Résumé du contenu de la page N° 1
C
E
N
R
G
T
I
INSTALLATION AND OPERATING
INSTRUCTIONS
FOR VENT-FREE
OR VENTED INSTALLATIONS
®
GOLDEN BLOUNT “TEXAS FLAME II” GAS LOGS
NATURAL GAS OR L.P.
18“ - 24“ & 30“ SIZE SETS
Warning: If the information in this manual is
not followed exactly, a fire or explosion may
result causing property damage, personal
injury or loss of life
• Do not store or use gasoline or other
flammable vapors or liquids in the
vicinity of this or any other appliance.
• What to do if you smell gas:
- Do not try to l
Résumé du contenu de la page N° 2
IMPORTANT! Read all instructions carefully before starting installation. Failure to follow these instructions may result in property damage, personal injury or possible loss of life SAFETY AND GENERAL INFORMATION Use correct gas type for your appliance. Do not Any outside air ducts and/or ash dumps in the fireplace • • convert from one gas type to another. shall be permanently closed at time of appliance installation. If this appliance is for use with Propane gas, do not • place propane supply t
Résumé du contenu de la page N° 3
CAUTION NOTE! CARBON MONOXIDE POISONING MAY LEAD TO DEATH. Early signs of carbon monoxide poisoning resemble the flu, with headache, dizziness and/or nausea. If you have these signs, the heater may not be working properly. Get fresh air at once! Have heater serviced. Some people - pregnant women, persons with heart or lung disease, anemia, those under the influence of alcohol, those at high altitude - are more affected by carbon monoxide than others. WARNING: ANY CHANGES TO THIS HEATER OR ITS CO
Résumé du contenu de la page N° 4
BURNER SYSTEM INSTALLATION Before starting installation, find out if local and state codes approve vent-free gas logs. If unvented gas logs are not approved, the installation must be made with the fireplace damper partially open and locked to assure the minimum vent area required by local codes or the National Gas Fuel Code (ANSI Z223.1-latest edition). Use the damper clamp provided. Clean the firebox thoroughly. In the future, frequent cleaning may be required due to excessive lint from carpeti
Résumé du contenu de la page N° 5
PLACEMENT OF LOGS - 18” SETS Front ember log sits under front ember burner tube as shown. Bottom back log is to be placed on back of grate and against burner support brackets as illustrated. Notches in bottom log will go over grate bar. Bottom front log is to be placed on front of EMBER BURNER TUBE EMBER LOG grate and against front uprights as illustrated. Front log should be centered. Remaining logs are to be placed in numbered notches as illustrated. WARNING: Failure to position the parts in a
Résumé du contenu de la page N° 6
PLACEMENT OF LOGS - 24” & 30” SETS Front ember log sits under front ember burner tube as shown. Bottom back log is to be placed on back of grate and against burner support brackets as illustrated. Notches in bottom log will go over grate bar. Bottom front log is to be placed on front of EMBER BURNER TUBE EMBER LOG grate and against front uprights as illustrated. Front log should be centered. Remaining logs are to be placed in numbered notches as illustrated. WARNING: Failure to position the part
Résumé du contenu de la page N° 7
FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance is equipped with a push-button piezo ignition device which automatically lights the pilot. If the piezo fails to ignite the pilot, then follow the lighting instructions for lighting the pilot with a match. B. BEFORE LIGHTING smell all around the appliance for gas. Be sure to smell next to the floo
Résumé du contenu de la page N° 8
LIGHTING INSTRUCTIONS “MILLIVOLT VALVE” 1. STOP! Read the safety information previously listed above. 2. Make sure manual shutoff valve is fully open. 3. Set rocker switch to OFF position. 4. Press in and turn control knob clockwise to the OFF position. 5. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! follow “B” in the safety information on page 7. If you don’t smell gas, go to the next step. 6. Press in and turn control knob c
Résumé du contenu de la page N° 9
TO TURN OFF GAS TO APPLIANCE “MILLIVOLT VALVE” CONT. SHUTTING OFF HEATER 1. Turn control knob clockwise to the OFF position. 2. Set rocker switch to OFF position Shutting off burners only (pilot stays lit) You may shut off burner and keep the pilot lit by doing one of the following. 1. Turn control knob clockwise to the PILOT position. 2. Set rocker switch to OFF position. 3. Turn remote control to OFF position. MANUAL LIGHTING PROCEDURE 1. Follow steps 1 through 6 under lighting instructions
Résumé du contenu de la page N° 10
PARTS LIST 18 6 7 13 2 8 1 16 19 17 14 15 22 21 10 24 9 3 11 20 4 12 23 5 TO ORDER PARTS CALL OR WRITE: GOLDEN BLOUNT INC. • 4301 WESTGROVE DR. ADDISON, TX 75001 • (972) 250-3113 ITEM QUANTITY DESCRIPTION 1 1 TF-II-18 TOP LEFT LOG 2 1 TF-II-18 TOP RIGHT LOG 3 1 TF-II-18 BOTTOM BACK LOG 4 1 TF-II-18 BOTTOM FRONT LOG 5 1 TF-II-18 FRONT EMBER LOG 6 1 TF-II-24/30 MIDDLE LEFT LOG 7 1 TF-II-24/30 MIDDLE RIGHT LOG 8 1 TF-II-24/30 LEFT FRONT LOG 9 1 TF-II-24/30 RIGHT FRONT LOG 10 1 TF-II-24/30 BOTTO
Résumé du contenu de la page N° 11
TROUBLESHOOTING REFERENCE With Proper installation and maintenance, your new Gas Appliance should provide years of trouble free service. If you do experience a problem, this guide will assist a CERTIFIED SERVICE PERSON in the diagnosis of problems and the corrective action to be taken. SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION 1. Pilot will not light with A. Main shutoff valve closed. 1. Make sure that the shutoff valve Piezo ignitor located on the pipe supplying gas to the fireplace is open. B
