Résumé du contenu de la page N° 1
INSTALLATION INSTRUCTIONS
AND
OWNER’S MANUAL
INNSBROOK FIREPLACE INSERT
DIRECT VENT
GAS FIREPLACE HEATER
MODEL SERIES
DV25IN33L(N,P)-1
DV33IN33L(N,P)-1
DV35IN33L(N,P)-1
GAS-FIRED
UL FILE NO. MH30033
Installer: Leave this manual with the appli-
ance.
Consumer: Retain this manual for future refer-
ence.
WARNING: If the information in these instruc-
tions are not followed exactly, a fire or explosion
may result causing property damage, personal
injury or loss of life.
— Do not store or use gasoli
Résumé du contenu de la page N° 2
TABLE OF CONTENTS SECTION PAGE Important Safety Information .................................................................................................3 Safety Information for Users of LP Gas .................................................................................4 Introduction ............................................................................................................................5 Specifications ..................................................................
Résumé du contenu de la page N° 3
IMPORTANT SAFETY INFORMATION Before enclosing the vent pipe assembly, operate the appliance to ensure it is venting properly. DO NOT OPERATE THIS APPLIANCE WITHOUT GLASS FRONT PANEL INSTALLED • Children and adults should be alerted to the hazards • Keep the area around your appliance clear of of high surface temperatures and should stay away combustible materials, gasoline and other flammable to avoid burns or clothing ignition. vapor and liquids. • Young children should be carefully supervise
Résumé du contenu de la page N° 4
SAFETY INFORMATION FOR USERS OF LP GAS Propane (LP-Gas) is a flammable gas which can cause fires by point with the members of your household. Someday and explosions. In its natural state, propane is odorless and when there may not be a minute to lose, everyone’s safety colorless. You may not know all the following safety precau- will depend on knowing exactly what to do. If, after read- tions which can protect both you and your family from an ing the following information, you feel you still nee
Résumé du contenu de la page N° 5
INTRODUCTION Instructions to Installer Warning: ANY CHANGE TO THIS FIREPLACE OR ITS 1. Installer must leave instruction manual with owner after CONTROLS CAN BE DANGEROUS. installation. Improper installation or use of the fireplace can cause 2. Installer must have owner fill out and mail warranty card supplied serious injury or death from fire, burns, explosions, or with the fireplace. carbon monoxide poisoning. 3. Installer should show owner how to start and operate the fireplace. Any alteratio
Résumé du contenu de la page N° 6
SPECIFICATIONS DV25IN33L MODELS LP Nat Remote Control Description Accessories Input Btu/hr Maximum 25,000 25,000 FRBC Millivolt Battery Remote ON/OFF Btu/hr Minimum 17,000 17,000 FRBTC Millivolt Battery Remote T-Stat KWH (Maximum) 7.30 7.30 TMV Millivolt WIRELESS Wall Thermostat (Minimum) 5.00 5.00 TRW Millivolt Reed Switch Wall Thermostat Orifice #53 (0.0596) #42 (0.0935) Air Shutter Opening Full Open 1/8” DV33IN33L MODELS LP Nat Input Btu/hr Maximum 33,000 33,000 Surround Ki
Résumé du contenu de la page N° 7
FIREPLACE INSERT DIMENSIONS • Whether optional accessories - devices such as a wall switch When planning a fireplace insert installation, it’s necessary to or remote control - are desired. determine: • Electrical supply requirements for blower. • The vent system configuration to be used. • Proper opening size of fireplace required for installation of • Gas supply piping. the fireplace insert. DV FIREPLACE INSERT DIMENSIONS MODEL A B C D E F G H I J K L M N DV25IN 19 3/8” 28 14 1/2” 11 1/8” 25 1/4
Résumé du contenu de la page N° 8
MANTLE AND TRIM CLEARANCES 12 ” 10 ” COMBUSTIBLE MANTEL/TRIM AREA 23 ” 1 3/4 ” 1 1 ” 8” MINIMUM CLEARANCE T O PERPENDICULAR COMBUSTIBLE SIDE-W ALL (FROM EDGE OF DOOR FRAME) Figure 3 Figure 4 Combustible Material No greeting cards, stockings or ornamentation of any type should be placed on or attached to the fireplace. The flow of heat can ignite combustibles. Page 8 23015-3-0707
Résumé du contenu de la page N° 9
GAS SUPPLY The gas pipeline can be brought in through the right or left side of Installing the Main Gas Cock the appliance. The insert has a Flexline with shutoff valve located Each appliance should have its own manual gas cock. on the right side when facing the unit. See Figures 5 and 6. Consult A manual main gas cock should be located in the vicinity of the the current National Fuel Gas Code, ANSI Z223.1 CAN/CGA-B149 unit. Where none exists, or where its size or location is not ad- (.1 or .2
Résumé du contenu de la page N° 10
VENTING AND INSTALLATION 1. Before beginning, remove glass door and log package from 7. To assure top performance, safety and efficiency, inserts must unit. Also check to make sure there is no hidden damage to be installed with an approved flue liner as per CAN/CGA the unit. Take a minute and plan out the gas, venting and elec- B-149 or National Fuel Code ANSI Z223 and these instruc- trical route. It is best to start with the gas line first, followed tions. by the chimney liner and electrical sup
