Résumé du contenu de la page N° 1
CD RECEIVER KD-AR3000/KD-LH300
RECEPTOR CON CD KD-AR3000/KD-LH300
RECEPTEUR CD KD-AR3000/KD-LH300
KD-AR3000
ATT SOUND
U
KD-AR3000
R SOURCE F
D
VOL VOL
KD-LH300
ATT SOUND
U KD-LH300
SOURCE
R F
D
VOL VOL
• This unit is equipped with the display demonstration. To cancel it, see page 8.
• Esta unidad está equipada con demostración en la pantalla. Para cancelarla, consulte la página 8.
• Cet appareil est équipé d’une fonction de démonstration des affichages. Pour l’annuler, référez-
vous à la page 8.
Résumé du contenu de la page N° 2
INFORMATION (For U.S.A.) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guara
Résumé du contenu de la page N° 3
Thank you for purchasing a JVC product. Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit. CONTENTS How to reset your unit ............................... 2 GRAPHIC DISPLAYS ....................... 29 Downloading images and animations ....... 30 LOCATION OF THE BUTTONS ............ 4 Deleting unwanted files ............................. 32 Control panel..........................................
Résumé du contenu de la page N° 4
LOCATION OF THE BUTTONS Control panel 12 3 4 56 7 8 y KD-AR3000 KD-LH300 9p q wer t 1 Control dial q Number buttons 2 (standby/on attenuator) button w M MODE button 3 ANGLE button e Remote sensor 4 Display window r∞ (down) button 54 /¢ buttons t (control panel release) button 65 (up) button y For KD-AR3000: 7 FM/AM button CD/CD-CH (CD changer) LINE button 80 (eject) button For KD-LH300: 9 SEL (select) button CD/CD-CH (CD changer) button p D DISP (display) button Illumination Navigation for easy
Résumé du contenu de la page N° 5
3 • Selects the preset stations while listening to Remote controller the radio. Each time you press the button, the preset station number increases, and the selected station is tuned in. ATT SOUND • Skips to the first track of the previous folder while listening to an MP3 or a WMA disc. Each time you press the button, you can move to the previous folder and start playing the first track. U • While playing an MP3 disc on an MP3- SOURCE R F compatible CD changer; – Skips to the previous disc if pr
Résumé du contenu de la page N° 6
3. Return the battery holder. Preparing the remote controller Insert again the battery holder by pushing it until you hear a clicking sound. Before using the remote controller: • Aim the remote controller directly at the remote sensor on the main unit. Make sure there is no obstacle in between. (back side) WARNING: Remote sensor • Store the battery in a place where children • Do not expose the remote sensor to strong cannot reach. light (direct sunlight or artificial lighting). If a child accide
Résumé du contenu de la page N° 7
BASIC OPERATIONS 1 3 2 2 * Without connecting the CD changer, you Turning on the power cannot select “CD-CH” as the source. 3 * To select the external component as the source, 1 Turn on the power. set “Ext Input” correctly (see page 39). 3 Adjust the volume. Note on One-Touch Operation: To increase the volume When you select a source in step 2 below, the power automatically comes on. You do not have To decrease the volume to press this button to turn on the power. Volume level appears. 2 Select
Résumé du contenu de la page N° 8
To drop the volume in a moment 2 Press number button 1 to select Press briefly while listening to any “MOVIE”—Movie category of the source. “ATT” starts flashing on the display, and PSM settings. the volume level will drop in a moment. The “Graphics” setting screen appears on To resume the previous volume level, press the the display. button briefly again. • If you turn the control dial, you can also restore the sound. To turn off the power Press and hold for more than one second. • If you tur
Résumé du contenu de la page N° 9
Setting the clock 4 Set the minute. 1 Select “Clock Min” (minute). You can also set the clock system to either 2 Adjust the minute. 24 hours or 12 hours. 12 1 Press and hold SEL (select) for more than 2 seconds so that one of the PSM items appears on the display. (PSM: see pages 36 and 37.) The next-step-operation buttons 5 Set the clock system. start flashing. 1 Select “24H/12H.” 2 Select “24Hours” or “12Hours.” 2 Press number button 2 to select 12 “CLOCK”—Clock category of the PSM settings. Th
Résumé du contenu de la page N° 10
RADIO OPERATIONS To stop searching before a station is Listening to the radio received, press the same button you have pressed for searching. You can use either automatic searching or manual searching to tune in to a particular station. Searching for a station manually: Manual search Searching for a station automatically: Auto search 1 Select the band (FM1 – 3, AM). Each time you press the button, 1 Select the band (FM1 – 3, AM). the band changes as follows: Each time you press the button, the b
Résumé du contenu de la page N° 11
