Instruction d'utilisation Roberts Radio CR980

Résumé du contenu de la page N° 1

CR980
3 Band Dual Alarm
Clock Radio
Please read this manual before use
CR980 Instruction Book.pm6 1 24/10/99, 13:42
ROBERTS
Sound for Generations

Résumé du contenu de la page N° 2

Controls 3 5 7 2 4 6 8 1 11 10 9 7. Battery compartment (on rear) 1. Function switch 8. Volume control 2. Alarm switch 9. Tuning control 3. Time/Alarm off button 10. Alarm button 4. Fast set button 11. Snooze button 5. Slow set button 6. Sleep button If you need any further advice, please call our Technical Helpline on 2 0181 758 0338 (Mon-Fri) CR980 Instruction Book.pm6 2 24/10/99, 13:42

Résumé du contenu de la page N° 3

Controls 14 16 12 13 15 17 18 12. Auto dimmer 13. PM indicator 14. Alarm 1 indicator 15. Clock display 16. Alarm 2 indicator 17. Tuning scale 18. Waveband switch (on end) 3 CR980 Instruction Book.pm6 3 24/10/99, 13:42

Résumé du contenu de la page N° 4

General Fuse Do not allow this unit to be exposed to water or steam. Do not leave the This apparatus must be protected by a 3A fuse (BS1362) in a 13A plug unit where excessive heat could cause damage. It is recommended that (BS1363). If another type of plug is used a 5A fuse should be fitted in the the FM band be used wherever possible as better results in terms of plug, adaptor or distribution board. quality and freedom from interference will usually be obtained than on the IF IN DOUBT - CONSU

Résumé du contenu de la page N° 5

Operating the Radio Quick on/off feature The radio is equipped with three wavebands to enable you to select the The Sleep and Time/Alarm off button can be used together as a programme of your choice. The FM waveband requires the use of an convenient way to turn the radio on and off when it is required to operate external aerial wire which can be found at the rear of the unit. for a short period of less than one hour. This should be uncoiled and positioned for the best reception. The MW Alarm ti

Résumé du contenu de la page N° 6

If an alarm time has not been set and the Function switch is left in the Dual alarm 'Buzz' or 'Auto' position, the alarm/radio will operate at 12.00 midnight. If you require the alarm to operate at two different times on one day, first If you do not require the alarm function, ensure that the Function switch position the Alarm switch to 'AL1' and set the required alarm time. Then is correctly set to the 'Off' position. The display alarm indicators will be move the Alarm switch to 'AL2' and set t

Résumé du contenu de la page N° 7

Clock Specifications Power Requirements Battery back-up Mains AC 230 volts, 50Hz only 12 Hr AM/PM display Back-up Battery IEC size 6LR61 (PP3) Wake to buzzer or radio alarms 7 minute snooze function Radio 59 minute Sleep timer Waveband coverage FM 88 - 108 MHz LW 150 - 260 kHz MW 540 - 1600 kHz Imported by:- ROBERTS RADIO LIMITED PO BOX 130 MEXBOROUGH SOUTH YORKSHIRE S64 8YT The Company reserves the right to amend the specification without notice. 7 CR980 Instruction Book.pm6 7 24/10/99, 13:42

Résumé du contenu de la page N° 8

Guarantee This instrument is guaranteed for twelve months from the date of delivery to the original owner against failure due to faulty workmanship or component breakdown, subject to the procedure stated below. Should any component or part fail during this guarantee period it will be repaired or replaced free of charge. The guarantee does not cover: 1. Damage resulting from incorrect use. 2. Consequential damage. 3. Receivers with removed or defaced serial numbers. Procedure: Any claim under thi