Résumé du contenu de la page N° 1
FREEZER
ZU 9100 F
INSTRUCTION BOOKLET
2222740-41
Résumé du contenu de la page N° 2
CONTENTS Instructions for the User Instructions for the Installer Important Safety Instructions 3 Technical specifications 12 Description of the Appliance 4 Installation 12 Positioning 12 Operation 4 Before use 4 Electrical Connection 13 Freezer controls 4 Starting your appliance 5 Building-in instructions 14 Temperature control 5 Door Reversal 14 Warning light (red) 5 Building the appliance in under a worktop 16 Temperature acoustic alarm 5 Fitting the plinth 19 Open door acoustic alarm 5 Freez
Résumé du contenu de la page N° 3
IMPORTANT SAFETY INSTRUCTIONS These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Departement. Prior to Installation During Use n Check the appliance for transport damage. Under n This appliance is designed for domestic use only, no circumstance should a damaged appliance be specific
Résumé du contenu de la page N° 4
DESCRIPTION OF THE APPLIANCE Freezer calendar Freezer control ` Compartment for frozen ´ food storage ˆ Compartment for freezing ˆ fresh food Thermometer ˜ °C ˜ ˆ ´ ´ 6 1 5 4 2 3 ` OPERATION Before use Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or deter- gent as the smell may linger. Dry thoroughly. Freezer controls 6 1 5 2 4 3 G F E D C B A ˘ ¯ ˜ ˆ ´ ` Thermostat Pushbutton ON/OFF
Résumé du contenu de la page N° 5
Starting your appliance food to be frozen in the two top compartments of the Insert the plug into the wall socket. The appliance freezer as this is the coldest part; if freezing only a can be activated/deactivated by pressing the small amount of food, always use the top compart- ON/OFF button.When the pilot light is illuminated ´ ment. this shows that the appliance is on. Once the food is completely frozen (which could take up to 24 hours) press the fast freeze switch to Temperature control deac
Résumé du contenu de la page N° 6
Internal thermometer This indicates the internal temperature of the freez- er. It may indicate a temperature above -18°C when large quantities of food are placed inside for freezing °C or when the door is left open for a long time. Thawing Frozen food, prior to being used, can be thawed in the fridge or at room temperature depending on the time available. Small food items may even be PR202 cooked from frozen; in this case cooking will take longer. Any frozen food which is allowed to thaw acciden
Résumé du contenu de la page N° 7
DEFROSTING The freezer compartment will become progressively Important covered with frost. This should be removed with the In the event of a power failure causing the special plastic scraper provided, whenever the thick- temperature within your freezer to rise, do ness of the frost exceeds 1/4". not re-freeze the food without checking its condition. The following guidelines should During this operation it is not necessary to switch off assist you: the power supply or to remove the foodstuffs. Ho
Résumé du contenu de la page N° 8
MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELEC- TRICITY supply. Warning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians. Internal cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly. NEVER USE DETERGENTS, ABRASIVE POW- DERS, HIGHLY PERFUMED CLEAN
Résumé du contenu de la page N° 9
SOMETHING NOT WORKING? Before contacting your local Service Force Centre check the following points. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom Solution No power to the appliance - Check there is power at the socket. - Check there is not a power cut by checking the household lights. - Check the fuse has not blown. The temperature in the freez
Résumé du contenu de la page N° 10
SERVICE AND SPARE PARTS In the event of your appliance requiring service, or if Before calling out an engineer, please ensure you you wish to purchase spare parts please contact have read the details under the heading ‘Something your local Zanussi Service Force Centre by Not Working?’ telephoning: When you contact the Service Centre you will need to give the following details. 1. Your name, address and post code 0870 5 929929 2. Your telephone number 3. Clear and concise details of the fault You
Résumé du contenu de la page N° 11
GUARANTEE CONDITIONS Standard guarantee conditions We, Zanussi, undertake that if within 24 months of the date of purchase this Zanussi appliance or any part there- of is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: n The appliance has been correctly installed and used only on the electricity supply stated on the rating plate. n The appliance has been
Résumé du contenu de la page N° 12
TECHNICAL SPECIFICATIONS DIMENSIONS Height 81,5 cm Width 59,6 cm Depth 53,8 cm POWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 Hz TOTAL POWER ABSORBED 90 W AVERAGE DAILY UNITS ELECTRICITY(*) 0,75 kWh GROSS CAPACITY 108 l NET CAPACITY 100 l STAR RATING (*)This figure is based on standard test results in accordance with European Standard EN153. Actual con- sumption will depend on how the appliance is used and where it is located. INSTALLATION Positioning For this appliance to work efficiently, i
Résumé du contenu de la page N° 13
ELECTRICAL CONNECTION This appliance complies with the E.E.C. WARNING: Directive No. 87/308 of 2.6.87 relative to radio THIS APPLIANCE MUST BE EARTHED. interference suppression. The manufacturer declines any liability This appliance complies with the following should this safety measure not be observed. E.E.C. Directive: If the plug that is fitted to your appliance is not suit- - 73/23 EEC of 19.2.73 (Low Voltage Directive) able for your socket outlet, it must be cut off and the and subsequent a
Résumé du contenu de la page N° 14
BUILDING-IN INSTRUCTIONS Before carrying out any work, remove the plug from the power socket. Door Reversal Left door opening: 1. Remove the grid from the appliance pulling it A towards you with hands. 2. Remove the left side (A) of the grid cutting it from the rear (see figure). DO002 To reposition the grid on the appliance proceed as fol- lows: a Apply the grid to the base of the appliance by pushing the clasps (a) until they click. N.B. The grid is to be assembled after having fixed the app
Résumé du contenu de la page N° 15
To reverse the opening direction of the door, proceed as shown in the figures: Attention After completion of the door reversing opera- tion, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fit- ting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting. 15
Résumé du contenu de la page N° 16
600 550 min. Building the appliance in under a worktop The dimensions of the recessed installation area must correspond with those indicated in the figure. DO013 Remove covering and adjusting strips. Push the appliance into place. The plug socket neces- sary for connection of the appliance to the electricity supply should be positioned, so that the plug is not placed in the recess. S.I.005 Adjust height. 16 600
Résumé du contenu de la page N° 17
To mount the furniture door proceed as shown in the figures: 17
Résumé du contenu de la page N° 18
Screw appliance into place. Refit the covering strip. 18
Résumé du contenu de la page N° 19
25 ÷ 80 Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. n For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=870 mm and a plinth height dimension b=150 mm. n For plinth heights greater than a=100 mm, b=150 mm, a cut should be made in the plinth, 580 mm wide, in the centre of the appli
Résumé du contenu de la page N° 20
© Electrolux Household Appliances Limited 2000
