Instruction d'utilisation Whirlpool 110.44832

Résumé du contenu de la page N° 1

Sears Kenmore/Whirlpool Front Load Washer
Error Codes: 02F dLF

Model: 110.44832 200 (110. = Whirlpool)
S/N: CSP 1903874
Type: 199-AKP 705/WT

SOURCE: www.applicancepartspros.com
WHIRLPOOL FAULT CODES
Whirlpool Duet Front Loading Automatic Washer Fault Codes
Failure Fault Code Description Solution
Code
FH No water detected entering If after 30 seconds the control does not detect water
machine or Pressure switch trip entering machine and then valves will be turned off and

Résumé du contenu de la page N° 2

then 4 minutes later the F02 error code will be displayed. Potential Causes • Check the drain hose and make sure it is not plugged or kinked • Check the electrical connections at the pump and make sure the pump is running. • Check the drain pump filter for foreign objects • If the above does not correct the problem replace the pump F05 Water temperature sensor error If during the water heating step in the wash cycle, the water temperature sensor (NTC) value is out of range, or the

Résumé du contenu de la page N° 3

Potential Causes • Check the drain hose and make sure it is not plugged or kinked • Check Wire Harness connections to the Drain Pump, Pressure Switch, and Central Control Unit (CCU) • Check / Clean Drain Pump Filter of foreign objects • Check for Drain Pump Failure • Check the Inlet Valve for proper shut off • Check the Pressure switch for proper operation Replace failed component. F10 Motor Control Unit (MCU) heat If the thermal protector on the MCU heat sink gets too sink ther

Résumé du contenu de la page N° 4

EEPROM onboard the CCU. If there is an error reading this data it will cause this error. Potential Causes • A power glitch may cause this error. Try unplugging the Unit for two minutes to see if that fixes the error. • Check CCU. Replace failed component. F15 Motor Control Unit (MCU) error If the MCU detects multiple resets or errors during a wash cycle it will go into this error mode. Potential Causes • Check Wire Harness connections to the MCU, the motor, and Central Contr

Résumé du contenu de la page N° 5

unlocked. It will try to unlock the door 6 times before displaying the error. Potential Causes • Door Lock Mechanism broken. • Check Door Lock/Switch Assembly for foreign objects • Check Wire Harness connections to the Door Lock/Switch Assembly and Central Control Unit (CCU) • Door Lock/Switch Assembly Failure Replace failed component. Note: The door lock/switch assembly can be manually unlocked. To Manually unlock the door lock system: 1. Unplug the power cord from the o