When an FM stereo broadcast is hard to 3 Tune in to a station you want while receive: “Manual Search” is flashing. Set the FM reception mode to “Mono On.” To tune in to stations of higher frequencies 1 Press M MODE while listening to an FM stereo broadcast. “Mode” appears on the display. To tune in to stations of lower frequencies The next-step-operation buttons start flashing. • If you release your finger from the button, the manual mode automatically turns off 2 Press number button 1 to select
Résumé du contenu de la page N° 12
Local FM stations with the strongest signals are Storing stations in memory searched and stored automatically in the band number you have selected (FM1, FM2, or FM3). You can use one of the following two methods to These stations are preset in the number buttons store broadcasting stations in memory. —No.1 (lowest frequency) to No.6 (highest • Automatic preset of FM stations: SSM (Strong- frequency). station Sequential Memory) When automatic preset is over, the station stored • Manual preset of
Résumé du contenu de la page N° 13
3 Press and hold the number button Tuning in to a preset station (in this example, 1) for more than You can easily tune in to a preset station. 2 seconds. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on pages 12 and 13. The display pattern automatically changes Selecting a preset station directly to the small animation display (see page 1 Select the band (FM1 – 3, AM). 14). Each time you press the button, the band changes as follo
Résumé du contenu de la page N° 14
Selecting a preset station using the Changing the display pattern preset station list By pressing D DISP, you can change the If you forget what stations are stored in which information shown on the display. preset numbers, you can check the preset station Each time you press the button, list, then select your desired station. the display patterns change as follows: 1 Select the band (FM1 – 3, AM). Each time you press the button, Ex.: When selecting preset station 1 of FM1 band the band changes a
Résumé du contenu de la page N° 15
Hierarchy DISC OPERATIONS This unit has been designed to reproduce CDs, Playing a disc CD-Rs (Recordable), CD-RWs (Rewritable), and CD Texts. 1 Open the control panel. • This unit is also compatible with MP3 and WMA discs. For details about these discs, refer to “A Guide to MP3/WMA” (separate volume). About MP3 and WMA discs Note on One-Touch Operation: ® MP3 and WMA (Windows Media Audio) “tracks” When a disc is already in the loading slot, (word “file” is not used to indicate MP3 or WMA pressin
Résumé du contenu de la page N° 16
Display indications when inserting an audio Display indications when inserting an MP3 CD or a CD Text: or a WMA discs: Total folder and track numbers Total track number and total playing time of the inserted CD MP3 indicator* Current track and elapsed playing time Notes: • MP3 or WMA discs require a longer readout time. (It differs due to the complexity of the folder/track configuration.) Current folder/track and elapsed playing time • The unit cannot read or play an MP3 track without the extens
Résumé du contenu de la page N° 17
What is ImageLink? To activate ImageLink, follow the procedure below: When an MP3 or a WMA folder includes an • See also “Changing the general settings image file edited by Image Converter (PSM)” on page 36. (supplied in the CD-ROM), you can show the image on the display while the tracks in the 1 Press and hold SEL (select) for more than folder are played back. 2 seconds so that one of the PSM items • While reading an image file, no appears on the display. sounds come out (“Image Lin
Résumé du contenu de la page N° 18
To go to a track quickly Locating a track or a 1 Press M MODE while playing a disc. particular portion on a disc “Mode” appears on the display. The next-step-operation buttons To fast-forward or reverse the track start flashing. Press and hold ¢ , while playing a disc, to fast-forward the track. Press and hold 4 , while playing a disc, to reverse the track. See page 30 for this function. 2 Press 5 (up) or ∞ (down) while “Mode” is still Note: on the display. During this operation on an MP3 or WMA
Résumé du contenu de la page N° 19
To go to a particular folder directly To skip to the next or previous folder (Only possible for MP3 or WMA disc) (Only possible for MP3 or WMA disc) IMPORTANT: Press 5 (up) while playing a disc To directly select the folders using the number to skip to the next folder. button(s), it is required that folders are Each time you press the button assigned 2 digit numbers at the beginning of consecutively, the next folder is their folder names. (This can only be done located and the first track in the
Résumé du contenu de la page N° 20
Selecting a track and start playback Selecting a folder and a track using the name lists 1 Press and hold 5 (up) or ∞ (down) so that the folder name list of the The following operations are only possible inserted disc appears on the when playing an MP3 or a WMA disc. display. The current playing folder will be You can show the folder name and track name highlighted on the display. lists on the display while playing a disc. Then, select a folder or a track you want to start playback with. Selecti
