Résumé du contenu de la page N° 1
K 3.740
HIGH PRESSURE WASHER - OPERATOR MANUAL
NETTOYEUR HAUTE PRESSION - MANUEL D'UTILISATION
MANUAL DE USUARIO DEL LIMPIADOR DE ALTA PRESIÓN
English 3
Français 22
Español 42
59639230 (12/10)
Résumé du contenu de la page N° 2
2
Résumé du contenu de la page N° 3
HIGH PRESSURE WASHER OPERATOR MANUAL HIGH PRESSURE WASHER OPERA- Owner/User Responsibility TOR MANUAL . . . . . . . . . . . . . . . . 3 MODEL OVERVIEW . . . . . . . . . . . 4 The owner and/or user must have an IMPORTANT SAFETY INSTRUCTIONS . . . 5 understanding of the manufacturer’s ASSEMBLY INSTRUCTIONS . . . . 7 operating instructions and warnings OPERATING INSTRUCTIONS . . . 9 before using this pressure washer. USING THE ACCESSORIES . . . . 11 Warning information should be empha- WORKING W
Résumé du contenu de la page N° 4
MODEL OVERVIEW 1 Garden hose connector (female) 13 Detergent tank 2 Water inlet connector 14 Accessory storage 3 Water inlet with filter 15 Storage hook for mains connection cable 4 High pressure hose 16 Power cord with Ground Fault Cir- 5 Quick coupling for high pressure cuit Interrupter (GFCI) hose 17 Wheels 6 ON/OFF switch 18 Trigger gun 7 Dosage regulator for detergent 19 Lock trigger gun 8 Storage for trigger gun 20 Key to detach the high pressure 9 Transport handle, detachable hose from
Résumé du contenu de la page N° 5
IMPORTANT SAFETY INSTRUCTIONS WARNING WARNING When using this product basic precau- Risk Of Explosion – Do not spray tions should always be followed, in- flammable liquids. cluding the following: Do not use acids, alkaline, solvents, or any flammable material in this prod- uct. These products can cause physi- cal injuries to the operator and irreversible damage to the machine. To reduce the risk of injury, close CAUTION supervision is necessary when a product is used near childre
Résumé du contenu de la page N° 6
the skin. do not point the gun at anyone CI) built into the plug of the power-sup- or any part of the body. In case of pen- ply cord. This device provides etration seek medical aid immediately. additional protection from the risk of This system is capable of producing electric shock. Should replacement of 12400 kPa /1800 PSI to avoid rupture the plug or cord become necessary, and injury, do not operate this pump use only identical replacement parts with components rated less than that inclu
Résumé du contenu de la page N° 7
ASSEMBLY INSTRUCTIONS For more detailed information on Install the storage for hand-spray how to assemble this pressure gun washer, please visit STEP 2: www.karcherresidential.com/ Place the bottom holder into the re- assembly cesses and push forward until it au- dibly locks in. Required tools Insert the top holder and push down A Philips Screwdriver, medium all the way. size (not supplied) for final assembly Assembly Mount loose parts delivered with appli- Install the storage hook for
Résumé du contenu de la page N° 8
Install the transport handle STEP 4: Place the transport handle into the intake until you feel resistance. Use the heel of your hand or a soft rub- ber mallet to position it. STEP 5: Connect the high pressure hose to To push the appliance, the trans- the hand spray gun port handle must be pulled all the STEP 7: way up; it will lock into place audi- Push the high pressure hose into bly. the trigger gun until it locks audibly. Note: Make sure the connection nipple is aligned correctly.
Résumé du contenu de la page N° 9
OPERATING INSTRUCTIONS This pressure washer has been tested STEP 3: by Kärcher's quality assurance team. A Install the supplied connector to the small amount of water may be present unit’s water inlet. in the water inlet or outlet. This is nor- Note: Never attach the garden mal and will not affect the performance hose connector to the unit’s water of the pressure washer. inlet! STEP 1: Insert the spray wand of your choice into the trigger gun. Press in against the spring tension and
Résumé du contenu de la page N° 10
STEP 5: STEP 7: Connect garden hose to the cold Unlock the trigger gun safety lock. water source and turn water on Trigger the gun to eliminate trapped completely. air, wait for a steady flow of water to emerge from the spray nozzle. STEP 6: STEP 8: Plug the Ground Fault Circuit Inter- rupter (GFCI) into a receptacle. Turn on the high pressure washer (I/ON). Press RESET button, indicator should be “ON”. The motor starts only if the trig- ger of the gun is pulled and shuts Press TES
Résumé du contenu de la page N° 11
USING THE ACCESSORIES WARNING ® Dirtblaster To avoid serious injury never point This nozzle features a 0º pencil jet spray nozzle at yourself, other per- which rotates 360º for maximum dirt sons or animals. cutting action, effectively increasing Always test an inconspicuous area cleaning performance up to 50%. before cleaning with high pressure. This nozzle combines the cleaning Vario Power Spray Wand performance of a 0º pencil jet with the surface coverage of a wide an- The Vario P
Résumé du contenu de la page N° 12
STEP 3: For best results see Cleaning Tips for specific information on how to Adjust the suction volume of the de- clean different surfaces. tergent solution by means of the ® Always Use Kärcher Detergent for dosage regulator for detergents. Best Results STEP 4: ® Kärcher biodegradable detergents Turn on the pressure washer (I). are specially formulated to protect the Pull trigger to operate unit. Liquid environment and your pressure wash- detergent is drawn into the unit and er.