Résumé du contenu de la page N° 11
VENTING AND INSTALLATION Connecting the Vent Pipe Vent System Approvals Figure 8 shows the vent termination caps and systems approved Caution: Sharp edges. Always use gloves when installing. for use with these models. Approved vent system terminations Install the 3-inch flexible vent pipes down through the chimney. are labeled for identification. 3-inch diameter listed flexible aluminum or stainless steel gas vent is used for both the incoming Attach the pipe-to-cap adaptor to the termination ca
Résumé du contenu de la page N° 12
VENTING AND INSTALLATION RECT ANGULAR TERMINA TION CAP (DVVK3FV KIT) NOTE: LONG EXTENSIO N TUBE FOR INLET VENT ROUND CONNECTION. TERMINA TION CAP (DVKI KIT) ROUND CO-LINEAR T O CO-AXIAL ADAPT OR VENT CLAMPS RET AINER SCREWS M A Y USE HIGH TEM P BE INST ALLED THROUGH SEALANT ON VENT THE VENT CLAMPS T O CONNECTIONS ENSURE POSITIVE SECUREMENT OF VENTING. INT AKE VENT 10’ MINIMUM 35’ MAXIMUM FLUE EXHAUST VENT OPTIONAL ON/OFF SWITCH LOCA TION VENT CLAMPS OPTIONAL ON/OFF SWITCH LOCA TION USE HIGH TEM
Résumé du contenu de la page N° 13
VERTICAL TERMINATION Determining Minimum Vent Height Above the Roof. Vertical Through the Roof Applications The Gas Fireplace Insert has been approved for: WARNING: Major U.S. building codes specify minimum a) Vertical installations up to 35 feet in height (top of insert to chimney and/or vent height above the roof top. These minimum cap). heights are necessary in the interest of safety. These specifica- b) Two sets of 45 degree elbow offsets (bends in flexvent) within tions are summarized in
Résumé du contenu de la page N° 14
ALTERNATE ON/OFF SWITCH INSTALLATION WIRING THE FIREPLACE Note: Electrical wiring must be installed by a licensed electrician. CAUTION: DISCONNECT REMOTE CONTROLS IF YOU ARE AB- SENT FOR EXTENDED TIME PERIODS. THIS WILL PREVENT ACCIDENTAL FIREPLACE OPERATION. Installation of Alternate Surround Panel ON/OFF Switch An ON/OFF switch and wire assembly are provided. They are included in the instruction packet. Do not cut wire or insulation on metal edges. Note: Refer to surround panel installation
Résumé du contenu de la page N° 15
SURROUND PANEL INSTALLATION INSTALLING THE TRIM SURROUNDS Combustible materials MUST NEVER overlap onto the front face. WARNING: WHEN FINISHING THE FIREPLACE INSERT, NEVER OBSTRUCT OR MODIFY THE AIR INLET/OUTLET LOUVERS ON THE FIREPLACE IN- SERT IN ANY MANNER. NOTE: INST ALL SURROUND P ANELS SO TH A T TH E T OP P ANE L RETURN FLANGE SLIDE’ S OVER TH E T OP FLANG E O N TH E INSER T Figure 15 ENGAGE SID E P ANEL HOOK S W ITH TH E NOTCHE S P ROVIDED O N THE SIDE FLANGE S SURROUND P ANEL ASSEMBL
Résumé du contenu de la page N° 16
BLOWER ACCESSORY INFORMATION The appliance, when installed must be electrically connected and grounded in accordance with local codes or, in the absence of local codes, with the current CSA C22.1 Canadian Electrical Code. U.S. Installations, follow local codes and the National Electrical Code, ANSI/NFPA No. 70. Should this blower require servicing, the power supply must be disconnected. For rewiring of any replacement components, re- fer to Figures 16 and 17 and the parts list on page 25. B
Résumé du contenu de la page N° 17
LOG PLACEMENT Before you begin: This fireplace insert is supplied with a set of seven ce- 13. Replace the glass door assembly onto the fireplace insert. ramic fiber logs. Do not handle these logs with your bare hands. Always 14. Secure the glass door with the two spring clamps located under the wear gloves to prevent skin irritation from ceramic fibers. After handling firebox. logs, wash your hands gently with soap and water to remove any traces 15. Re-install the upper and lower louver assemblies b
Résumé du contenu de la page N° 18
OPERATING INSTRUCTIONS 750 Millivolt System Initial Lighting The standing pilot (750 millivolt system) is a continuous burning Upon completing the gas line or turning the gas valve on after it pilot. The pilot remains ON even when the main burner is OFF. has been in the “OFF” position, a small amount of air will be in the lines. When first lighting the fireplace, it will take a few minutes When you ignite the pilot, the thermopile produces millivolts for the lines to purge themselves of this a
Résumé du contenu de la page N° 19
STANDING PILOT LIGHTING INSTRUCTIONS FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by hand. • If you cannot reach your gas supplier, call the fire depart- When lighting the pilot, follow these instructions exactly. ment. B. Before lighting smell all around the appliance area for gas. C. Use only your hand t
Résumé du contenu de la page N° 20
STANDING PILOT WIRING For Standing Pilot Ignition Wiring Optional Wall Switch Position the wall switch in the desired position on a wall. Run a Appliance Requirements maximum of 25 feet (7.8m) or less length of 18 A.W.G. minimum wire and connect it to the fireplace valve pigtails. WARNING: DO NOT CONNECT 110-120 VAC TO THE GAS CONTROL VALVE OR THE APPLIANCE WILL MALFUNCTION AND THE VALVE WILL BE DE- WARNING: DO NOT CONNECT THE 110-120 VAC STROYED. TO THE WALL SWITCH OR THE CONTROL VALVE WIL
