Instruction d'utilisation Cub Cadet 759-04080

Résumé du contenu de la page N° 1

Installation Instructions
759-04080 CRUISE CONTROL KIT
For Series 6000 Tractor Models
KIT COMPONENTS
3
5
2
6
1
7
Ref. Pt. No. Description
1. 1750736 Special Screw
4
2. 1768971 Magnet w/Spring Assy.
3. 703-05791 Cruise Latch Bracket
4. 712-0240 Hex Jam Nut, 7/16-20
5. 725-0157 Cable Tie
6. 725-04246 Cruise Switch
7. 736-0171 Lock Washer, 7/16"
Introduction NOTE: The wire harness connector for the cruise switch
may be connected to the dash panel plug. If so, carefully
The cruise control kit

Résumé du contenu de la page N° 2

 Remove the dash panel insert by removing the two Remove Screws screws and lifting the insert out (See Figure 2).  Locate the unused dash harness connector (with green(2), green w/white, red w/black, yellow w/ black, and violet wires) inside the dash panel. Lift Fender the connector up through the hole in the dash panel Cover from which the plug was just removed. Screws Figure 4  From beneath the right running board, locate the Dash Panel Insert hex lock nut on the end of the pedal shaft. Us

Résumé du contenu de la page N° 3

 Insert the cruise latch bracket (Ref. 3) down Lock Washer Special Screw through the opening in the fender/running board so Tractor that its large plate area is against the left side of Spring Hex Frame Jam the magnet. See Figure 8. Nut Hex Tapp Screw Cruise Pedal Shaft Plate Latch Bracket Drive Shaft Shield Figure 6  Slide the lock washer (Ref.7) onto the special screw, then thread the hex jam nut (Ref.4) onto the Magnet screw. Refer to Figure 6. NOTE: Because of limited space between the pe

Résumé du contenu de la page N° 4

Setting The Cruise Control Disengaging the Cruise Control NOTE: Regardless of the method used, the indicator WARNING: Always use extreme caution light in the cruise switch will turn off when the cruise when operating the tractor with the control is disengaged. Simply depress the top of the cruise control engaged. Use good judge- switch to re-engage the cruise control. ment and maintain a safe speed for the conditions of operation. Disengage the cruise control using one of the following methods: