Résumé du contenu de la page N° 1
C
N
E
R
G
T
I
INSTALLER / CONSUMER
SAFETY INFORMATION
PLEASE READ THIS MANUAL
BEFORE INSTALLING AND USING
APPLIANCE.
WARNING!
Dutchwest
IF THE INFORMATION IN THIS
MANUAL IS NOT FOLLOWED Natural Vent Gas Heater
EXACTLY, A FIRE OR EXPLOSION
Models: 2467, 2468
MAY RESULT CAUSING PROPER-
TY DAMAGE, PERSONAL INJURY
OR LOSS OF LIFE.
FOR YOUR SAFETY
Installation and service must be per-
formed by a qualified installer, service
agency or the gas suppler.
WHAT TO DO IF YOU SMELL
GAS:
• Do not try
Résumé du contenu de la page N° 2
Dutchwest Natural Vent Gas Heater Table of Contents PLEASE READ THE INSTALLATION & OPERATING INSTRUCTIONS BEFORE USING APPLIANCE. Thank you and congratulations on your purchase of a Dutchwest stove. IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard and will void the warranty. Installation & Operating Instructions ......................................................................
Résumé du contenu de la page N° 3
Dutchwest Natural Vent Gas Heater Installation & Operating Instructions The Dutchwest Natural Vent Room Heater, Model Nos. 2467 The Dutchwest Natural Vent Room Heater, when installed, and 2468, is a vented gas appliance listed to the ANSI standard must be electrically grounded in accordance with local codes or, Z21.88b-2001 and CSA-2.33b-2001 for Vented Room Heaters, in the absence of local codes, with the National Electrical Code and CSA 2.17-M91, Gas-Fired Appliances For Use at High Al-
Résumé du contenu de la page N° 4
Dutchwest Natural Vent Gas Heater Dutchwest Natural Vent Gas Heater Dimensions See Page 5 for Flue Collar Centerline Dimensions. 6���" (172 mm) C L Valve Inlet 24���" (622 mm) 28���" (721 mm) Valve C L 4���" Inlet (111 mm) 12���" 23" (318 mm) (584 mm) 17" (419 mm) Fig. 1 Dutchwest dimensions. 2008 Dutchwest NV dimensions 6/23/03 4 30002008
Résumé du contenu de la page N° 5
Dutchwest Natural Vent Gas Heater Ceiling Clearances Clearance Requirements Minimum Clearances to Combustible Materials 45" (1140mm) Measure side clearances as shown in Figures 2 through 5 from the outer edge of the cast iron stove top. Measure rear clearances from the outermost surface of 72" the sheet metal rear skirt. (1829mm) The Dutchwest heater is approved for installation into an alcove constructed of combustible materials to the dimensions and clearances shown in Figure 5. The same
Résumé du contenu de la page N° 6
Dutchwest Natural Vent Gas Heater Gas Specifications Venting Requirements and Options Max. Min. The Dutchwest must be properly connected to a listed Input Input 4” (102 mm) Type B venting system or to an approved Model Fuel Gas Control BTU/h BTU/h Class A masonry or factory-built chimney system. In Canada, a complete relining of Class A chimney sys- 2467 Nat Millivolt 28,000 20,000 tems is required. 2468 Prop Millivolt 28,000 19,000 The Dutchwest Natural Vent stove will accept decor
Résumé du contenu de la page N° 7
Dutchwest Natural Vent Gas Heater Passing Through a Venting Requirements Combustible Wall or Ceiling 36 An approved pass-through device is always required 34 A when a vent passes through a combustible wall or ceil- 32 B ing. Check with the maker of the vent system for the 30 correct listed devices that are available. A listed pass- 28 through device is required whether or not the installa- 26 tion includes decorative pipe around the Type B venting 24 system. NOTE: It is essential to seal
Résumé du contenu de la page N° 8
Dutchwest Natural Vent Gas Heater 4. Disassemble the inner shroud from the outer shroud Install the Optional Fan by removing the four screws, two on each side. 1. The fan kit includes a blower assembly and a rheo- 5. Place the grommet provided in the manual bag as- stat assembly, connected by a cable. The blower as- sembly on the inner shroud. Run the snapstat exten- sembly mounts to the bottom rear of the stove, and sion assembly leads through the grommet toward the rheostat mounts to the le
Résumé du contenu de la page N° 9
Dutchwest Natural Vent Gas Heater Venting System Assembly Snapstat Left Air Duct The venting collar is on the sheet metal draft hood/heat exchanger assembly, over the firebox. Use a B-vent adapter, from the same maker as the rest of the B-vent components, to join the first section of venting to the draft hood. The stove includes a spill switch. Operating this stove when not connected to a properly installed and main- ST671 tained venting system, or tampering with or disconnect- Fig. 12 Insta
Résumé du contenu de la page N° 10
Dutchwest Natural Vent Gas Heater Attach the first section of venting to the B-vent adapter. Connect the Gas Supply Line Depending on the length of the individual venting Check the Rating Plate attached by a steel cable to the sections and the lengths of the decorative pipe, you firebox, to confirm that you have the appropriate firebox may need to slip the decorative pipe over the venting for the type of fuel to be used. The Dutchwest may be sections before attaching upper sections to lower o
Résumé du contenu de la page N° 11
