Résumé du contenu de la page N° 1
MARINE SERIES
Use and Care Guide
Ice Maker Model:
SS1095
Résumé du contenu de la page N° 2
MARINE SERIES 1 Introduction Congratulations on your purchase of a U-Line refrigeration product. A pioneer in the field for more than 40 years, U-Line Corporation is the world’s number one manufacturer of built-in, under-counter, specialty refrigeration and ice making products. U-Line dedicates 100% of its research and development to these products. The result: U-Line technology consistently leads the market with innovation, design, depth of product line and performance. U-Line products are m
Résumé du contenu de la page N° 3
MARINE SERIES 2 Table of Contents Introduction ..................................................................................................Inside Front Cover Warranty Registration .......................................................................... Inside Front Cover Please Record Your Model Information .............................................. Inside Front Cover Table of Contents ...................................................................................................
Résumé du contenu de la page N° 4
MARINE SERIES WARNING 3 Safety Precautions SHOCK HAZARD - Electrical Grounding Required. Never attempt to repair or perform IMPOR IMPORT TANT ANT maintenance on the unit until the electricity PLEASE READ all instructions completely before has been disconnected. attempting to install, operate, or service your unit. Never remove the round grounding prong from • Proper installation procedures must be followed the plug and never use a two-prong grounding if this unit is being initially ins
Résumé du contenu de la page N° 5
C O L MARINE SERIES 4 Product Features Origins Ice Maker Model SS1095 All Origins Ice Makers provide high daily ice production ULIN_0129_A and storage capabilities, and conserve on water, using Figure 3 only 2-3/4 gallons (10.4 L) to produce approximately 22 lbs (10 kg) of ice. Depress the ON/OFF switch (Figure 3) as required to turn Model SS1095 produces up to 23 lbs (10.4 kg) of ice per the unit on or off. day and will store 12 lbs (5.4 kg). Ice Harvest Control The unit features a
Résumé du contenu de la page N° 6
MARINE SERIES Normal operating sounds may be more noticeable because of the unit’s environment. Hard surfaces such as cabinets, wood/vinyl/tiled floors and paneled walls have a tendency to reflect normal appliance operating noises. Common refrigeration components, and a brief description of the normal operating sounds they make, are listed below. NOTE: Your product may not contain all of the components listed. Compressor: The compressor makes a hum or pulsing sound that may be heard whe
Résumé du contenu de la page N° 7
MARINE SERIES Product Disposal WARNING If the unit is being removed from service for disposal, Electrical Shock Hazard. Disconnect power before check and obey all Federal, State and/or Local regulations servicing. Before operating, replace all panels. regarding the disposal and recycling of refrigeration Failure to do so may result in death or electrical appliances, and follow these steps completely: shock. 1. Disconnect power to the unit and unplug the power 1. Remove all consumable cont
Résumé du contenu de la page N° 8
MARINE SERIES 3. Place a towel or other absorbent material on bottom of 6 Cleaning and Maintenance unit. 4. If you would like, place warm water inside ice bucket. Proper cleaning and maintenance of your U-Line product Then place ice bucket back into unit and close door. will ensure efficiency, top performance and long life. The maintenance intervals listed are based on normal 5. After approximately one hour, remove ice bucket and conditions. You may want to shorten the intervals if you dis
Résumé du contenu de la page N° 9
MARINE SERIES 1. Disconnect electrical power to the unit. Ice Maker Maintenance 2. With a standard blade screwdriver or 1/4" nut driver, Inlet Screen remove the grille screw (Figure 8). Interval - Every Twelve Months 3. Remove the grille. The solenoid valve inlet screen must be cleaned at least once each year as follows: WARNING DO NOT touch the condenser fins. The condenser WARNING fins are SHARP and can be easily damaged. Disconnect electrical power to the unit before IMPOR IMPORT TANT ANT
Résumé du contenu de la page N° 10
MARINE SERIES SS1095FD model: Align the tabs on the bottom of the 3. Turn the adjusting screw toward the minus (-) sign grille with the slots in the flange and swing grille up (clockwise) for smaller cubes or toward the plus (+) sign into position. (counterclockwise) for larger cubes. 4. Install the ice maker assembly cover. Align the grille and cabinet screw holes (Figure 8). 10. Insert the grille screw (Figure 8) and tighten. Do not IMPOR IMPORT TANT ANT over-tighten. Use only genuine U-Lin
Résumé du contenu de la page N° 11
MARINE SERIES 1. Remove grille (one screw) (Figure 15). Door Alignment Check and 2. Remove top hinge from cabinet (three screws) (Figure Adjustment 14). Hold door to keep it from falling. IMPOR IMPORT TANT ANT 3. Lift the door off the bottom hinge. Properly aligned, the door’s gasket should be firmly in contact with the cabinet all the way around the door (no gaps). Carefully examine the door’s gasket to assure that it is firmly in contact with the cabinet. Also make sure the door gasket i
Résumé du contenu de la page N° 12
MARINE SERIES 6. Install hinge on opposite side, bottom of cabinet Hinge (Figure 18). Align hinge outer edge with cabinet before tightening screws. Plastic Plastic Plug Hole Plug Hole Screw Right Side Left Side Door Swing Door Swing Invert Right Invert Screw Hinge Side Hinge ULIN_0142_A Figure 21 9. Remove plastic hole plug (Figure 22) from door handle and relocate on opposite side. Lift the handle slightly and press on the locking tab, then gently pry the hole Figure 18 plug out of the hol
Résumé du contenu de la page N° 13
MARINE SERIES 13. Remove all three screws on the opposite side of the 7 Service hinge and carefully lift off the door latch assembly (Figure 23). Before Calling for Service If your U-Line product appears to be malfunctioning, read through the OPERATION section of this guide to ensure that the function of all controls are clearly understood. If the malfunction persists, the TROUBLESHOOTING GUIDE in this guide will assist you in quickly identifying common problems, and provide information o
Résumé du contenu de la page N° 14
MARINE SERIES DANGER 8 Troubleshooting Guide ELECTROCUTION HAZARD! Never attempt to repair or perform maintenance on the unit unitl the main electrical power has been disconnected. Troubleshooting - What to check when problems occur: PROBLEM POSSIBLE CAUSE REMEDY The unit frosts up. Unit is manual defrost model. Defrost unit manually (See MAINTENANCE; DEFROSTING). Door gasket not sealing properly Adjust door (See MAINTENANCE; DOOR ALIGN, ADJUST, REVERSE). High ambient temperatures or Defrost
Résumé du contenu de la page N° 15
MARINE SERIES U-LINE CORPORATION LIMITED WARRANTY U-Line Corporation warrants each U-Line product to be free from defects in materials and workmanship for a period of one year from the date of purchase; and warrants the sealed system (consisting of the compressor, the condenser, the evaporator, the hot gas bypass valve, the dryer and the connecting tubing) in each U-Line product to be free from defects in materials and workmanship for a period of five years from the date of purchase. During t
Résumé du contenu de la page N° 16
For General Inquiries: P.O. Box 245040 Milwaukee, Wisconsin 53224-9540 U.S.A. Phone (800) 779-2547 FAX (414) 354-5696 www.U-Line.com For Service and Parts Assistance: Phone (800) 779-2547 (414) 354-0300 FAX (414) 354-5696 Email: OnLineService@U-Line.com www.U-LineService.com E-mail: OnlineParts@u-line.com For more than four decades, U-Line has distinguished itself as the leader in built-in under-counter ice making, refrigeration and wine storage appliances. An INSTALLATION MANUAL for yo
