Résumé du contenu de la page N° 1
H-CMD7075
DVD/MP3/CD RECEIVER DVD/MP3/CD-
Instruction manual
Résumé du contenu de la page N° 2
Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table o contents.............................................................................................................................................................................2 Importansafeguards............................................
Résumé du contenu de la page N° 3
IMPORTANT SAFEGUARDS Using the device at temperature below -10º may cause the breakage of the device. BEFORE USING PLEASE HEAT UP THE PASSENGER COMPARTMENT TO THE RECOMMENDED TEMPERATURE! · Read carefully through this manual to familiarize you with this high-quality sound system. · Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. · When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating ma
Résumé du contenu de la page N° 4
Installation/ Connections First complete the electrical connections, and then check them for correctness. Installation way (method 1) It is an anti-theft installation way. The chassis wear a metal sliding housing. Please have the wiring connection of the power supply, speakers and antenna as for the requirement of the manual, and then install the metal sliding housing into the car according to the diagram. 4
Résumé du contenu de la page N° 5
Installation way (method 2) Installation using the screw holes at both sides of the unit. 1. Select a position where the screw holes of the main unit are fitted for aligned, and tighten the screws at 2 positions at each side. Use either truss screws (5 x 8mm) or flush surface screws (4 x 8mm), depending on the shape of the screw holes in the bracket. 2. Screw. 3. Factory radio mounting bracket. 4. Dashboard or Console. 5. Hook (Remove this part). Note: The mounting box, outer trim ring, and the
Résumé du contenu de la page N° 6
Connection scheme: 6
Résumé du contenu de la page N° 7
Using the ISO Connector 1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated. 2. For connections without the ISO connectors, check the wiring in the vehicle carefully before connecting, incorrect connection may cause serious damage to this unit. Cut the connector, connect the colored leads of the power cord to the car battery as shown in the colour code table below for speaker and power cable connections. Location FUNCTION Connector A Connector B 1 Re
Résumé du contenu de la page N° 8
Controls description Front panel 1. OPEN BUTTON Press it to remove the front panel. 2. TA BUTTON In RADIO mode press it to active the TA function. 3. SCAN BUTTON In RADIO mode press it to start preset stations scanning. 4. PTY / CLK BUTTON Press it and hold for 2 seconds to set clock. In RADIO mode press it to active the PTY function. Press and hold it to set the time. 5. PRESET STATION [1-6] BUTTONS 6. / OSD button In menu use it to move to the left. During playback press it and hold for 2 sec
Résumé du contenu de la page N° 9
7. / RPT BUTTON In menu use it to move to the right. During playback press it and hold for 2 seconds to start repeat playback. 8. / INT BUTTON In menu use it to move upward. During playback press it and hold for 2 seconds to start intro playback (about 10 seconds each track). 9. / RDM BUTTON In menu use it to move downward. During playback press it and hold for 2 seconds to start random playback. 10. STOP BUTTON During playback press it to stop playback. 11. SET/PAU BUTTON Press it to enter t
Résumé du contenu de la page N° 10
Rotate it clockwise to increase the volume level; rotate anticlockwise to decrease the volume level. Press it repeatedly to select the mode: VOL => BAS => TRE => BAL => FAD => LOUD => LOC => ST => EQ. Rotate VOL knob to adjust each mode. 20. LCD (LIQUID CRYSTAL DISPLAY) 21. Disc slot 22. TUN TRK KNOB / MOD BUTTON Rotate it to adjust the radio frequency. Press it to choose the mode: RADIO => DISC => USB => CARD => AUX. 23. EJECT BUTTON Press it to eject a disc. 24. AF BUTTON Press it to active th
Résumé du contenu de la page N° 11
Remote control 1. MODE BUTTON 2. POWER BUTTON 3. BND/TA/SYS BUTTON 4. ERROR BUTTONS 5. ENTER BUTTON 6. STOP/REVERSE BUTTON 7. AMS/RPT BUTTON 8. ST/PROG BUTTON 9. LOC/AF/RDM BUTTON 10. VOL +/- BUTTON 11. PBC BUTTON 12. OSD BUTTON 13. DIGIT AREA 14. PLAY/PAUSE BUTTON 15. MUTE BUTTON 16. TITLE BUTTON 17. SUB-T BUTTON 18. SETUP BUTTON 19. ANGLE BUTTON 20. SLOW BUTTON 21. ZOOM BUTTON 22. SEL BUTTON 23. SEEK +/- /9/: BUTTONS 24. AUDIO BUTTON 25. GOTO BUTTON Changing the battery 1. Press the catch and
Résumé du contenu de la page N° 12