TP TPTH TH PILOT ADJ Dutchwest Natural Vent Gas Heater Burner Information The appliance must only use the gas specified on the rating plate, unless converted using a CFM Corporation Fuel Conversion Kit. Refer to Page 23 for the correct Fuel Conversion Kit for your model. Conversion instructions are provided with each kit and beginning on Page 16 in this manual. ST228 THIS APPLIANCE SHOULD BE CONNECTED Fig. 20 Attach switch wires to valve. TO THE GAS SUPPLY ONLY BY A QUALI- FIED GAS SERVICE
Résumé du contenu de la page N° 12
UTCH UTCH EST EST D D W W Est. 1974 Dutchwest Natural Vent Gas Heater Install the Stove Front Left Log Insert the handle stub into the hole in the front casting. Right Fasten in place with the 3/8” locking nut provided. (Fig. Log 23) The front attaches to the stove by four steel tabs that engage with corresponding cast ribs onto the sides and bottom of the stove body. Position the front about 3” down from stove top and lift the plate to engage the upper tabs behind the adjacent ribs on th
Résumé du contenu de la page N° 13
Dutchwest Natural Vent Gas Heater Operation Your First Fire Read these instructions carefully and familiarize your- self with the burner controls. Locate the pilot assembly, Figure 25. Follow the lighting instructions on Page 14 exactly. During the first fire, it is not unusual to smell some odor associated with new logs, paint and metal being heated. Odors should dissipate within an hour or so, however, you can open a window to provide fresh air to CO105c alleviate the condition. Fig. 26
Résumé du contenu de la page N° 14
O 3 2 ON 1 T O Dutchwest Natural Vent Gas Heater Lighting and Operating Instructions FOR YOUR SAFETY READ BEFORE LIGHTING WARNING:If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This heater has a pilot which must be lit manu- • If you cannot reach your gas supplier, call the ally. When lighting the pilot follow these instruc- Fire Department tions exactly. C. Use only your hand to push in or turn the ga
Résumé du contenu de la page N° 15
Dutchwest Natural Vent Gas Heater Troubleshooting / Honeywell #8420 Gas Control System NOTE: Before troubleshooting the gas control system, be sure the external gas shutoff is in the “ON” position. WARNING: REMOVE THE GLASS PANEL BEFORE PERFORMING ANY GAS CONTROL SERVICE WORK. SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION A. Defective or misaligned Using a match, light [ilot. If pilot lights, turn off pilot and 1. Spark ignitor will electrode at the pilot push the ignitor button again. If pilot wil
Résumé du contenu de la page N° 16
O L L L I I Dutchwest Natural Vent Gas Heater 5. Remove the rear log bracket by loosening the screw Fuel Conversion Instructions and sliding the bracket up. CAUTION: Do not re- move the screw completely. It would be very difficult WARNING! This conversion kit shall be installed to replace it. (Fig. 29) by a qualified service agency in accordance with the manufacturer’s instructions and all applicable Loosen Screw Remove Screws codes and requirements of the authority having Rear Log Bracket j
Résumé du contenu de la page N° 17
Dutchwest Natural Vent Gas Heater • Remove pilot orifice with allen wrench. (Fig. 32) 1/8" Air Shutter (LP Position) • Install the conversion orifice. • Reinstall pilot hood. Be sure to align hood with index tab. 3/8" Pilot Hood Configuration for Stove with Serial #’s up to #5483 Air Shutter (LP Position) Pilot Configuration for Stoves with Serial Bracket #’s Starting at #5484 ST726 CO105a Fig. 34 LP air shutter settings. Fig. 31 Remove pilot hood. ST726 SNV Index Tab Left Burner Leg Alle
Résumé du contenu de la page N° 18
Dutchwest Natural Vent Gas Heater Table 2. Injector Orifice Size Matrix Conversion to Natural Gas Input (BTU/h) Air Shutter Kit # Front Part # Rear Part # Minimum Maximum Setting 000-5021 #54 / .055” 20000130 #44 / .086” 30000334 19,000 28,000 Fully Closed Conversion to LP Input (BTU/h) Air Shutter Kit # Front Part # Rear Part # Minimum Maximum Setting 000-5022 #69 / .029” 30000513 #54 / .055” 20000130 21,500 28,000 3/8” Open 18 30002008
Résumé du contenu de la page N° 19
D DUTCH UTCHW WEST EST Est. 1974 Dutchwest Natural Vent Gas Heater Maintenance Your Dutchwest Gas Heater will provide years of CAUTION service with minimal upkeep. The following procedures will help ensure that your stove continues to function TURN THE PILOT OFF BEFORE PAINTING. properly. ALLOW THE HEATER TO COOL COMPLETELY BEFORE PAINTING. Annual System Inspection Have the entire heater and venting system inspected Cleaning the Glass annually by a qualified gas technician. Replace any wor
Résumé du contenu de la page N° 20
Dutchwest Natural Vent Gas Heater Inspect the Vent System Annually Have the vent system inspected annually by a quali- fied technician. Shut off the main gas supply before inspecting the system. Both the inner exhaust pipe and the outer combustion supply pipe must be checked to confirm that they are unblocked and in good condition. Check the Gas Flame Regularly To ensure that the stove is operating properly, check ST582 the flames periodically to confirm they match Figure 39. Fig. 37 Release
