Instruction d'utilisation Grizzly CABLE H6167

Résumé du contenu de la page N° 1

MODEL H6167
2000 LB. WINCH
w/STEEL CABLE
INSTRUCTIONS
To reduce the risk of serious personal injury
while using this winch:
1. Always wear ANSI approved eye protec-
tion when operating the winch.
2. Be sure the cable is not damaged. If the
cable shows any signs of fraying or any
other damage, do not use the winch.
3. Do not exceed the pulling capacities of
the winch.
4. Do not stand in line with cable while
operating the winch. If the cable breaks
it will whip back along this line.
Figure

Résumé du contenu de la page N° 2

Mounting Winching Direction The Model H6167 has holes in the base for The Model H6167 has a three position ratchet mounting to most flat surfaces. The winch must control lever that controls the ratchet action of the be mounted for safe and effective operation. Be winch. sure to check for wires before drilling into a trailer frame. To change the winching direction: To mount the winch: 1. Firmly grasp the winch handle to prevent sud- den movement. 1. Place the winch in the desired position and

Résumé du contenu de la page N° 3

2. Remove the lock nut that secures the handle gear Ratios to the shaft. The Model H6167 has a two available gear ratios. By placing the handle on one of the two shafts, 3. Remove handle and handle bracket, reposi- you can change the gear ratio to a 4:1 or an 8:1 tion them to the necessary shaft, making sure ratio. to align the flats on the shaft with the flats on the handle bracket, then replace the lock To change the gear ratio: nut. 1. use Figure 4 to determine which handle position i

Résumé du contenu de la page N° 4