Résumé du contenu de la page N° 1
Model: PP4300/PP6600/PP6600E/PP7600E
IMPORTANT - Please make certain the person
who uses this generator thoroughly reads these
instructions and all other instructions provided to
ensure proper safety, use, and care of your new
Consumers service: 1-800-849-1297
portable electric generator.
WWW.POULANPRO.COM
Résumé du contenu de la page N° 2
TABLE OF CONTENTS INTRODUCTION.................................................................................................2 SAFETY RULES ............................................................................................. 3-4 SYMBOLS....................................................................................................... 5-7 FEATURES ................................................................................................... 8-10 ASSEMBLY.......................
Résumé du contenu de la page N° 3
SAFETY RULES DANGER WARNING Running generator gives off carbon monoxide, Fuel and its vapors are extremely flammable and an odorless, colorless, poison gas. explosive. Breathing carbon monoxide will cause nausea, Fire or explosion can cause severe burns or fainting, or death. death. ● Operate generator ONLY outdoors. WHEN ADDING FUEL: ● Keep clearance on all sides of generator for adequate ● Turn generator OFF and let it cool at least2 minutes before ventilation. removing gas cap. Loosen cap slo
Résumé du contenu de la page N° 4
SAFETY RULES WARNING CAUTION Exceeding generator’s wattage/amperage capacity can damage generator and/or electrical devices connected Unintentional sparking can result in fire or to it. electric shock. ● See“Don’t Overload Generator” on page. 17 ● Start generator and let engine stabilize before connecting WHEN ADJUSTING OR MAKING REPAIRS TO YOUR electrical loads. GENERATOR ● Connect electrical loads in OFF position, then turn ON for ● Disconnect the spark plug wire from the spark plug and place
Résumé du contenu de la page N° 5
SYMBOLS Some of the following symbols may be used on this generator. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the generator better and safer. SYMBOL NAME DESIGNATION/EXPLANATION V Volts Voltage A Amperes Current Hz Hertz Frequency (cycles per second) W Watt Power min Minutes Time ~ Alternating Current Type of current Direct Current Type of current n No Load Speed Rotational speed, at no load o Wet Conditions Alert Do not expose t
Résumé du contenu de la page N° 6
SYMBOLS The following signal words and meanings are intended to explain the levels of risk associated with this product. SYMBOL SIGNAL MEANING DANGER: Indicates an imminently hazardous situation which, if not avoided,will result in death or serious injury WARNING: Indicates an imminently hazardous situation which, if not avoided, could result in death or serious injury CAUTION: Indicates an imminently hazardous situation which, if not avoided, may result in minor or moderate injury (Without Safe
Résumé du contenu de la page N° 7
SYMBOLS SAFETY LABELS The following labels are found on the generator. For your safety, please study and understand all of the labels You could be KILLED or SERIOUSLY HURT before starting the generator. if you do not follow the Owner`s Manual instructions. If any of the labels come off the unit or become hard to read, contactanauthorized service centerfor replacement. Do not expose to rain or use in damp locations. FUEL WARNING DO NOT SMOKE when filling with gasoline. Do not over fill. Full leve
Résumé du contenu de la page N° 8
FEATURES SPECIFICATIONS PP4300 PP6600 PP6600E PP7600E GENERATOR AC OUTPUT: Frequency (Hertz) 60 Hz 60 Hz 60 Hz 60 Hz Voltage 120 / 240 Volts 120/ 240 Volts 120 / 240 Volts 120/ 240 Volts Rated Power 4300 Watts 6600 Watts 6600 Watts 7600 Watts ENGINE Engine Type Single Cylinder, Forced Air Cooling, 4-Stroke Engine Speed (RPM) 3600 3600 3600 3600 Fuel Gasoline Gasoline Gasoline Gasoline Engine Oil Capacity 1L 1L 1L 1L Spark Plug Type F7TC F7TC F7TC F7TC Spark Plug Gap 0.7 mm 0.7 mm 0.7 mm 0.7 mm 0
Résumé du contenu de la page N° 9
FEATURES AC CIRCUIT FUEL TANK FUEL TANK BREAKER CAP FUEL LEVEL GAUGE 120 VOLTS AC RECEPTACLES CHOKE LEVER ENGINE SWITCH AIR FILTER 120/240 VOLTS AC RECEPTACLES FUEL VALVE RECOIL STARTER GRIP BATTRAY (IF EQUIPPED) WHEEL OIL FILL CAP/DIPSTICK GROUNDING HANDLE TERMINAL OIL DRAINAGE BOLTS FOOT Fig. 1 PP4300 CONTROL PANEL 9
Résumé du contenu de la page N° 10
FEATURES KNOW YOUR GENERATOR RECOIL STARTER GRIP See1 Fig. The recoil starter grip is used (along with the engine switch) to start the generator抯 engine. with all operating features and safety rules. FUEL VALVE GROUNDING TERMINAL The flow of fuel through the generator is controlled by The grounding terminal is used to assist in properly the position of the fuel valve. grounding the generator to help protect against electrical shock. Consult with a local electrician for grounding AIR FILTER requi
Résumé du contenu de la page N° 11
ASSEMBLY UNASSEMBLED PARTS See2 Fig. The following assembly hardware items are included with the generator. Wheel Assembly1 .............................................................. Handle Assembly.............................................................1 Foot Assembly.................................................................1 Fig. 2 11
Résumé du contenu de la page N° 12
ASSEMBLY INSTALLING HANDLE ASSEMBLY INSTRUCTIONS This product requires assembly. See3 Fig. ■ Carefully remove the generator and any accessories from the box. Handle NOTE: Thegeneratoris heavy. To avoid back injury, lift with Left and right handle brackets your legs, not your back, and get help when needed. 4 bolts 4 nuts ■ Make sure that all items listed in the unassembled parts list are included. Assemble the bracket on the frame with bolts and nuts breakage or damage occurred during shipping.
