Résumé du contenu de la page N° 1
OPERATOR’S MANUAL
VAC ATTACK II
UT08042 and UT08542
Your blower has been engineered and manufactured to Homelite’s high standard for dependability, ease of operation, and
operator safety. When properly cared for, it will give you years of rugged, trouble-free performance.
WARNING: To reduce the risk of injury, the user must read and understand the operator’s manual before using
this product.
Thank you for buying a Homelite product.
SAVE THIS MANUAL FOR FUTURE REFERENCE
Résumé du contenu de la page N° 2
TABLE OF CONTENTS n Introduction ..................................................................................................................................................................... 2 n � General Safety Rules....................................................................................................................................................... 3 �n Specific Safety Rules.................................................................................................
Résumé du contenu de la page N° 3
GENERAL SAFETY RULES n Never operate the unit without a spark arrestor screen; WARNING: this screen is located inside the muffler. n � Product users on United States Forest Service land, and READ AND UNDERSTAND ALL INSTRUCTIONS. in some states, must comply with fire prevention regula- Failure to follow all instructions listed below, may result tions. in electric shock, fire and/or serious personal injury. n This product is equipped with a spark arrestor; however, other user requirements may
Résumé du contenu de la page N° 4
SPECIFIC SAFETY RULES n Do not operate vacuum without vacuum bag installed; n � Do not point the blower nozzle in the direction of people flying debris could cause serious injury. Always close or pets. vacuum bag completely before operating. �n Never run the unit without the proper equipment �n Always hold the blower in your right hand, refer to the attached. “Operation Instructions,” later in this manual for additional n When used as a blower, always install the blower tubes. information. W
Résumé du contenu de la page N° 5
SYMBOLS Some of the following symbols may be used on this tool. Please study them and learn their meaning. Proper interpre- tation of these symbols will allow you to operate the tool better and safer. SYMBOL NAME DESIGNATION/EXPLANATION Safety Alert Precautions that involve your safety. To reduce the risk of injury, user must read and understand Read The Operator’s Manual operator’s manual before using this product. Eye and Hearing Protection Wear eye and hearing protection when operating this
Résumé du contenu de la page N° 6
SYMBOLS The following signal words and meanings are intended to explain the levels of risk associated with this product. SYMBOL SIGNAL MEANING DANGER: Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury. WARNING: Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury. CAUTION: Indicates a potentially hazardous situation, which, if not avoided, may result in minor or moderate injury.
Résumé du contenu de la page N° 7
FEATURES PRODUCT SPECIFICATIONS Weight ......................................................................................................................................................................... 9.8 lbs. Engine displacement.......................................................................................................................................................30cc Air Velocity: MPH.........................................................................................
Résumé du contenu de la page N° 8
FEATURES TUBE CLAMP VACUUM BAG SHOULDER STRAP UPPER VACUUM TUBE LOWER VACUUM TUBE VACUUM BAG ADAPTOR ENGINE SWITCH VACUUM BAG STARTER GRIP PRIMER BULB LOWER HANDLE CHOKE LEVER Fig. 2 THROTTLE TRIGGER KNOW YOUR BLOWER See Figures 1 - 2. The blower can be operated at any speed between idle and full throttle. Before attempting to use this product, familiarize yourself with all operating features and safety rules. VACUUM BLOWER TUBE AND NOZZLE The blower will convert to a powerful vacuum/mulc
Résumé du contenu de la page N° 9
ASSEMBLY UNPACKING WARNING: This product requires assembly. n Carefully remove the tool and any accessories from the If any parts are missing do not operate this tool until the box. Make sure that all items listed in the packing list are missing parts are replaced. Failure to do so could result included. in possible serious personal injury. n Inspect the tool carefully to make sure no breakage or damage occurred during shipping. WARNING: n Do not discard the packing material until you have
Résumé du contenu de la page N° 10
ASSEMBLY WARNING: Stop the engine and disconnect the spark plug wire before installing parts, making adjustments, cleaning, or when not in use. Failure to do so could result in possible serious personal injury. UPPER NOZZLE KNOB BLOWER TUBE ASSEMBLING THE BLOWER TUBES Fig. 3 See Figure 3. n Screw the nozzle onto the upper blower tube and tighten ADAPTOR securely. Check tightness after initial run and retighten if needed. n Place clamp around the neck of the blower housing outlet. Do not t
Résumé du contenu de la page N° 11
