Résumé du contenu de la page N° 1
CS-2012TW1
Super Rage™
2-Way AM/FM Paging Remote Alarm, Keyless Entry System & Engine Starting
System with 1-Way Sidekick Remote Control
OPERATING INSTRUCTIONS
CONGRATULATIONS on your choice of a CS-2012TW1 Super Rage™ Alarm & Remote Engine Starter by
Crimestopper Security Products Inc. This booklet contains the information necessary for operating your
system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc.
*IMPORTA
Résumé du contenu de la page N° 2
TABLE OF CONTENTS Operation Cautions & Warnings……..………..………………………………………………………….….………2 2-Way LED Paging Remote………………………………………………………….………..….……….…..……..3 1-Way “SideKick” Non-Paging Remote……………….………..………………………………….……..…..……..4 Paging Tones & LEDs……….………………………………………….………..…………………..….….…..…….5 . Operating Instructions - Alarm……………………………………………………….………..……………..……..6-9 LED Diagnostics………………..…………………………………………………………………….………..…..….9 Remote Engine Control………………………...……………………………………………………
Résumé du contenu de la page N° 3
2-WAY LED PAGING REMOTE PAGER / REMOTE TRANSCEIVER: The hand-held remote transceiver is used to send and receive information from the vehicle. The Control Module transmits confirmation signals from the vehicle to your pager. Your range will vary depending on location, terrain, and local RF noise/interference. This system is not guaranteed to page you if you are behind concrete walls, underground, in a large structure, or in an area with high levels of electronic interference. Handle
Résumé du contenu de la page N° 4
1-WAY “SIDEKICK” NON-PAGING REMOTE The 1-Way sidekick remote adds flexibility #2 to your CS-2012TW1. You have the convenience of operating your system UNLOCK/ without needing to carry the pager remote. DISARM The “Sidekick” remote offers all of the same operation features remote, except the range #1 #5 is lower and it will not receive page-back LOCK/ FLASHLIGHT confirmations from the vehicle. See ARM #6 diagram at right for Sidekick 1-Way remote operation. 2ND VEHICLE #3 BUT
Résumé du contenu de la page N° 5
PAGING TONES & LEDs CS-2012TW1 PAGING LEDs Blue LED: Orange/Green LED: Red LED: Yellow LED: Door Trigger Remote Start, Lock/Unlock, Shock sensor, Ignition Hood/Trunk Trunk pop PAGE-BACK: FEATURE BUTTON ACTION BEEPS LED COLOR & FLASH LOCK #1 (Lock) Press & Release 1X, then 1X Orange - 1X UNLOCK #2 (Unlock) Press & Release 1X, then 2X Green - 2X AUX #1 #3 (Trunk) Press & Release 1X, then 3 fast Yellow – 1 long AUX #2 #3 (Trunk) Press & Hold 1X NO PAGE BACK PANIC #1 (Lock) Pres
Résumé du contenu de la page N° 6
OPERATING INSTRUCTIONS - ALARM Active Arming / Locking: Press and release button #1 (Lock symbol) on the transmitter. The system will arm and confirm with one siren chirp, one light flash, and the LED will begin to flash. Power locks will lock (if equipped). Starter disable circuit will turn on. After a short delay to allow the vehicle and electronics to settle, the system is completely armed. Disarming: / Unlocking Press and release button #2 (Unlock symbol) on the transmitter.
Résumé du contenu de la page N° 7
OPERATING INSTRUCTIONS - ALARM Alarm Triggering An intrusion into the vehicle or hard impact to the body will sound the alarm and flash the lights for 1 minute. After 1 minute the trigger cycle will automatically stop and alarm will remain armed to continue protecting the vehicle. If a door is left open after an intrusion then the unit will cycle a maximum of 5 minutes and continue to protect the other un-tampered or unopened zones. Prior intrusion Alert This system will notify you
Résumé du contenu de la page N° 8
OPERATING INSTRUCTIONS - ALARM Remote AUX. Output 2 (Optional) This system contains a second auxiliary output to activate other accessories or devices. To activate the systems’ Second Auxiliary Output, press and hold Button #3 (Trunk Symbol) on the transmitter for more than 2 seconds. This is a momentary output that will stay active as long as the remote button is held down. Remote output #2 requires programming before operation. Check with your installer or follow programming option
Résumé du contenu de la page N° 9
OPERATING INSTRUCTIONS - ALARM Optional M.A.P. (Mobile Accessories Protection) This system can be programmed to provide Crimestopper’s unique M.A.P. (Mobile Accessories Protection) feature that allows you to prevent unauthorized access of your vehicles Audio, Cellular, Navigation, or Entertainment systems. This feature is OPTIONAL and will requires extra parts and labor for installation. Consult your installation dealer about MAP before or during installation. The CS2012TW1 must be pr
Résumé du contenu de la page N° 10
REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START DIAGRAM: SOLID FLASH 1X AFTER START IGN 3 STARTER SEC. THEN SOLID REMOTE ENGINE STARTING - UNSUCCESSFUL START In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, then nd rd attempts to restart the engine a 2 and 3 time. For hard starting engines, the unit will allow a starter crank time of up to10 seconds maximum. This should provide ample cranking time for difficult