Résumé du contenu de la page N° 13
SHUTTING DOWN & CLEAN-UP STEP 1: STEP 5: Turn the switch to OFF (0) position Disconnect the garden hose from and unplug cord from outlet. the water inlet on the unit. Caution: When disconnecting the supply or high pressure hose, warm water may leak from the connec- tions after operation. STEP 2: Turn off the water source. STEP 3: Press trigger to release water pres- sure. STEP 4: Release trigger and engage gun safety lock. English 13
Résumé du contenu de la page N° 14
WINTERIZING AND LONG-TERM STORAGE 1: Disconnect all water connec- of heat as it may dry out the pump tions. seals. 2: Turn on the machine for a few CAUTION seconds, until the water which had Failure to follow the above directions remained in the pump exits, turn off will result in damage to the pump as- immediately. sembly and accessories and will void 3: Do not allow high pressure hose the warranty. ® to become kinked. Kärcher also recommends the regular 4: Store the machine
Résumé du contenu de la page N° 15
CLEANING TIPS ing detergent, apply to surface at low CAUTION pressure (for best results, limit your Before cleaning any surface an in- work area to sections of approximately conspicuous area should be 6 feet and always apply detergent from cleaned to test spray pattern and bottom to top). Allow detergent to re- distance for maximum cleaning re- main on surface 1-3 minutes. Do not sults. allow detergent to dry on surface, if If painted surfaces are peeling or surface appears to be
Résumé du contenu de la page N° 16
use special wash brush attachment (not included) to remove stubborn dirt. Rinse at high pressure in a sweeping motion keeping the spray nozzle ap- proximately 6-8 inches from the clean- ing surface (distance should increase when rinsing pin-striping or other sen- sitive surfaces). Always clean from top to bottom and from left to right. For best results, wipe surface dry with a cham- ois or soft dry cloth. Barbecue Grills, Outdoor Power Equipment & Gardening Tools (with or without deterge
Résumé du contenu de la page N° 17
OPTIONAL CLEANING ACCESSORIES Optional accessories are available to causes the inner brushes to gently further enhance your cleaning capabil- spin, making your cleaning job much ities. These accessories are accurate easier. The angle of brush head is ad- as of the printing date of this manual. justable to help you reach difficult ar- Please check our website for pricing eas. Excellent for the application of and up-to-date information. detergent. A must-have accessory de- ® signed for Kärche
Résumé du contenu de la page N° 18
material and attack the rust and paint with our eco-friendly alternative. Fits ® most Kärcher pressure washers up to 2300 PSI. (bayonet) Part No. 2.638-792.0 Detergent Foamer Attachment Ideal for applications which require a thick foam. Simply fill the resevoir cup with liquid pressure washer detergent to generate a foam spray. Connects di- rectly to the trigger gun. Fits most ® Kärcher pressure washers up to 2300 PSI. (bayonet) Part No. 6.964-507.0 T 200 Wide Area Surface Cleaner For
Résumé du contenu de la page N° 19
TROUBLESHOOTING Disconnect the machine from the pow- CAUTION er source before making any repair. Symptom Cause Solution Motor will not start On/Off switch is in the “OFF” Turn switch to the “ON” (I) posi- (0) position. tion Power cord is not plugged in. Plug in power cord. Electrical outlet does not Try a different outlet. supply adequate power. Tripped GFCI plug. Press “RESET” button on GFCI plug. Tripped circuit breaker. Switch off pressure washer. The reset comes automatically once the t
Résumé du contenu de la page N° 20
Symptom Cause Solution No detergent. Detergent suction tube not Check connection. properly connected to the machine. Detergent is too thick. Dilute detergent, for best re- ® sults use Kärcher detergent. Filter on detergent suction Run warm water through filter tube is clogged. to remove debris. Damaged or clogged deter- Remove obstruction or replace gent suction tube. detergent suction tube. Spray wand is in high pres- Turn spray wand tip to low sure position. pressure position. Discharge
