Résumé du contenu de la page N° 1
OWNER'S MANUAL
DieHard,
Portable Power 1150
Jump Starter/DC Power Source
Air Compressor, Inflator and AC Power
Model No.
200.71488
CAUTION:
Read all Safety Rules and Operating Instructions,
and follow them with each use of this product.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
00-99-000525/1205
Résumé du contenu de la page N° 2
bIL*_ :] I :l[o)=[e[o]_bll:l_11[-1 Warranty ........................................................................................................................ 2 Important Safety Instructions ........................................................................................ 3 Portable Power 1150 Product Features ........................................................................ 3 Operating Instructions .............................................................................
Résumé du contenu de la page N° 3
hVAI ;[o] Z_I IV;1_| | _-"T;1 d=/15"d II_[._ | zZi[o,)d[o] _[.'] SAVE THESE INSTRUCTIONS CHARGE THE 1150 BEFORE THE FIRST USE AND AFTER EVERY USE THEREAFTER. USE IN A WELL-VENTILATED SPACE. CONTAINS SEALED NON-SPILLABLE LEAD-ACID BATTERY. MUST BE DISPOSED OF PROPERLY. WARNING: POSSIBLE EXPLOSION HAZARD, CONTACT WITH BATTERY ACID MAY CAUSE SEVERE BURNS AND BLINDNESS. KEEP OUT OF REACH OF CHILDREN. WARNING: Handling the cord on this product or cords associated with accessories sold with this produ
Résumé du contenu de la page N° 4
[.]__;l-'_lil _[_ II_[-
Résumé du contenu de la page N° 5
Tooperate a12V DCdevice: blow. To replace, contact a qualified service technician. 1. Open theprotective cover oftheDC power outlet onthefrontpanel ofthe 4. Charge the Portable Power 1150 as Portable Power 1150. soon as possible after each use. 2. Plugthe12V DCdevice intotheDC Because the DC power outlet is in- power outlet, andturnonthe12V DC ternally wired directly to the internal device (ifrequired). battery, extended operation of a 12V 3. If both12VDCdevices combined DC device may result in
Résumé du contenu de la page N° 6
USING THE BUILT-IN LIGHT 1. Attachthecorrugated hosewith endadapter tothehigh-flow inflator 1. Position the 1150 on a flat, stable sur- face near the intended work area. outlet located directly above theinfla- torON/ OFF switch on the back of 2. Push the Light/Display switch to the the 1150. LIGHT position. The light will turn on 2. The main accessory nozzle attached and illuminate your work area. to the corrugated hose accommo- 3. Push the Light/Display switch to the dates up to 4 sizes. If ano
Résumé du contenu de la page N° 7
USING THE INVERTER successful, it is likely that the 1150 It is important to know the continuous inverter does not have the required wattage of the device you plan to use with capacity to operate the device in the inverter. The Portable Power 1150 question. must be used with devices drawing 400 5. Charge the Portable Power 1150 as watts or less. If the wattage is not marked soon as possible after each use. on the device, an estimate can be made CAUTION: Incorrect operation of your in- by multipl
Résumé du contenu de la page N° 8
110V AC ELECTRICAL DEVICE EXAMPLE RUN-TIME CHART Appliance Type Estimated Wattage Estimated Time* Spotlights, Sump Pumps, DVD Players 100 Watts 1.5 Hours Faxes, TVs, Small Power Tools 150 Watts 1.25 Hours Computer Printer, Medium Power 200 Watts 55 Minutes Tools, Blenders The maximum continuous load is 400 watts. *NOTE: Estimated run-times. Actual time may vary. Times are based on the internal battery being fully charged. DIGITAL DISPLAY FUNCTIONS CHARGING INTERNAL BATTERY 1. Portable Power 1150
Résumé du contenu de la page N° 9
4, Once the battery is fully charged, The internal battery may also be charged the built-in charger automatically while you drive using just the male-to- switches to float-mode monitoring, male accessory cable (included). Insert which trickle charges the battery and one end of the accessory cable into keeps it fully charged without over- the 12V DC power outlet and the other charging so the Portable Power 1150 end into the vehicle's accessory outlet may be left permanently connected to (lighter
Résumé du contenu de la page N° 10
I,,"] __[_] Ii [.!':_ i [.]_ f,.'] Maintenance-free AGMLead-acid Internal Battery Type 12vDC Nominal Voltage 22Ah Capacity DCPower Outlets (Max. Continuous 15A peroutlet Load) Built-in Light Bulb(Replaceable) 5w/12v DC(Base typeBA9S) Jumper Cables 4-gauge AWG, 24Inches 12HX11.5 X10.5 Inches Dimensions (HXWXD) 24.5 Lbs. Product Weight AC POWER SPECIFICATIONS Maximum Continuous Power ........................................................................ 400 Watts Surge Capacity (Output Wattage)
Résumé du contenu de la page N° 11
CONTAINS SEALED NON-SPILLABLE LEAD-ACID BATTERY. MUST BE DISPOSED OF PROPERLY. WARNING: Possible explosion hazard. Contact with battery acid may cause severe burns and blindness. Keep out of reach of children. 11