Résumé du contenu de la page N° 13
ASSEMBLY INSTALLING WHEEL ASSEMBLY 2 wheels 2 flat washers 2 pins 4 bolts 4 nuts ■ Slide wheel over axle extension. ■ Slide flat washer on axle extension. ■ Install hex nut on axle extension and tighten to secure. ■ Repeat for second wheel. NOTE: Block up frame securely with wood blocks to provide clearance for frame bolts& wheel assembly. ■ Slide square curved washer, curved side down, on bolt. ■ Place on frame and slide bolt through frame hole. ■ Repeat for second bolt. Fig. 4 ■ Lift axle and
Résumé du contenu de la page N° 14
OPERATION GROUNDING THE GENERATOR The National Electrical Code requires that the frame and external electrically conductive parts of this generator be properly connected to an approved earth ground. Local electrical codes may also require proper grounding of the unit. For that purpose,a GROUNDING FASTENER is provided on the generator end (Figure 6). Grounding fastener Fig. 6 Generally, connecting a No. 12 AWG (American Wire Gauge) stranded copper wire to the grounding fastener and to an earth-dr
Résumé du contenu de la page N° 15
OPERATION DANGER: Failure to properly ground generator can result in electrocution,especiallyifthegeneratorisequippedwith a wheel kit. National Electric Code requires generator to be properly grounded to an approved earth ground. Call an electrician for local grounding requirements OIL DIPSTICK WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this generator. The use of attachments or accessories not recommended can result in serious personal injury. APPLI
Résumé du contenu de la page N° 16
OPERATION If using an oxygenated fuel, make sure it is unleaded RECOIL and meets the minimum octane rating requirements. CIRCUIT ENGINE STARTING Before using an oxygenated fuel, try to confirm the fuel抯 BREAKER SWITCH GRIP contents. Some states/provinces require this information to be posted on the pump. The following are the EPA approved percentages of oxygenates: Ethanol (ethyl or grain alcohol) 10% by volume. You may use gasoline containing up to 10% ethanol by volume. Gasoline containing eth
Résumé du contenu de la page N° 17
ELECTRICAL DON'T OVERLOAD GENERATOR WARNING: CAPACITY Do not overload generator's capacity. Exceeding generator's wattage/amperage capacity can damage Make sure the generator can supply enough rated generator and/or electrical devices connected to it. (running) and surge (starting) watts for the items you will power at the same time. Follow these simple steps: Additional Rated* Surge 1. Select the items you will power at the same time. Tool or Appliance (Running) (Starting) 2. Total the rated (r
Résumé du contenu de la page N° 18
MAINTENANCE WARNING: When servicing, use only identical Poulan Pro replacement parts. Use of any other parts may createa hazard or cause product damage. Only the parts shown on the parts list are intended to be repaired or replaced by the customer. All other parts should be replaced ata Poulan Pro Authorized Service Center. GENERAL MAINTENANCE Keep the generator in a clean and dry environment where it is not exposed to dust, dirt, moisture, or cor- rosive vapors. Do not allow the cooling air slo
Résumé du contenu de la page N° 19
MAINTENANCE CLEANING FUEL SEDIMENT CUP gotten into the fuel tank from entering the carburetor. If the engine has not been run fora long time, the sediment cup should be cleaned before use. ■ Turn the fuel valve to the off position. ■ Remove the sediment cup using a 10 mm wrench. SEDIMENT ■ Remove the o-ring and filter. CUP ■ Clean each of the parts ina high flash-point solvent. ■ Reinstall the filter, o-ring, and sediment cup. Tighten with 10 mm wrench to secure. ■ Return the fuel valve to the O
Résumé du contenu de la page N° 20
MAINTENANCE MAINTENANCE SCHEDULE EACH FIRST EVERY 3 EVERY 6 EVERY SERVICE ITEMS USE MONTH OR MONTHS OR MONTHS OR YEAR OR 20 HOURS 50 HOURS 100 HOURS 300 HOURS 1 General Inspection X Check Oil Level X Change Engine O il X X 2 Clean Air C leaner X 2 Clean Cylinder Cooling Fins X Clean Spark Plug X Clean the Spark Arrestor X 3 Clean Fuel Sediment Cup X 3 Clean Fuel Tank X 3 Adjust Valve Clearance X 3 Check fuel line Every 2 years(Replace if necessary) STORAGE STORAGE When preparing the generator fo
