Instruction d'utilisation Russell Hobbs OPTI-ROVE SW-B-USBOR

Résumé du contenu de la page N° 1

instructions

Résumé du contenu de la page N° 2

Read the instructions and keep them safe. If you pass the iron on, pass on the instructions too. Remove all packaging, but keep it till you know the iron works. important safeguards Follow basic safety precautions, including: 1 This appliance must only be used by or under the supervision of a responsible adult. 2 Don’t put the appliance in liquid, don’t use it in a bathroom, near water, or outdoors. 3 Route the cable so it doesn’t overhang, and can’t be tripped over or caught. 4 Don’t iron clo

Résumé du contenu de la page N° 3

13 Unplug the appliance when not in use, before moving and before cleaning. Let it cool down fully before cleaning and storing away. 14 Don’t fit any attachment or accessory other than those we supply. 15 Keep the iron and the cable away from hotplates, hobs or burners. 16 Don’t use the iron for any purpose other than those described in these instructions. 17 Take care not to scratch the soleplate – avoid buttons, zips, etc. 18 The iron has a protective thermal fuse, which will blow if it overhe

Résumé du contenu de la page N° 4

power up 17 Set the iron upright, with the rests at either side of the rear of the iron, and the end of the handle, on a stable, level, heat- resistant surface, preferably an ironing board 18 Put the plug into the wall socket (switch the socket on, if it’s switchable). temperature setting guide 19 Turn the temperature control to bring the setting you want next to the mark. , If you want to use steam, you must set the temperature to S or higher, or you’ll just get water. 20 The ready light wi

Résumé du contenu de la page N° 5

after use 32 Turn the temperature control to •. 33 Turn the steam control to S. 34 Unplug the iron from the wall socket (switch the socket off first, if it’s switchable). 33 Sit it upright, and leave it to cool down completely. 34 When it’s cool, turn the iron upside down over a sink or basin, and empty the reservoir. 35 Wipe off any excess moisture. care and maintenance cleaning 36 Wipe outer surfaces with a damp cloth. If necessary, use a little washing-up liquid. 37 Remove spots from the solepl

Résumé du contenu de la page N° 6

6

Résumé du contenu de la page N° 7

7

Résumé du contenu de la page N° 8

connection The product must be earthed. It has a 13A BS1362 fuse in a 13A BS1363 plug. To replace the plug, fit the green/yellow wire to E or E, the blue wire to N, and the brown wire to L. Fit the cord grip. If in doubt, call an electrician. Don’t use a non-rewireable/moulded plug unless the fuse cover is in place. If you remove the plug, dispose of it. service If you ring Customer Service, please have the Model No to hand, as we won’t be able to help you without it. It’s on the rating plate