Résumé du contenu de la page N° 1
CT5.1
TREADMILL OWNER’S MANUAL
MANUEL D’UTILISATION DU TAPIS ROULANT
Read the TREADMILL g UIDE before using this OWNER’S MANUAL.
Lire le g UIDE DU TAPIS ROULANT avant de se servir du présent MANUEL D’UTILISATION.
Résumé du contenu de la page N° 2
3 ENg LISH 21 FRANç AIS 2
Résumé du contenu de la page N° 3
ASSEMBLY WArnin G There are several areas during the assembly process that special attention must be paid. It is very important to follow the assembly instructions correctly and to make sure all parts are firmly tightened. If the assembly instructions are not followed correctly, the treadmill could have parts that are not tightened and will seem loose and may cause irritating noises. To prevent damage to the treadmill, the assembly instructions must be reviewed and corrective actions should b
Résumé du contenu de la page N° 4
TOUCH PAD PANEL AND DISPLAY WINDOWS READING RACK SPEAKERS SUPPORT BAR CONSOLE WATER BOTTLE HOLDER IPOD/MP3 PLAYER POCKET GRIP PULSE HANDRAILS SAFETY KEY PLACEMENT ON/OFF SWITCH CONSOLE MAST FOOT LOCK LATCH (UNDERNEATH DECK) CIRCUIT BREAKER MOTOR COVER POWER CORD SIDE RAIL TRANSPORT WHEEL ROLLER END CAP RUNNING BELT / RUNNING DECK REAR ROLLER ADJUSTMENT BOLTS 4
Résumé du contenu de la page N° 5
Too LS in CLUDED: Pr E ASSEMBLY F Screwdriver F 6 mm T-Wrench Un PACKin G F 5 mm L-Wrench Place the treadmill carton on a level flat surface. It is recommended that you place a F 4 mm L-Wrench protective covering on your floor. Take CAUTION when handling and transporting this unit. Never open box when it is on its side. Once the banding straps have been removed, PAr TS in CLUDED: do not lift or transport this unit unless it is fully assembled and in the upright folded position, with the lo
Résumé du contenu de la page N° 6
ASSEMBLY STEP 1 A Cut the yellow banding straps and lift the HAr DWAr E BAG 1 CONTENTS : running deck upward until the t foo ch loc tla ks. Remove all contents from BOLT (A) SPRING WASHER (B) FLAT WASHER (C) 20 mm 15 mm 15 mm underneath the running deck. Qty: 4 Qty: 4 Qty: 4 B Open hararwde bag 1. C With the running deck in the raised RUNNING DECK position, attach the elft cone mastsol to the base fram using 4 e ts (a) bol , 4 spring washers (b) and 4 t fla aswhers (c). NOTE: Do not complet
Résumé du contenu de la page N° 7
ASSEMBLY STEP 2 A Open hararwde bag 2. HAr DWAr E BAG 2 CONTENTS : B Pull ead wl ir through e right cone sol BOLT (A) SPRING WASHER (B) FLAT WASHER (C) . After pulling the lead wire through the mast 20 mm 15 mm 15 mm Qty: 4 Qty: 4 Qty: 4 mast, the top of the cone csol abe should l be located at the top of the mast. Detach and discard the lead wire. C With the running deck in the raised position, attach the right cone sol LEAD WIRE mast to the base frame using 4 ts bol (a), 4 spring washers (b)
Résumé du contenu de la page N° 8
ASSEMBLY STEP 3 A Disengage the deck lock lach with your t HAr DWAr E BAG 3 CONTENTS : foot to lower the running deck. BOLT (D) FLAT WASHER (E) B Open hararwde bag 3. 25 mm 16 mm Qty: 2 Qty: 2 C gently place the cone on top of the sol cone mastssol . Attach the elft side first using 1 t (d) bol and 1 t wfla asher (e). D Connect the cone csol abels, carefully tucking wires in masts to avoid damage. E Attach the right si of the de con esol using 1 bolt (d) and 1 t wfla asher (e). CONSOLE CABLES
Résumé du contenu de la page N° 9
ASSEMBLY STEP 4 A Open hararwde bag 4. HAr DWAr E BAG 4 CONTENTS : B Align support bar with holes in cone sol BOLT (H) masts. 15 mm Qty: 4 C Insert ts (h) bol into all 4 holes of the support bar. Note: look into holes in the right mast before inserting bolts to avoid pinching cables. D Tighten all ts completely bol . CONSOLE BOLTS (H) SUPPORT BAR CONSOLE MAST 9
Résumé du contenu de la page N° 10
ASSEMBLY STEP 5 A Open hararwde bag 5. HAr DWAr E BAG 5 CONTENTS : B Slide right om cttbo one csol veor up SCREW (G) 15 mm cone sol mast and align screw holes. Attach Qty: 4 om cttbo one csol veor to con esol using 2 screws (g). C Repeat on other side. D Connect power plug to a power outlet. The ON/ CONSOLE OFF switch is located next to the power cord. Flip this switch to the ‘ON’ position, so that the switch is lit. You will hear a beep and the console will turn on. E Before the first use,
