Résumé du contenu de la page N° 1
Electric Dryer
Owner’s Manual
Register your product at
www.samsung.com/global/register
Code No.: DC68-02347B-02-EN
Résumé du contenu de la page N° 2
Features Extra Large Capacity Ultra washing and drying are at your fingertips! Now you can do extra-large loads in both the washer and dryer. Plus our ultra-large 7.3 cu.ft. capacity dryer circulates more air through your clothes getting them dry faster, for a wrinkle-free result. Various Drying Cycles & Fuzzy Logic Algorithm Simply turn the Jog Dial to select one of the 11 automatic drying cycles, including normal, heavy duty and towels. Or let Fuzzy Logic Control measure the degree of dampne
Résumé du contenu de la page N° 3
Safety Precautions Congratulations on your new Samsung Dryer. This manual contains valuable information on the installation, use, and care of your appliance. Please take the time to read this manual to take full advantage of your dryer’s many benefits and features. What you need to know about Safety Instructions Warnings and Important Safety Instructions in this manual do not cover all possible conditions and situations that may occur. It is your responsibility to use common sense, caution, an
Résumé du contenu de la page N° 4
Safety Precautions WHAT TO DO IF YOU SMELL GAS: • Do not try to light any appliance. • Do not turn on the appliance. • Do not touch any electrical switch. • Do not use any phone in your building. • Clear the room, building or area of all occupants. • Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. • If you cannot reach your gas supplier, call the fire department. Installation and service must be performed by a qualified installer, service agency,
Résumé du contenu de la page N° 5
Safety Precautions 10. Clean the lint screen before or after each load. 11. Keep the area around the exhaust opening and surrounding areas free from lint, dust, and dirt. 12. The interior of the dryer and exhaust duct should be cleaned periodically by qualified service personnel. 13. This appliance must be properly grounded. Never plug the power cord into a receptacle that is not grounded adequately and in accordance with local and national codes. See installation instructions for grounding th
Résumé du contenu de la page N° 6
Table of Contents Installation Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-1 Tools needed for installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . A-1 See Exhaust Requirements. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Résumé du contenu de la page N° 7
Installation Instructions Tools needed for installation Proper installation is the owner’s responsibility. HOWEVER, SERVICE CALLS PERFORMED AS A RESULT OF POOR SET-UP, ADJUSTMENT, AND CONNECTION ARE THE RESPONSIBILITY OF THE INSTALLER. Make sure you have everything necessary for proper installation. 1. GROUNDED ELECTRICAL OUTLET is required. See Electrical Requirements. 2. EXHAUST SYSTEM – must be rigid metal or flexible stiff-walled metal exhaust ducting. See Exhaust Requirements. Control panel
Résumé du contenu de la page N° 8
Installation Instructions DUCTING REQUIREMENTS • Use a 4-inch (10.2 cm) diameter rigid aluminum or rigid galvanized steel duct. • Do not use a smaller duct. • Ducts larger than 4 inches (10.2 cm) in diameter can result in increased lint accumulation. Lint accumulation should be cleaned regularly. • If a flexible metal duct must be used, use the type with a stiff sheet metal wall. Do not use a flexible duct with a thin foil wall. Serious blockage can result if the flexible metal duct is bent too s
Résumé du contenu de la page N° 9
Installation Instructions If new dryer is installed into an existing exhaust system you must make sure: • The exhaust system meets all local, state, and national codes. • That flexible plastic duct is not used. • Inspect and clean all lint buildup from inside the existing duct. • The duct is not kinked or crushed. • The exhaust hood damper opens and closes freely. The static pressure in any exhaust system must not exceed 0.83 inches of water column, or be less than 0. This can be measured with t
Résumé du contenu de la page N° 10
Installation Instructions MOBILE HOME INSTALLATION The installation of the dryer in mobile homes must conform to CSA Standards Z240 (for Canada). When installing a dryer in a mobile home, provisions for anchoring the dryer to the floor must be made. Locate in an area that has adequate fresh air. A minimum of 72 in² (183 cm² ) of unobstructed space is required. Call 1-800-SAMSUNG for information on purchasing the Floor Anchoring Kit as an accessory. All mobile home installations must be exhausted
Résumé du contenu de la page N° 11
