Résumé du contenu de la page N° 1
SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY
THIS MANUAL IS PRINTED ON RECYCLED PAPER
EG 28 B Vented
By SHERWOOD INDUSTRIES
OWNERS MANUAL
WHAT TO DO IF YOU SMELL GAS
WARNING
• Open windows
If the information in this manual
• Do not try to light any appliance.
is not followed exactly, a fire or
• Do not touch any electrical switch; do not use any explosion may result causing
property damage, personal
phone in yo
Résumé du contenu de la page N° 2
SAFETY PRECAUTIONS FOR SAFE INSTALLATION AND OPERATIONOF YOUR "ENVIROGAS" STOVE, PLEASE, CAREFULLY READ THE FOLLOWING INFORMATION: • To prevent injuries do not allow anyone who is GENERAL unfamiliar with the operation to use the stove. • Installation and repair should be done by a qualified service person. The appliance should • Always keep the appliance area clear be inspected before use and at once least and free of combustible materials, gasoline annually by a qualified serv
Résumé du contenu de la page N° 3
TABLE OF CONTENTS Safety Precautions 2 Code Approvals 3 Deciding where to locate your stove 4 Venting 6 Installation of Log Sets and Embers 8 Operating Instructions 9 Maintenance and Technical 10 Trouble Shooting 11 Gas Line Connection 12 Electrical 13 Parts and Accessories 14 Fuel Type Conversion 15 Warranty 16 Parts List 17 Exploded Views 18-19 Installation Data Sheet 20 CODE APPROVALS • This Vented appliance draws all of its combustion air from the dwelling and m
Résumé du contenu de la page N° 4
DECIDING WHERE TO LOCATE YOUR STOVE DIMENSIONS: Front Width: 22"/ 56cm Rear Width: 22"/ 56cm Height: 27-1/2"/ 70cm* Depth 19"/ 48cm (*not including vent coupling) Shipping Weight: 210 lbs/95 kg FIG. 1 CLEARANCES: A. Side wall to stove 10"/ 25cm B. Rear wall to stove 4"/ 10cm C. Combustible to stove Top 22”/ 56cm D. Floor to stove 0"/ 0cm E. Corner clearance 2"/ 5cm F. Alcove depth 48"/ 122cm Maintain sufficient clearances for serv
Résumé du contenu de la page N° 5
VENT TERMINAL CLEARANCES Figure 3 A= Clearance above grade, verandah, porch, deck, or H= *Not to be installed above a meter/regulator [balcony (*12 inches (30cm) minimum] assembly within 3 feet (90cm) horizontally from B= Clearance to window or door that may be opened [*12 the center-line of the regulator inches (30cm) minimum] I= Clearance to service regulator vent outlet C= Clearance to permanently closed window [*6 feet (1.8m) minimum] [minimu
Résumé du contenu de la page N° 6
VENTING This model must have a vent opening in the rear of the unit. Confirm this and also check that the label on the right side panel door states "Vented Room Heater". WARNING: THIS APPLIANCE HAS BEEN DESIGNED TO OPERATE BY DRAWING COMBUSTION AIR AND DILUTION AIR FROM THE ROOM. THE DRAFT HOOD LOCATED IN THE SAME ATMOSPHERIC PRESSURE ZONE AS THE COMBUSTION AIR INLET TO THE APPLIANCE. IT IS ALSO DESIGNED TO DRAW ROOM AIR FOR PROPER HEAT CIRCULATION FROM THE REAR OF THE UNIT. BLO
Résumé du contenu de la page N° 7
A. USING AN EXISTING CHIMNEY • Measure the height of the chimney beforehand and purchase the appropriate kit. Never attempt to over stretch a flexible liner to accommodate the height of the chimney. • Any flue damper must be removed or locked permanently in the open position. • The chimney must be clean, in good working order and constructed out of non-combustible materials. • Make sure that all chimney clean-outs are tightly fitting and will not permit air to leak into the chimney
Résumé du contenu de la page N° 8
INSTALLATION OF LOG SET and EMBERS INSTALLING THE GLOWING EMBERS A bag of Rock Wool embers is provided for use on the burner tray. CAUTION: Use only the type of ember material supplied with this appliance. Due to the irregular size of the ember material there may be more than required. If over time, through cleaning and servicing, these embers require replacement, contact your nearest ENVIROGAS dealer for replacement embers. Remove the ember material from the plastic bag.