Résumé du contenu de la page N° 11
REMOTE ENGINE CONTROL ENTERING YOUR REMOTE STARTED VEHICLE: 1) With engine running, Remote Unlock/Disarm system (If armed) or open door with key. 2) Enter vehicle and be careful not to step on brake pedal! (Remote Start Reset) 3) Turn Ignition to ON/RUN position, then press brake pedal to reset the Remote Starter & Shift out of park. 4) Remote starter will reset instantly when the brake is pressed. Parking lights will turn off and the ignition key is now controlling your vehicle. ID
Résumé du contenu de la page N° 12
REMOTE ENGINE CONTROL INFINITY RUN MODE This mode allows the vehicle’s engine to remain running INDEFINITELY. This mode can be beneficial to law enforcement vehicles or commercial vehicles that need to remain running unattended for long periods of time. INFINITY RUN MODE – EXITING THE VEHICLE: 1) Follow steps on the last page for “IDLE DOWN MODE - EXITING THE VEHICLE”, except press the remote start button TWO times at STEP #1. 2) Parking Lights will start flashing instead of coming o
Résumé du contenu de la page N° 13
REMOTE ENGINE CONTROL TIMED SELF START MODE This mode allows the vehicle to be programmed to self-start every 4 hours and run for the programmed run time. This can be helpful during extremely cold conditions where engine fluid freeze-up is a concern. THE VEHICLE MUST BE OUTDOORS OR IN A WELL VENILATED AREA. TIMED SELF-START MODE – EXITING THE VEHICLE: 1) Have engine running with the Key, then press and release the Start button. 2) Within the next 10 seconds press the valet/program
Résumé du contenu de la page N° 14
OPTIONAL TURBO TIMER MODE OPTIONAL TURBO TIMER MODE: IMPORTANT NOTE: This mode requires the use of an extra part called a momentary switch or button that is not included with the kit. Check with your installer about adding this feature. The optional Turbo Timer mode allows the your system to keep your vehicle running for 1 to 5 minutes [selectively] after you remove the key, exit the vehicle, and lock the doors remotely [if you own a Turbo or Turbo Diesel]. This is handy for turbo coo
Résumé du contenu de la page N° 15
ANTI CARJACK PROTECTION REMOTE OPERATED CARJACK PROTECTION This feature provides Active Carjack protection through the remote control. When the Ignition is on (vehicle is running), press and hold the #1 LOCK Button and #3 TRUNK Button for 3 seconds. The parking lights will flash 2 times and the LED will begin to flash rapidly to confirm the beginning of a Carjack countdown. 30 Seconds later, the unit will begin a Carjack Cycle consisting of 20 seconds of pre-warning chirps turning into
Résumé du contenu de la page N° 16
TRANSMITTER PROGRAMMING Note: Remotes Transmitters come pre-programmed from the Factory. When re-learning remotes or adding remotes, ALL your system’s remote codes must be learned at time of programming!! This system allows storage of up to 4 different remote codes in memory. 1. Open hood (ground the Blue hood pin wire if no hood pin is installed.) 2. Turn key to the ON position. (Starting the vehicle is not necessary.) 3. Press Program/Valet button 4 times. After a few seconds, t
Résumé du contenu de la page N° 17
PAGER REMOTE BATTERY REPLACEMENT CS-2012TW1 PAGER (LOW BATTERY WARNING) The CS-2012TW1 Pager LED has a low battery warning system. When the battery voltage is low, the Orange & Green LEDs flash 6 times with any button that is pressed. We recommend replacing the battery for proper operation. To replace the battery, simply unlock and slide open the battery door on the back of the LED remote. Carefully remove the low battery, then insert a new battery (AAA) using the outline on the button
Résumé du contenu de la page N° 18
TROUBLESHOOTING: “BEFORE YOU CALL SECTION” Before calling your dealer or Crimestopper, read the following for tips that may remedy the problem. RANGE QUESTIONS (2-Way Pager/Remote): Your CS-2012TW1 system uses Am & FM High-Frequency signals to send/receive data between the pager and the vehicle and from the vehicle to the remote for state-of-the-art operation. 1) Under normal operation, the distance from the vehicle-paging-the-remote will be greater than that from the remote-to-the-veh
Résumé du contenu de la page N° 19
TROUBLESHOOTING cont. UNIT FLASHES THE LIGHTS ONCE AND WILL NOT ATTEMPT A REMOTE START: The system is in Valet mode. Check the systems LED light and if it is on solid Red LED (with doors closed) then the system is in VALET mode. To exit VALET, turn the Ignition on, press and hold valet/programming button for about 5 seconds until LED goes out. Unit is now out of valet mode and should perform a remote start. SYSTEM DOES NOT RESPOND TO THE REMOTE CONTROL: 1. Check for proper power/gr
Résumé du contenu de la page N° 20
www.crimestopper.com email@crimestopper.com ONLINE TECHNICAL SUPPORT Phone (800) 998-6880 www.crimestopper.com/techweb03.html FAX (805) 581-9500 © 2005 Crimestopper Security Products
