Instruction d'utilisation Dacor EF36BNFSS

Résumé du contenu de la page N° 1

REFRIGERATOR MODELS: EF36BNFSS & PF36BNDFXX*
*Where XX indicates color
Preference™ Handle Kit, INSTALLATION
PN AFP36H3 INSTRUCTIONS
Tools Required
• 3/32” Allen wrench (not supplied)
• T20 Torx driver (EF36BNFSS Only)
Parts Included
Preference Style Handles (2 Large, 1 Small)
Installation Preparation (Model EF36BNFXX Only.
For Model PF36BNDFXX, skip to Step 3):
STEP 1: Using a T20 Torx driver, remove the six (6)
handle mounting studs from the front of the
refrigerator. Retain the Torx mo

Résumé du contenu de la page N° 2

Refrigerator Handle Kit Installation Instructions STEP 2 (Model EF36BNFSS only): Using the T20 Torx driver and the screws removed in step 1, install the six (6) short mounting studs from the kit in the locations shown. Existing handle New mounting mounting screw stud from kit Handle Mounting Stud Locations Bottom (Freezer) Handle Installation STEP 3: Find the smallest of the three handles in the kit box. STEP 4: Mount the handle to the bottom drawer by sliding the holes on the back o

Résumé du contenu de la page N° 3

Refrigerator Handle Kit Installation Instructions Top Right Handle Installation STEP 7: Mount the handle to the right door by slid- ing the holes on the back over the handle mounting studs on the right door. Make sure the set screw holes face toward the center of the refrigerator. Loosen the set screws if necessary to allow the handle to slide into place. Set Screw Handle Mounting STEP 8: Carefully tighten the set screws into place Holes Studs using the 3/32” Allen wrench. Be careful n

Résumé du contenu de la page N° 4

Dacor ● 1440 Bridge Gate Drive, Diamond Bar , CA 91765 ● T el: (800) 793-0093 ● F AX: (626) 403-3130 ● www .Dacor .com