Résumé du contenu de la page N° 1
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 1
AJ3112
Clock Radio
Register your product and get support at
www.philips.com/welcome
User manual
Résumé du contenu de la page N° 2
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 2 1 1 2 @ ! 0 9 3 4 8765 ^ % $ #
Résumé du contenu de la page N° 3
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 3 English Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. CONTROLS (see fig. 1 ) 1 DISPLAY - shows the clock/ alarm time and status of the set 2 ALARM indicator - lights up when alarm is activated 3 Frequency indicator - shows the radio frequency of your selected waveband 4 REPEAT ALARM / SLEEP OFF - switches off the active alarm for a 8-9 minu
Résumé du contenu de la page N° 4
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 4 INSTALLATION POWER SUPPLY 1 Check if the power supply, as shown on the type plate located on the bot- tom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2 Connect the plug to the wall outlet. 3 To disconnect the set from the power supply completely, remove the plug from the wall outlet. CLOCK MEMORY BACKUP The clock memory backup allows your alarm and clock time settings to be stored for up to
Résumé du contenu de la page N° 5
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 5 RADIO You can use this set solely as a radio! 1 Adjust RADIO / ALARM to RADIO ON to switch on the radio. 2 Select your waveband by adjusting the FM/MW switch. 3 Adjust TUNING to tune to your desired station. 4 Turn the VOLUME control to adjust the volume level. 5 Adjust RADIO / ALARM to OFF to switch off the radio. To improve reception: FM: Extend and position the pigtail fully to obtain optimal reception. MW: uses a built-in antenna inside the set. Dire
Résumé du contenu de la page N° 6
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 6 SELECTING THE ALARM MODE To use the alarm, you must set the alarm time first. You can choose from two different alarm modes to wake you up: by radio or buzzer. 1 Select your choice of alarm mode by adjusting RADIO / ALARM to RADIO or BUZ. ™ The alarm indicator (AL) will light up. Helpful Hint: • If you have selected the radio mode, make sure you have adjusted the vol- ume loud enough to wake you. • The buzzer is set at a fixed volume and cannot be adjus
Résumé du contenu de la page N° 7
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 7 REPEAT ALARM This repeats your alarm call at 9-minute intervals. 1 During the alarm call, press REPEAT ALARM / SLEEP OFF. ™ The alarm indicator (AL) will remain on. SLEEP This set has a built-in timer which enables the set to be automatically switched off during radio playback after a set period of time. This allows you to lie back, listen and fall asleep. The maximum sleep time is 1 hour and 59 minutes. Setting SLEEP 1 Set RADIO / ALARM to OFF position.
Résumé du contenu de la page N° 8
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 8 SAFETY INFORMATION • Install the unit near the AC outlet and where the AC plug can be easily reached. • Where the MAINS plug is used as the disconnect device, the disconnet device shall remain readily operable. • Place the set on a hard and flat surface so that the system does not tilt. • If you do not intend to use the set for a long time, withdraw the power plug from the wall outlet. In addition to this, it is advisable to remove the battery from the c
Résumé du contenu de la page N° 9
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 9 TROUBLESHOOTING If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to remedy a problem by following these hints, consult your dealer or service center. WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty. Do not open the set as there is a risk of electric shock. Problem – Possible Cause • Remedy No sound/power – Volume not adjusted • Adjus
Résumé du contenu de la page N° 10
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 10 ENVIRONMENTAL INFORMATION We have reduced packaging to the minimum for easy separation into two materials: paper and cardboard. Your set consists of materials which can be recycled if disassembled by a special- ized company. Please observe local regulations on the disposal of packing materi- als and old equipment. Disposal of your old product Your product is designed and manufactured with high quality materials and com- ponents, which can be recycled a
Résumé du contenu de la page N° 11
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 11 Specifications AC Power.............................................220 – 230 V / 50 Hz Power Consumption Active.........................................................................3.1W Standby......................................................................<2W Dimensions (w x d x h)...............130.4 x 130 x 46.8 (mm) Weight.....................................................................0.395 kg Caractéristiques technique Alimentation C
Résumé du contenu de la page N° 12
AJ3112_IFU_12_Eng 3/29/10 15:54 Page 12 Meet Philips at the Internet http://www.philips.com W AJ3112 Printed in China AJ3112_UM_12_V4.0
