Résumé du contenu de la page N° 1
®
Hardware Installation
™
Tracker Version 12
Building Automation System
BMTK-SVN01D-EN
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
® Hardware Installation ™ Tracker Version 12 Building Automation System BMTK-SVN01D-EN February 2004
Résumé du contenu de la page N° 4
Résumé du contenu de la page N° 5
® Tracker Version 12 Building Automation System Hardware Installation This guide and the information in it are the property of American Standard Inc. and may not be used or reproduced in whole or in part, without the written permission of American Standard Inc. Since Trane has a policy of continuous product improvement, it reserves the right to change design and specification without notice. Use of the software contained in this package is provided under a software license agreement. Unauthori
Résumé du contenu de la page N° 6
® NOTICE: Warnings and Cautions appear at appropriate sections throughout this manual. Read these carefully: WARNING Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury. CAUTION Indicates a potentially hazardous situation, which, if not avoided, may result in minor or moderate injury. It may also be used to alert against unsafe practices. CAUTION Indicates a situation that may result in equipment or property-damage-only accidents. The fo
Résumé du contenu de la page N° 7
Contents Chapter 1 Overview. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Controller components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Termination module. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Main module. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Display module. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Résumé du contenu de la page N° 8
Contents Wire the UCMs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 Wire specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29 UCM wiring configurations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32 Termination resistor placement for Comm5 links . . . . . . . . . . . . . . 34 Wire supported UCMs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37 Requirements for
Résumé du contenu de la page N° 9
® Chapter 1 Overview The Tracker building automation system (BAS) is an energy management system for small- to medium-size buildings. The Tracker BAS controls heating, ventilating, and air conditioning (HVAC) equipment. It consists of a Tracker controller (Figure 1) and an optional PC workstation. The Tracker BAS can be operated by using either a Tracker controller or a PC workstation that is running Tracker PC Workstation software. A visual interface enables an operator to set up and chang
Résumé du contenu de la page N° 10
® Chapter 1 Overview Figure 2. Example Tracker building automation system (models 12 and 24) on a network VariTrac or VariTrane zone dampers Voyager constant Precedent rooftop volume rooftop Voyager rooftop with ReliaTel controls TCI-V Interconnecting wiring (Comm5 link): single, twisted VariTrac central pair, shielded wire for two- control panel way communication. Tracer Tracer LCI-V LCI-R Utility pulse meter input Analog inputs Universal inputs Binary inputs Binary outputs Outdoor air Binary o
Résumé du contenu de la page N° 11
® Overview Figure 3. Example building automation system (water-source heat pump) on a network Tracer loop controller (for water-source heat pump) Tracer ZN510, ZN511, or ZN524 controller Analog inputs Binary inputs Binary outputs Voyager constant Precedent rooftop volume rooftop with ReliaTel controls Interconnecting wiring (Comm5 link): single, twisted pair, shielded wire for two- way communication. Tracer Tracer LCI-V LCI-R Utility pulse meter input Analog inputs Universal inputs Binary inputs
Résumé du contenu de la page N° 12
® Chapter 1 Overview Controller components The controller consists of a termination module, main module, and display module (Figure 4). Figure 4. Tracker controller components Termination module Main module Display module 4 BMTK-SVN01D-EN
Résumé du contenu de la page N° 13
® Controller components Termination module The termination module (Figure 5) is a housing that provides a termination board and cable access for power, communications, and system input connections. Mounting holes enable it to be mounted on a wall or a recessed conduit box. The termination board accepts connections for power, communications, and system inputs. Figure 5. Termination module Termination board Cable access (three places) BMTK-SVN01D-EN 5
Résumé du contenu de la page N° 14
® Chapter 1 Overview Main module The main module (Figure 6) is a housing that contains the main logic board and the Ethernet board. The main module can be “hot swapped”: it can be removed and installed without removing power from the termination module. When the main module is installed onto a powered termination module, it receives power and begins to operate automatically. The main logic board provides an Ethernet LAN port, a PC interface port, and a modem port. It provides an internal i
Résumé du contenu de la page N° 15
® Controller components Display module The display module (Figure 7) is a housing that contains a printed circuit board, liquid crystal display (LCD) touch screen, and an alarm LED. The printed circuit board supports the LCD touch screen and the alarm LED. The touch screen provides the operator access to the user interface program. The display module can be “hot swapped:” it can be removed and installed without removing power from the main module. When the display module is installed onto
Résumé du contenu de la page N° 16
® Chapter 1 Overview Model numbers Each controller is identified by a model number that provides information about the controller (Figure 8). Figure 8. Model number definition Digit number 1 2 3 4 5 6 7 8 9 10 11 12 13 14 Model number B M T K 0 0 0 A A 0 A x 1 0 Digit Description 1–2 BM = Building management 3–4 TK = Tracker 5–7 Customer ID: 000 = Customer sales office (CSO) KBB = Independent wholesale distributor (IWD) 8 A = 24 Vac, 50/60 Hz 9 Ethernet option A = Modem with no Ethernet LAN opt
Résumé du contenu de la page N° 17
® Tracker controller specifications Tracker controller specifications Table 1 shows the specifications for the Tracker controller. Table 1. Tracker Controller specifications Specification Description Power 24 Vac nominal (19 Vac to 30 Vac), 50/60 Hz, 1 phase 40 VA minimum, UL Class 2 transformer required Operating environ- From 32°F to 122°F (0°C to 50°C) ment 10% to 90% relative humidity, non-condensing Storage environment From –40°F to 185°F (–40°C to 85°C) 5% to 95% relative humidity, non-
Résumé du contenu de la page N° 18
® Chapter 1 Overview UCM maximum capacities for Tracker models 12 and 24 The Tracker model 12 and 24 controllers can control and monitor specific types and numbers of Trane unit control modules (UCMs) as specified in this topic. The supported UCMs are as follows: ® HVAC controllers that conform to the LonMark Space Comfort Con- troller (SCC) profile: the primary controller options are the Voyager rooftop with a Tracer LCI-V, Precedent rooftop with ReliaTel controls and a Tracer LCI-R, an
Résumé du contenu de la page N° 19
® UCM maximum capacities for Tracker model WSHP UCM maximum capacities for Tracker model WSHP The Tracker model WSHP controller can control and monitor specific types and numbers of Trane unit control modules (UCMs) as specified in this topic. The supported UCMs are as follows: Space Comfort Controllers (SCCs): the primary controller options are the Tracer ZN510, ZN511, and ZN524. Other controllers are limited to Voyager rooftops with a Tracer LCI-V, Precedent rooftops with Reli- aTel co
Résumé du contenu de la page N° 20
® Chapter 1 Overview Before installation Before beginning to install the Tracker controller, make sure that you have all the necessary controller components and that they are undamaged. Also, take steps to protect components until they are needed. IMPORTANT Before you install the Tracker hardware, review this guide and other Tracker support literature and create an installation plan. Verify the shipment When the shipment arrives at the job site, carefully unpack the carton. Even though outg