ASSEMBLY WARNING: INLET COVER DOOR Stop the engine and disconnect the spark plug wire before installing parts, making adjustments, cleaning, or when not in use. Failure to do so could result in possible serious personal injury. INSTALLING THE VACUUM TUBES See Figures 6 - 7. To install the vacuum tubes: DOOR KNOB n Screw the upper and lower vacuum tubes together and tighten securely. Fig. 6 n Loosen the door knob on the inlet cover door and open. Place the notch in the support arm of the up
Résumé du contenu de la page N° 12
OPERATION FILLING THE TANK WARNING: WARNING: Do not allow familiarity with tools to make you care- less. Remember that a careless fraction of a second is Always stop the engine before filling the fuel tank. Never sufficient to inflict serious injury. add fuel to a machine with a running or hot engine. Move at least 30 ft. from the refueling area before starting engine. Do not smoke while filling the tank. WARNING: n � Clean the surface around the fuel cap to prevent con- Always wear safety go
Résumé du contenu de la page N° 13
OPERATION STARTING AND STOPPING THROTTLE See Figure 8. TRIGGER Starting the product differs depending on whether the engine is cold or warm. TO START A COLD ENGINE: PRIMER BULB n Place the blower on a flat, bare surface. n Make sure cruise control is locked in the IDLE position. Do not engage the throttle trigger or cruise control during the start-up process. n Push the primer bulb, slowly, 7 times. n Move the choke lever to the full choke position marked START. n Pull the starter rope unt
Résumé du contenu de la page N° 14
OPERATION �n Operate blower at the lowest possible throttle speed to WIDE SWEEPER do the job. NOZZLE ��n Check your equipment before operation, especially the muffler, air intakes and air filters. ��n Use rakes and brooms to loosen debris before blowing. ��n In dusty conditions, slightly dampen surfaces when water is available. n �� Conserve water by using power blowers instead of hoses HIGH VELOCITY for many lawn and garden applications, including areas NOZZLE such as gutters, screens, p
Résumé du contenu de la page N° 15
OPERATION n Hold the engine higher than the inlet end of the vacuum tube. n Always point vacuum tube downhill when working on a hillside. �n To avoid injury to the operator or unit, do not pick up rocks, broken glass, bottles, or other similar objects. n � If the vacuum tubes should clog, stop the engine and disconnect the spark plug wire before cleaning out the obstruction. n Remove the vacuum tubes and clear the debris from the blower fan housing. Remove the bag and clear the tube. A sm
Résumé du contenu de la page N° 16
MAINTENANCE REPLACING AND CLEANING THE AIR FILTER WARNING: See Figure 14. For proper performance and long life, keep air filter clean. When servicing, use only identical Homelite replacement parts. Use of any other parts may create a hazard or n Push down on the latch of the air filter cover; carefully cause product damage. pull the top of the air filter cover so it pivots away from the base. n Remove the air filter and clean it in warm soapy water. WARNING: Rinse and let dry completely. A
Résumé du contenu de la page N° 17
MAINTENANCE The fuel cap contains a non-serviceable filter and a check SPARK ARRESTOR valve. A clogged fuel filter will cause poor engine performance. The muffler is equipped with a spark arrestor screen inside If performance improves when the fuel cap is loosened, the muffler body. After extended use the screen can become check valve may be faulty or filter clogged. Replace the fuel dirty and you may need to have the muffler replaced by an cap if required. authorized servicing dealer. SP
Résumé du contenu de la page N° 18
TROUBLESHOOTING IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICING DEALER. PROBLEM POSSIBLE CAUSE SOLUTION Engine will not start. 1. No spark. 1. Check spark. Remove spark plug. Reattach the spark plug cap and lay spark plug on metal cylinder. Pull the starter rope and watch for spark at spark plug tip. If there is no spark, repeat test with a new spark plug. 2. No fuel. 2. Push primer bulb until fuel is visible in the bulb. If fuel is not apparent, the primary fue
Résumé du contenu de la page N° 19
WARRANTY LIMITED WARRANTY STATEMENT In addition, this warranty does not cover: Homelite Consumer Products, Inc. warrants to the original A. Tune-ups – Spark Plugs, Carburetor, Carburetor retail purchaser that this HOMELITE product is free from Adjustments, Ignition, Filters defect in material and workmanship and agrees to repair or B. Wear items – Bump Knobs, Outer Spools, Cutting Lines, replace, at Homelite Consumer Products, Inc.’s discretion, Inner Reels, Starter Pulleys, Starter Ropes, D
Résumé du contenu de la page N° 20
WARRANTY THE FOLLOWING CALIFORNIA AIR RESOURCES BOARD (CARB) STATEMENT ONLY APPLIES TO MODEL NUMBERS REQUIRED TO MEET THE CARB REQUIREMENTS. HOMELITE CONSUMER PRODUCTS, INC., LIMITED WARRANTY FEDERAL AND CALIFORNIA EMISSION CONTROL SYSTEMS NONROAD AND SMALL OFF-ROAD ENGINES The U.S. Environmental Protection Agency (EPA), the California Air Resources Board (CARB), and Homelite Consumer Products, Inc., are pleased to explain the Emission Control System Warranty on your nonroad or small off-road
