Instruction d'utilisation Razor Powerwing

Résumé du contenu de la page N° 1

Owner’s Manu
Read and understand this entire manual before riding!
For assistance contact Razor®. DO NOT RETURN TO STORE.
NOTE: Manual illustrations are for demonstration purposes only.
Illustrations may not reflect exact appearance of actual product.
Specifications subject to change without notice.
Item Number:
Black 20036090
Silver 20036011
DLX 20036099
Version_1_01_10
al

Résumé du contenu de la page N° 2

CONTENTS Safety Warnings ............................................................ 1 PowerWing™ Parts ....................................................... 5 Before You Begin ........................................................... 2 Warranty ........................................................................ 6 Set-Up and Usage ....................................................... 3-4 SaFETy WaRNINgS AN IMPORTANT MESSAGE TO PARENTS: This manual contains ACCEPTABLE RI

Résumé du contenu de la page N° 3

BEFORE yOU BEgIN Remove contents from box and check parts against part diagram below. Remove the foam separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked WaRNINg: DO cables that may have occurred during shipping. Because the PowerWing™ is partially assembled and packed at the NOT USE NON-RAZOR factory, there should not be any problems, even if the box has a few scars or dents. PRODUCTS WITH YOU

Résumé du contenu de la page N° 4

SET-Up aND USagE q attaching the Foot platforms 1 Remove black plastic protector 2 Remove black plastic protector 3 Insert the two coupling bolts at the end of the frame. Using two at the end of the platform. Position and two hexagonal bolts. Starting 5mm hexagonal wrenches, remove the right and left foot platforms up underneath with the bolt on the the two hexagonal bolts and the to the frame and align holes. back. Turn product over and insert two coupling bolts from the frame. the next se

Résumé du contenu de la page N° 5

SET-Up aND USagE q attaching the Handlebars WaRNINg: Failure to properly tighten the wedge may allow the handlebars to dislodge while riding and may cause you to lose control and fall. When correctly tightened, the handlebars will not rotate out of alignment with the front wheel under normal circumstances. 1 Remove the plastic protector 3 Slide the handlebar stem 2 Insert the handlebar stem into covering the wedge and loosen the the front fork. You may have to down into the fro

Résumé du contenu de la page N° 6

pOWERWINg p aRTS Keep your PowerWing™ running for years with genuine Razor parts. Visit our web site www.razor.com to purchase replacement parts. (Specifications subject to change without notice.) 1 Handlebar Stem 8 120mm Front Wheel 10 - 1 Brake Cable Adjust Screw 13 Foot Platform (Right/Left) 2 Handlebar Grip (2) 8 - 1 Washer (Front Wheel) 10 - 2 Brake Spring 14 Platform Cover (Right/Left) 3 Brake Lever Assembly 8 - 2 608zz Bearing

Résumé du contenu de la page N° 7

SaFETy REMINDERS pRE-RIDE CHECKLIST Loose parts Frame, Fork and Handlebars Check and secure all fasteners before every ride. Make sure the Check for cracks or broken connections. Although broken frames q q steering bolts and foot steppers are tight. There should not be any are rare, it is possible for an aggressive rider to run into a curb unusual rattles or sounds from loose parts or broken components. or wall and wreck and bend or break a frame. Get in the habit of If you are not sure, as