Résumé du contenu de la page N° 9
OPERATING INSTRUCTIONS FOR YOUR SAFETY READ BEFORE OPERATING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A) This appliance is equipped with a pilot, which must be lit by • If you cannot reach your gas supplier, call the fire hand by following these instructions exactly. department. B) BEFORE LIGHTING smell all around the appliance area C) Use only your hand to push in or turn t
Résumé du contenu de la page N° 10
MAINTENANCE AND TECHNICAL Annually check to ensure that your 3. Ensure the door is properly fastened after Venting system is clear. cleaning before attempting to re-light the appliance. Periodically check the pilot and burner. Check to TO REPLACE DOOR AND GLASS ASSEMBLY see that all the burner ports are clean and clear. Check the pilot head for blockage. Check to ensure The glass in this appliance is an integral part of the the pilot flame is blue with small yellow ti
Résumé du contenu de la page N° 11
Problem Possible Cause Solution Spark will not light the pilot after Defective piezo igniter Check connections to igniter repeated pressing of spark igniter -If igniter connections are good but there is no spark-replace igniter Broken spark electrode -Check for broken ceramic insulation replace, electrode if broken Miss-aligned spark electrode -If spark is not arcing from the electrode to pilot- adjust by loosening screws on pilot base. Adjust and re- tighten Pilot will not remain
Résumé du contenu de la page N° 12
GAS LINE CONNECTION ORIFICE SIZES, PRESSURE AND BTU’S NATURAL GAS PROPANE GAS Orifice size #42 dms #53 dms Manifold pressure. 3.8” wc (0.95 kPa) 11” wc (2.74 kPa) Min. Manifold pressure. 1.1” wc (0.27 kPa) 2.7” wc (0.67 kPa) Supply Pressure. 7.0” wc (1.74 kPa) 12” wc (2.98 kPa) Min. Supply pressure. 5” wc (1.25 kPa) 11.5” wc (2.86 kPa) Max. BTUH Input. 26,500 Btu/h(7.87 kW) 26,500 Btu/h(7.87 kW) Min. BTUH Input. 13,500 Btu/h(3.9 kW) 13,500 Btu/h(3.9 kW) Output fan off 20
Résumé du contenu de la page N° 13
The ENVIROGAS EG 28.FS.BV. will operate with no external power supply. These models have a Millivolt gas control which uses the pilot flame to generate enough electricity to operate the main burner. The appliance when installed, must be electrically connected and grounded in accordance with local codes or in the absence of local codes, with the current CSA C22.1 CANADIAN ELECTRICAL CODE. Part 1, SAFETY STANDARDS FOR ELECTRICAL INSTALLATIONS, or THE NATIONAL ELECTRICAL CODE ANSI / NFPA 70
Résumé du contenu de la page N° 14
PARTS AND ACCESSORIES Service Parts available from your local Envirogas Dealer Burner Control Assembly Convection Blower Natural Gas Pilot Assembly Light Bulb Holder Propane Pilot Assembly Light Switch (momentary) Door Bolt Fan Controller Relief Door Gasket Log Set (with Embers) Regulating Valve Thermocouple Piezo Igniter Embers Burner Switch Thermopile Door Gasket B-vent Spill switch 220° Orifice Blank Convection Fan Sensor 120° (48°C) Accessories Gold trim Package L
Résumé du contenu de la page N° 15
ADJUSTING THE VENTURI • Remove the ash shelf by undoing the screw at each end, pull shelf towards you. • Remove one screw from the cover plate located below the ash shelf. Loosen the other screw (do not remove) swing the cover plate out of the way and tighten screw down to hold it in place. • With along screwdriver rotate spring clips to open or close the shutter to the desired setting. • The burner flame should be a bright yellow/orange when hot. Excessive blue is to lean and da
Résumé du contenu de la page N° 16
WARRANTY Because of our high standards Sherwood Industries Ltd. can offer a *Lifetime Warranty on all it’s gas products. Covered under this warranty are Cabinet Sides, Tops, Pedestals, Surround Panels and Chassis. These steel components are covered against manufacture’s defects for 5 years and labour for the first years and for parts only thereafter. Please refer to the warranty agreement for specific details on the coverage of your *Lifetime Warranty. Sherwood Industries Ltd. offer
Résumé du contenu de la page N° 17
PARTS LIST EC-001 120° F CERAMIC TEMP SENSOR EG28-108 FREESTANDING PEDESTAL EC-002 220° F CERAMIC SPILL SWITCH EG28-109 FS PEDESTAL DOOR EC-006 SIT NOVA 820 NG VALVE 50% EG28-116 BURNER TRAY TOP EC-007 SIT NOVA 820 LP VALVE 50% EG28-120 FS DV OWNERS MANUAL EC-009 THERMOCOUPLE (POST 10/00) EG28-121 FS BV OWNERS MANUAL EC-011 SPARK ELECTRODE w/CABLE EG28-123 FS CABINET SIDE PANEL EC-012 THERMOPILE EG28-124 FS BV STOVE TOP EC-013 PILOT NG w/ELECTRODE EG28-125 FIREBOX BAFFLE EC-014 PI
Résumé du contenu de la page N° 18
BV 4” FS BV CRIMPED STOVE TOP 120 ° F (49° C) FLUE PIPE EG28124 CERAMIC FAN EG28-169 TEMP SENSOR DV 4” EC-001 FS DV FLARED BV TOP STOVE TOP FLUE PIPE BAFFLE EG28-126 EG28-170 EG28-132 CONVECTION DV TOP BLOWER BAFFLE EC-030 EG28-131 FS FAN MOUNTING FS CABINET BRACKET SIDE PANEL EG28-304 EG28-123 WIRE CHANNEL EG28-139 DOOR MAGNET 220° F (104° C) AND BRACKET CERAMIC SPILL SWITCH EC-002 UPPER GOLD BARS 1 X 1 SIDE EG28-129 CABINET HINGE LOWER EC-054 GOLD B
Résumé du contenu de la page N° 19
FULLY ASSEMBLED PAN BURNER TOP PILOT EC-015 NG , 016 LP BURNER CONTROL ASSEMBLY PAINTED DOOR ASSEMBLY THERMOPILE COMPLETE WITH GLASS (A+B) EC-012 EG28-143 NG EG28-099 EG28-145 LPG THERMOCOUPLE GOLD DOOR ASSEMBLY EC-009 WITH GLASS (A+B) EG28-101 VENTURI PILOT ORIFICE TUBE EC-019 NG, 020 LP SPARK ELECTRODE EC-011 BURNER BRACKET GLASS GLASS RETAINER ORIFIC EXTRUSIONS GAS TRAY TOP E AND SIDES BLANK EC 022 DOOR LATCH DOOR LATCH BOLT STRIP EC-059 EG28-162
Résumé du contenu de la page N° 20
INSTALLATION DATA SHEET The following information must be recorded by the installer for warranty purposes and future reference. Model: EG 28 B vented Name of Dealer: Name of Owner: __________________________________________ ___________________________________________ Address: Address: ___________________________________________ __________________________________________ __________________________________________ ___________________________________________ _________