General operations Reset the unit Operating the unit for the first time or after replacing the car battery, you must reset the unit. Press OPEN button and remove the panel, then press the RESET button to restore the unit to the original factory settings. Power button Press any button to turn the unit on. Press the POWER button to switch the unit off. Note: After the unit is off, the clock, volume level and radio current settings will be memorized, and when you turn the unit on it will resume the
Résumé du contenu de la page N° 13
Sound settings Press SEL button shortly and repeatedly to select the mode: VOL => BAS => TRE => BAL => FAD => LOUD => LOC => ST => EQ. Rotate the VOL knob or use VOL +/- buttons to adjust each mode. · VOLUME: 00, 02,......, 44, 46 · BASS/TREBLE: -6, -5,......, 0, +1, +2,......+5, +6 · BALANCE: 12L, 11L,......, L=R, 1R,......,12R · FADER: 12R, 11R,......, R=F, 1F,......, 12F · LOUD: ON/OFF · LOC: LOC )N, LOC OFF (DX). · ST: STEREO, MONO · EQ: CLASS, POP, ROCK, FLAT, OFF Note: In each mode, the wa
Résumé du contenu de la page N° 14
Radio operations Note: RDS (Radio Data System) service availability varies with areas. Please understand if RDS service is not available in you area, the following service is not available, either. Band select Press the BAND button on the front panel or BND/SYS button on RC repeatedly to select your desired radio band during RADIO mode: FM1, FM2, FM3, AM1, AM2. Auto/ Manual tuning · Manual tuning: Press briefly the SEEK-/+ buttons on the RC or shortly rotate the TUN TRK knob on the panel to sele
Résumé du contenu de la page N° 15
· Auto memory store: press APS button on the panel for more than 2 seconds to enter auto store mode. The radio will automatically store the 6 strongest available stations to the 6 preset memories of the current band. To stop auto store, press this button again. Stereo/ Mono mode Press the ST/PROG button on the RC to select Stereo or Mono. OR press the SEL button until ST is selected, rotate the VOL knob to select Stereo or Mono. Local/Distance control Press the LOC/RDM button on the RC to select
Résumé du contenu de la page N° 16
PTY (Program Type) 1. Press PTY/CLK button on the panel to activate the PTY function. The previous PTY type is shown. 2. Press PTY/CLK once again to enter the MUSIC type or press twice to enter the SPEECH type, then use buttons 1 - 6 to select the desired program type (see the following table). 3. When PTY is selected, the radio starts to search corresponding PTY information, and stops if the corresponding PTY information is detected. 4. If there are no keys entered for 2 seconds, previously sel
Résumé du contenu de la page N° 17
Discs operations Disc glossary PBC (PlayBack Control) PBC is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it can playback interactive software with the menu displayed on TV. And if the disc contains still images, it can playback high definition of still image. Title The title is the important part of DVD disc. The memory volume of the disc is rather big, that makes possible to record several films on one disc. For example, if a disc contains three films, t
Résumé du contenu de la page N° 18
· Max. nested directory is 8 levels · The max. album number is 99 · The max. length of each track is 99 minutes 59 seconds · Supported sampling frequency for MP3 disc: 8 KHz 48 KHz (44.1 KHz preferably) · Supported bit-rates of MP3 disc are: 32 - 320 kbps (128 kbps preferably). · Following formats are NOT supported *.ACC, *.DLF, *.M3U, *.PLS, MP3 PRO, files with DRM. · Open session discs are NOT supported. USB/SD/MMC notes USB functions (flash memory type) MP3 music play. 1. SD/ MMC card suppor
Résumé du contenu de la page N° 19
Loading/ eject a disc · Turn the power on. · Insert the disc with the printed side facing upward into the slot. · Press EJECT button on the panel to eject the disc. Inserting the SD/ MMC card/ USB device Insert the MMC/ SD card or USB device into MMC/ SD compartment or USB socket. Then the playing mode will be changed into MMC/ SD or USB mode automatically. The first card/ USB device track playback will start. Note: When MMC/ SD card and USB device are both inserted into their compartment or soc
Résumé du contenu de la page N° 20
Slow playback (for DVD/VCD) During DVD / VCD playback press the SLOW button on the RC to execute the SLOW function. With each consecutive pressing of the SLOW button, the playback speed decreases: X1/2 => X1/3 => X1/4 => X1/5 => X1/6 => X1/7 => Normal. During slow forward, press the PLAY/PAUSE button to resume normal playback. Repeat playback Press and hold for 2 seconds the RPT button on the front panel or press shortly AMS/RPT button on the RC to repeat the current track playback. Press again
