Résumé du contenu de la page N° 1
Henny Penny
Humidified Counter Warmer
Model HCW-2
Model HCS-2
Model HCW-3
Model HCW-5
Model HCS-5
Model HCW-8
OPERATOR’S MANUAL
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
Model HCS-2/HCW-3/HCW-5/HCW-8 LIMITED WARRANTY FOR HENNY PENNY EQUIPMENT Subject to the following conditions, Henny Penny Corporation makes the following limited warranties to the original purchaser only for Henny Penny appliances and replacement parts: NEW EQUIPMENT: Any part of a new appliance, except baskets, lamps, and fuses, which proves to be defective in material or workmanship within two (2) years from date of original installation, will be repaired or replaced without charge F.O.B.
Résumé du contenu de la page N° 4
Model HCS-2/HCW-3/HCW-5/HCW-8 TABLE OF CONTENTS Section Page Section 1. INTRODUCTION ....................................................................................................... 1-1 1-1. Heated Display Cabinet ....................................................................................... 1-1 1-2. Features .............................................................................................................. 1-1 1-3. Proper Care ........................................
Résumé du contenu de la page N° 5
Model HCS-2/HCW-3/HCW-5/HCW-8 SECTION 1. INTRODUCTION 1-1. HEATED DISPLAY The Henny Penny Heated Display Cabinet is a basic unit of food CABINET processing equipment used to display the food product and maintain the temperature of hot foods in the commercial food service operation. This highly efficient, quality-built cabinet will keep hot foods at proper holding temperatures with controlled humidity. The Henny Penny Heated Display Cabinets have see-thru doors which allow viewing and access to
Résumé du contenu de la page N° 6
Model HCS-2/HCW-3/HCW-5/HCW-8 1-5. SAFETY The only way to ensure safe operation of the Henny Penny Heated Display Cabinet is to fully understand the proper installation, operation, and maintenance procedures. The instructions in this manual have been prepared to aid you in learning the proper procedures. Where information is of particular importance or is safety related, the words NOTICE, CAUTION, or WARNING are used. Their usage is described below. SAFETY ALERT SYMBOL is used with DANGER, WAR
Résumé du contenu de la page N° 7
Model HCS-2/HCW-3/HCW-5/HCW-8 SECTION 2. INSTALLATION 2-1. INTRODUCTION This section provides the installation instructions for the Henny Penny Heated Display Cabinet. Installation of this unit should be performed only by a qualified service technician. Do not puncture the skin of the unit with drills or screws as component damage or electrical shock could result. 2-2. UNPACKING The Henny Penny Heated Display Cabinet has been tested, inspected, and expertly packed to ensure arrival at its des
Résumé du contenu de la page N° 8
Model HCS-2/HCW-3/HCW-5/HCW-8 2-2. UNPACKING (Continued) 2. Open top flaps and remove packing. Step 2 3. Lift carton off skid. Step 3 4. Remove four bolts from under skid. Step 4 The unit is now ready for location and set-up. 2-2 103
Résumé du contenu de la page N° 9
Model HCS-2/HCW-3/HCW-5/HCW-8 2-3. LOCATION Place the unit on a table, preferably with a cut-out opening below the cabinet to allow easy service connections and serviceability. When setting up the Henny Penny Heated Display Cabinet, be sure to level the table. The unit has built-in draining capabilities, but this becomes ineffective when set on an unlevel table. After the Henny Penny Heated Display Cabinet has been leveled on the table, run a bead of silicone rubber (silicone or equivalent sea
Résumé du contenu de la page N° 10
Model HCS-2/HCW-3/HCW-5/HCW-8 2-5. DRAIN CONNECTION The drain can be connected to a 1 inch N.P.T. directly below the water well or to a 3/4 inch N.P.T. from the operator’s side. We recommend the 1 inch N.P.T. connection as this will allow straight down draining of the water. 2-6. ELECTRIC CONNECTION The heated display cabinet is available from the factory wired for 208 or 230 volts, single phase, 3-wire (includes neutral) or three phase, 4-wire (includes neutral) 50 or 60 Hz. service. The pro