Installation Instructions ELECTRICAL CONNE CTIONS Before operating or testing, follow all grounding instructions in the Grounding section. An individual branch (or separate) circuit serving only your dryer is recommended. DO NOT USE AN EXTENSION CORD. • A 120/240 volt, 60 Hz AC approved electrical service fused through a 30-ampere fuse or circuit breaker on both sides of the line is required. • The power cord should be plugged into a 30-ampere receptacle. NOTE: It is not permissible to convert
Résumé du contenu de la page N° 12
Installation Instructions Dryer Exhaust Tips WARNING: Plastic or non-metal flexible duct presents a potential fire hazard. 1 2 3 4 1. Let your dryer exhaust the air easily. 2. Use 4” diameter rigid metal duct.Tape all joints, including at the dryer. Never use lint-trapping screws. 3. Keep ducts as straight as possible. 4. Clean all old ducts before installing your new dryer. Be sure vent flap opens and closes freely. Inspect and clean the exhaust system annually. Don’t let a poor exhaust system slo
Résumé du contenu de la page N° 13
Installation Instructions Door Reversal 1. Unplug power cord. 6. Place the door on the other side and reattach it to dryer. 2. Remove two door hinge screws. 3. Lift the door and remove from dryer. 4. Remove two screws on the 7. Reassemble holder lever. opposite side of door hinge. 5. Remove two screws on holder 8. Reassemble the screws in the lever. remaining holes. SAMSUNG Dryer Owner’s Instructions A-7
Résumé du contenu de la page N° 14
Operating Instructions, Tips Control Features vary by model. OVERVIEW OF THE CONTROL PANEL B-1 SAMSUNG Dryer Owner’s Instructions
Résumé du contenu de la page N° 15
Operating Instructions, Tips 1. Digital Graphic Display The display window shows the estimated time remaining in the cycle after the Cycle Selector dial is pressed. The estimated time remaining may fluctuate as the cycle progresses. The Drying light will illuminate and remain lit until the cycle is complete. When your dryer is in the cool-down phase, the Cooling light will illuminate. When your dryer is in the wrinkle prevent phase, the Wrinkle Prevent light will illuminate. When the cycle is co
Résumé du contenu de la page N° 16
Operating Instructions, Tips 7. Select Cycle Option Adjust Time – Time can be added or subtracted from the automatically set times in the Manual Dry cycles (Time Dry, Freshen Up, Delicates, Wrinkle Release, or Air Fluff cycles). To add or subtract time from the cycle, press the Adjust Time arrow pad up or down until the desired time is displayed. My Cycle – Choose your favorite cycle including cycle, temp, dry level option, etc. (See page B4 for detail.) Rack Dry – Rack Dry is available at Tim
Résumé du contenu de la page N° 17
Operating Instructions, Tips CHILD LOCK A function to prevent children from playing with your dryer. SETTING/RELEASING If you want to set or release Child Lock, press both the Time and Signal buttons at the same time for 3 seconds. How to Set: 1. It can be set while your dryer is running. 2. Once you set the Child Lock function, no button, except for the Power button, can be controlled until you release the Child Lock function. 3. The Child Lock indicator will be lit. Notice: 1. If the power i
Résumé du contenu de la page N° 18
Operating Instructions, Tips Rack Dry(select models) INSTALLING THE DRYING RACK 1. Open dryer door. 2. Position drying rack in tumbler, placing the rear legs in the two recessed areas of the dryer’s back wall. 3. Place the front lip of the drying rack on top of the lint filter. 4. Place items to be dried on the rack, leaving space between them so air can reach all surfaces. 5. Close dryer door. 6. Use the Time Dry cycle. Select time according to moisture and weight of the items. Start dryer. It
Résumé du contenu de la page N° 19
Operating Instructions, Tips CLEAN THE LINT FILTER • After each load. • To shorten drying time. • To operate more energy efficiently. NOTE: Do not operate your dryer without the lint filter in place. LOAD THE DRYER PROPERLY • Place only one washload in your dryer at a time. • Mixed loads of heavy and lightweight fabrics will dry differently, which may result in lightweight fabrics being dry while heavy fabrics remaining damp at the end of a drying cycle. • Add one or more similar items to your drye
Résumé du contenu de la page N° 20
Care and Cleaning Control Panel Clean with a soft, damp cloth. Do not use abrasive substances. Do not spray cleaners directly on the panel. The control panel finish could be damaged by some laundry pre-treatment soil and stain remover products. Apply such products away from your dryer and wipe up any spills or overspray immediately. Tumbler Remove any stains such as crayon, ink, or fabric dye (from new items such as towels or jeans) with an all-purpose cleaner. Then tumble old towels or rags to
