flights. 3. Aircraft was not set to OFF during 3. The aircraft won’t accept a charge in the ON position. Always charging. set to “OFF” before charging. 4. Charger/controller was not set to 4. The charger/controller will NOT charge in the “Control ON” “Charge