Résumé du contenu de la page N° 11
Model HCS-2/HCW-3/HCW-5/HCW-8 2-6. ELECTRICAL CONNECTION The electrical power can be connected from the bottom or from the (Continued) operator’s side. There is a 1-3/32 inch diameter hole for either connection. Again, we recommend the bottom connection as this will give a cleaner appearance to the unit. Please observe the electrical connection information on the data plate located on the side panel of the control end. Voltage potential of L1 and L2 to ground cannot exceed 125 volts, or damag
Résumé du contenu de la page N° 12
Model HCS-2/HCW-3/HCW-5/HCW-8 2-8. WATER SUPPLY CONNECTION (Continued) This unit as manufactured requires the installation of an appropriate back-siphoning device (as per National Plumbing Code ASA-A40.8-1955) to be connected to the water inlet line. This device to be connected in accordance to the basic plumbing code of the Building Officials and Code Administrators International, Inc. (BOCA), and the Food Service Sanitation Manual of the Food and Drug Administration (FDA). A water shut-off v
Résumé du contenu de la page N° 13
Model HCS-2/HCW-3/HCW-5/HCW-8 2-10. CABINET DIMENSIONS Model HCS-2 Model HCW-3 1006 2-7
Résumé du contenu de la page N° 14
Model HCS-2/HCW-3/HCW-5/HCW-8 2-10. CABINET DIMENSIONS (Continued) Model HCW-5 2-8 1006
Résumé du contenu de la page N° 15
Model HCS-2/HCW-3/HCW-5/HCW-8 SECTION 3. OPERATING INSTRUCTIONS 3-1. INTRODUCTION This section provides operating procedures for the heated display cabinets. The Introduction, Installation and Operation sections should be read, and all instructions should be followed before operating the cabinet. 3-2. OPERATING CONTROLS Figures 3-1 through 3-12 identify and describe the function of all the operating controls and the major components of the cabinet. 103 3-1
Résumé du contenu de la page N° 16
Model HCS-2/HCW-3/HCW-5/HCW-8 3-2. OPERATING CONTROLS (Continued) Figure 3-2 Figure 3-1 Figure 3-3 Figure 3-4 Figure 3-5 Figure 3-6 3-2 103
Résumé du contenu de la page N° 17
Model HCS-2/HCW-3/HCW-5/HCW-8 3-2. OPERATING CONTROLS (Continued) Figure 3-8 Figure 3-7 Figure 3-9 Figure 3-10 Figure 3-11 Figure 3-12 103 3-3
Résumé du contenu de la page N° 18
Model HCS-2/HCW-3/HCW-5/HCW-8 3-2. OPERATING CONTROLS (Continued) Fig. Item Description Function No. No. 3-1 1 Water Valve An electrical solenoid valve energized by the float switch or the water control switch (in manual position) that allows water to flow into the water pan 3-1 2 Water Strainer A filter to prevent particles plugging the water valve 3-1 3 Contactor The relay that directs power to the water heaters 3-1 4 Relay Shuts the heat off to the water pan when a low water condition
Résumé du contenu de la page N° 19
Model HCS-2/HCW-3/HCW-5/HCW-8 3-2. OPERATING CONTROLS (Continued) Fig. Item Description Function No. No. 3-10 13 Water Control A three-position switch with center position being OFF; Switch in the position marked AUTOMATIC (up), the water level in the unit will be controlled by the float switch; in the position marked MANUAL (down), the water valve is opened directly by the switch; the MANUAL position is spring loaded so that the water valve will close when the switch is released 3-10 14 W
Résumé du contenu de la page N° 20
Model HCS-2/HCW-3/HCW-5/HCW-8 3-2. OPERATING CONTROLS (Continued) Fig. Item Description Function No. No. 3-11 22 Float Switch An electro-mechanical sensing device used to automati- cally control the water level in the water pan; the float switch can be inactivated by the water control switch; the float switch illuminates the low water light when it senses a low water condition 3-12 23 Water Heater Two flat strip heaters, attached to the bottom of the water pan, which measure approximately
