Résumé du contenu de la page N° 1
OWNER’S MANUAL
Read and understand this entire manual before riding!
DO NOT RETURN TO STORE!
NOTE: Manual illustrations are for demonstration purposes only.
Illustrations may not reflect exact appearance of actual product.
Specifications subject to change without notice.
Please have your 19 digit product I.D. code ready before contacting Razor for
warranty assistance and/or replacement parts.
Product I.D. Code: _____________ - ____________ - ____________
v1_07_12
Résumé du contenu de la page N° 2
CONTENTS Safety Warnings ...............................................................1 Repair and Maintenance ................................................6-8 Before You Begin ..............................................................2 Troubleshooting Guide ......................................................9 Assembly and Set-Up/Usage .........................................3-4 Electric Scooter Parts .....................................................10 Charging Battery/Pre-Rid
Résumé du contenu de la page N° 3
BEFORE YOU BEGIN Remove contents from box. Remove the foam separators that protect the components from damage during WARNING: shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have DO NOT USE NON-RAZOR occurred during shipping. Because the scooter is 95 percent assembled and packed at the factory, there PARTS WITH YOUR RAZOR should not be any problems, even if the box has a few scars or dents. ELECTRIC SCOOTER. The scooter has be
Résumé du contenu de la page N° 4
ASSEMBLY AND SET-UP Note: Make sure the cables/ wires are out of the way before q Attaching the Handlebars inserting the stem in the fork. Tools required: 5 mm Allen wrench. WARNING: Failure to properly tighten the collar clamp may allow the handlebars to dislodge while riding and may cause you to lose control and fall. When correctly tightened, the handlebars will not rotate out of alignment with the front wheel under normal circumstances. Note: The cable and wire assembly fro
Résumé du contenu de la page N° 5
ASSEMBLY AND SET-UP q Attaching the Seat (E300S Only) Tools required: Two (2) 4 mm Allen wrenches and Phillips screwdriver. 2 Remove the four screws on 1 Attach the seat to the seat 3 Place the seat post on the the middle of the deck with the post with two (2) 4 mm Allen deck and secure using the same 4 mm Allen wrench and the wrenches. See note below. 4 screws. Phillips screwdriver. Note: Do not completely tighten at this time. Adjust the seat tilt approximately level to the ground, or
Résumé du contenu de la page N° 6
CHARGING BATTERY WARNING: q Charging the Battery Rechargeable batteries are Charge the battery prior to use. only to be charged under adult supervision. Always disconnect • Initial charge time: 12 hours • To ensure long battery life, never store the product your scooter from the charger in freezing or below freezing temperatures! • Recharge time: up to 12 hours, even if the light before cleaning with damp cloth. Freezing will permanently damage the battery. turns green. R
Résumé du contenu de la page N° 7
REPAIR AND MAINTENANCE Turn power switch “OFF” before beginning repair or maintenance: WARNING: The brake is capable of skidding • Read the instructions • Secure the unit under repair • Contact Razor customer the rear tire and throwing an • Remove Charger Plug • Exercise caution around service if unsure about unsuspecting rider. Practice • Turn the power switch off exposed parts any repair or maintenance in an open area free from obstacles until you are familiar q Adjust
Résumé du contenu de la page N° 8
REPAIR AND MAINTENANCE Cable Guide Reassembly Bracket Nut Frame Washer Bolt Washer Brake Plate 5 Install the chain onto the rear 6 Verify chain is properly 7 Install the cable guide wheel sprocket. Slip wheel axle installed on each sprocket and bracket to the frame and brake E300 into the frame slots. See rear wheel tensioner is correctly positioned plate using bolt, washers, and hardware sequence on prior page. at the bottom of the chain. nut. Do not tighten. Push the chain tensioner do
Résumé du contenu de la page N° 9
REPAIR AND MAINTENANCE WARNING: If a battery q Battery Care and Disposal leak develops, avoid any contact Do not store in freezing or below freezing temperatures. To properly maintain your battery and ensure maximum battery with leaking acid and place the life, carefully read the “Charging the Battery” section on page 5 of this owner’s manual. damaged battery in a plastic bag. Refer to the disposal instructions at CONTAINS SEALED LEAD ACID BATTERIES. BATTERIES MUS
Résumé du contenu de la page N° 10
*Unit(s) should be turned off and fully charged prior to doing any Troubleshooting NOTE: All troubleshooting steps should be performed by an adult only TROUBLESHOOTING GUIDE Problem Possible Cause Solution Does Not Work Out Of The Box Loose connection(s) Check for loose connections/wires No Longer Works Loose connection(s) Check for loose connections/wires Check power to wall outlet and/or try a different outlet Charger not working Check lights on charger: Plugged into wall = Green Plugged i
Résumé du contenu de la page N° 11
E300 / E300S SCOOTER PARTS Keep your scooter running for years with genuine Razor parts. Visit our website or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) 1 Handlebar Grip (right/left) 8 Front Fork 17 Rear Wheel Complete (See page 6 for hardware sequence) 1-1 Handlebar End Cap 9 Front Wheel Complete (See page 7 for hardware sequence) 18 Chain Tensioner 1-2 Valve Extender 10 Control Module 19 Chain 2 Single Speed Twist Grip Th
Résumé du contenu de la page N° 12
SB 1918 (CALIFORNIA) DECLARATION YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC RIDE-ON PRODUCT. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT. 11
Résumé du contenu de la page N° 13
WARRANTY Razor does not offer an extended warranty. If you have purchased an Razor Limited Warranty extended warranty, it must be honored by the store at which it was The manufacturer warranties this product to be free of manufacturing defects purchased. for a period of 90 days from date of purchase. This Limited Warranty does not cover normal wear and tear, tires, tubes or cables, or any damage, failure For your records, save your original sales receipt with this manual and write or los