Résumé du contenu de la page N° 1
READ AND SAVE THESE INSTRUCTIONS
™
TUREEN
Model No.
Damp Location
CF980MAB 00
Ceiling Fan
CF980MBX 00
Owner's Manual
EMX
Net Weight: 35.8 Lbs.
LIMITED WARRANTY
What The Warranty Covers:
This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials.
You must be the original purchaser or user of the product to be covered.
What The Period Of Coverage Is:
As it applies to the motor, this warranty will last for a
Résumé du contenu de la page N° 2
! WARNING WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference 2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a warning device, such as a tag, to the service panel. 3. Be careful of
Résumé du contenu de la page N° 3
LIGHT HIHI MED MED LO LW OW RR EV EV FAN OFF This Manual Is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan Installed Wire Length Wire Size A.W.G. Tools Needed for Assembly Up to 50 ft. 14 One Phillips head screwdriver 50-100 ft. 12 One stepladder ! WARNING MATERIALS Wiring, outlet box and box connectors must be of type Before assembling your ceiling fan, refer to section on required by the local code. The minimum wire would proper met
Résumé du contenu de la page N° 4
LOWER HOUSING Electrical Requirements Your new ceiling fan will require a grounded electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit. The outlet box must be securely anchored and capable of withstanding a load of at least 50 pounds. ! WARNING FAN HOUSING To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support of 50 lbs. or less”, and use screws supplied with outlet box. Most outlet boxes commonly used for support of l
Résumé du contenu de la page N° 5
CAUTION: Before installing and tightening the screws, be sure there are no wires pinched MOTOR between the bottom of the light kit assembly and COUPLING SETSCREW (2) fan motor. HAIRPIN CLEVIS PIN CLIP 5. Install the three #10-24 x 5/16” pan head screws to DOWNROD secure the light kit assembly to the lower housing HAIRPIN CLIP (Figure 4). #10-24 x 5/16" PAN HEAD MOTOR SCREW (3) COUPLING LIGHT KIT ASSEMBLY CLEVIS PIN SETSCREW (2) Figure 6 ! WARNING LOWER It is critical that the clevis pin in th
Résumé du contenu de la page N° 6
12. Position one of the blade assemblies onto the ! WARNING motor hub and secure blade assembly using two 1/4-20 x 1/2” oval head flange screws (provided). It is critical that the pin in the hanger ball is properly Repeat for all blade assemblies (Figure 8). installed and the setscrews securely tightened. Failure to verify that the pin and setscrews are properly installed could result in the fan falling. 15.Reinstall the hanger ball on the downrod (Figure 1/4-20 x 1/2" OVAL HEAD 10) as follows.
Résumé du contenu de la page N° 7
How to Hang Your Ceiling Fan 2. Carefully lift the fan and seat the hanger ball/down- ! WARNING rod assembly on the hanger bracket that was just attached to the outlet box (Figure 13). Be sure the The fan must be hung with at least 7' of clearance groove in the ball is lined up with the tab on the from floor to blades (Figure 11). hanger bracket (Figure 12). CEILING ! WARNING Failure to seat tab in groove could cause damage to electrical wires and possible shock or fire hazard. AT LEAST 7' NOTE:
Résumé du contenu de la page N° 8
How to Wire Your Ceiling Fan If you feel that you do not have enough electrical 3. Using wire connectors (supplied), make wiring con- wiring knowledge or experience, have your fan nections as follows (Figure 14 and 15): installed by a licensed electrician. a. Connect the white fan wire and the white supply wire to the white receiver wire (AC IN/ MOTOR N). ! WARNING b. Connect the black fan wire to the black receiver Turning off wall switch is not sufficient. To avoid wire (TO MOTOR L). possible
Résumé du contenu de la page N° 9
SW105 TO RECEIVER 110V SUPPLY BLACK SUPPLY WHITE RECEIVER WIRE WHITE SUPPLY WIRE BLACK RECEIVER WIRE BLACK/WHITE RECEIVER BLUE RECEIVER WIRE WHITE FAN WIRE BLUE FAN WIRE BLACK FAN WIRE YELLOW RECEIVER WIRE DO NOT USE DOWNROD Figure 15 7. Secure the ceiling cover in place by sliding ! WARNING lockwashers (supplied) over the threaded studs and Check to see that all connections are tight, including installing the two knurled knobs (supplied). ground, and that no bare wire is visible at the wire (Fi
Résumé du contenu de la page N° 10
Halogen Bulb and Glass Installation 2. Place the glass onto the light kit assembly aligning 1. Do not touch the new 50-watt (maximum) MR-16, the three flat areas on the top flange of the glass GU-10 bulb with your bare fingers; using a cloth or with the three pins on the inside of the assembly soft gloves to hold the bulb, gently push it into the (Figure 19). Then turn the glass clockwise until it socket and twist to lock the lamp into the socket stops turning. (Figure 18). If there is any doubt
Résumé du contenu de la page N° 11
LIGHT LIGHT LIGHT REV REV HIHI MED MED LOW LOW REV REV FAN OFF HI HI ME MD ED LO LW OW FAN OFF HI MED LOW REV FAN OFF Setting Operating Installation Frequency of Wall Control of Wall Control and Receiver (Figure 20) ! WARNING Your wall control and receiver have code switches which must be set in one of 16 possible code combi- Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is nations. The four levers (numbered 1, 2, 3, and 4) on turned off at
Résumé du contenu de la page N° 12
Operating Your Ceiling Fan Trouble Shooting Wall Control IMPORTANT Fan installation must be completed, including the Fan/Light Fails to Operate installation of the fan blades, before testing of the • Check that the wall switch for the ceiling fan is in the “ON” wall control. position. Your SW114 Fan/Light Wall Control (Figure 23) has • Check that the battery is good (red indicator light should full control of your fan, lights, and airflow direction. light when any button is pressed). 1. To set t
Résumé du contenu de la page N° 13
INSTRUCTION TO THE USER (if device contains a digital device) This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interfer- ence in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if no installed and used in accordance with the instructions, may cause harmful interference to radio commun
Résumé du contenu de la page N° 14
! WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER BEFORE TROUBLE SHOOTING YOUR FAN. Trouble Shooting TROUBLE PROBABLE CAUSE SUGGESTED REMEDY 1. Fan will not start. 1. Fuse or circuit breaker blown. 1. Check main and branch circuit fuses or circuit breakers. 2. Loose power line connections to the fan, or loose 2. Check line power connections to fan and switch wire switch wire connections in the switch housing. connections in the switch housing. ! WARNING: Make sure main
Résumé du contenu de la page N° 15
LIGHT HIHI MED MED LOW LOW R R FAN OFF EV EV Repair Parts 2 1 5 3 4 15 11 10 19 18 6 7 9 16 8 23 17 22 24 14 12 20 13 21 15
Résumé du contenu de la page N° 16
Repair Parts Listing Part Numbers Key Model No. Model No. No. Description CF980MBX 00 CF980MAB 00 * Hanger Pack, Consisting of: 761655-67 761655-67 1 Hanger Bracket — — 2 Hanger Ball — — 3 Downrod, 8” — — * Parts Bag Containing: 763415 763415 4 Setscrew Wrench — — 5 Threaded Stud, 1-1/4” (2) — — 6 Lockwasher (2) — — 7 Knurled Knob (2) — — 8 Pin, Clevis (1) — — 9 Clip, Hairpin (1) — — 10 Screw, 1/4-20 x 1/2” Oval Head Flange (9) — — 11 Screw, #10-24 x 1/4” Oval Head Blade (13) — — 12 Screw, #10-2