Résumé du contenu de la page N° 11
TREADMILL OPERATION This section explains how to use your treadmill’s console and programming. The BASIC OPERATION section in the TREADMILL g UIDE has instructions for the following: • Lo CATion o F THE Tr EADMiLL • USin G THE SAFETY KEY • Fo LDin G THE Tr EADMiLL • Mo Vin G THE Tr EADMiLL • LEVELin G THE Tr EADMiLL • TEn Sionin G THE r Unnin G BELT • CEn TErin G THE r Unnin G BELT • USin G THE HEAr T r ATE FUn CTion 11
Résumé du contenu de la page N° 12
TIME DISTANCE A CALORIES HEART RATE INCLINE SPEED B % COMPLETE C SCAN SAVED MANUAL WEIGHT SAVED SAVED WEIGHT SAVED SAVED INTERVALS HILLS ROLLING LOSS MANUAL INTERVALS LOSS HILLS ROLLING D E U U ™ ™ M y K E Y S M y K E Y S Q R Press and hold a MyKEY™ Press and hold a MyKEY™ for three seconds to set for three seconds to set LOW MED HIGH SLOW MED FAST key to current incline. key to current speed. O P P INCLINE SPEED T T M H F L J S K G I N 12
Résumé du contenu de la page N° 13
Con So LE o PEr ATion Note: There is a thin protective sheet of clear plastic on the overlay of the console that should be removed before use. A) LAr GE LED Win Do WS: time & distance. B) LCD Win Do W: calories, heart rate, incline, speed, % complete, and scan. C) FEEDBACK LEDS: indicate what workout feedback is currently being displayed in the lcd window. D) ProG rAM LED S: indicate what program is currently selected. E) SAVED ProG rAM LED S: indicate what saved program is currently selected. F
Résumé du contenu de la page N° 14
™ MYKEYS KEY o PEr ATion You can program the MyKeys to your desired speed or incline values. The SPEED MyKeys defaults are: The INCLINE MyKeys defaults are: Slow = 1 mph Low = 0% Med = 3 mph Med = 3% Fast = 5 mph High = 6% To change the default value of any MyKEY, while in a program, first select the speed or incline level you would like to save, then press and hold the MyKEY you wish to change for 3 seconds. The current speed or incline level will flash on the console and beep three t
Résumé du contenu de la page N° 15
Pro Gr AMS MAn UAL: Allows “on the fly” manual speed and incline changes. Time-based goal. inTE rVALS: Improves your strength, speed and endurance by increasing and decreasing the speed throughout your workout to involve your heart and other muscles. WEiGHT LoSS: Promotes weight loss by increasing and decreasing the speed, while keeping you in your fat burning zone. HiLLS: Simulates running up and down hills to improve stamina. roLLin G: A less-intense version of the HILLS program. GETTin G
Résumé du contenu de la page N° 16
SAVin G A Wor Ko UT If you had an especially challenging workout, you may want to save that one for the future. 1) At the end of your workout, the console will prompt you if you would like to save your completed workout by scrolling save workout. 2) If you would like to save the workout, press the SAvE WORKOUT key. If not, either press the STOP key or stop using the treadmill until the console resets itself. 3) The LED will flash next to the type of program you used. For example, if you used t
Résumé du contenu de la page N° 17
LIMITED HOME-USE WARRANTY 17
Résumé du contenu de la page N° 18
EXCLUSion S An D LiMiTATion S Who IS covered: WEiGHT CAPACiTY = 300 lbs (136 kilograms). • The original owner and is not transferable. FrAME • LIFETIME What IS covered: Horizon Fitness warrants the frame against defects in workmanship and materials for the lifetime of the owner, so • Repair or replacement of a defective motor, electronic long as the device remains in the possession of the original component, or defective part and is the sole remedy of the owner. (The frame is defined
Résumé du contenu de la page N° 19
SEr ViCE/r ETUrn S • In-home service is available within 150 miles of the nearest • Equipment used for commercial purposes or any use other authorized repair center (Mileage beyond 150 miles from than a single family or Household, unless endorsed by an authorized service center is the responsibility of the Horizon Fitness for coverage. consumer). • Equipment owned or operated outside the US and • All returns must be pre-authorized by Horizon Fitness. Canada. • Horizon Fitness’ oblig
Résumé du contenu de la page N° 20
20