Instruction d'utilisation Arcam CD93 Compact Disc player CD93/92

Résumé du contenu de la page N° 1

H A N D B O O K C D 9 3
English
Arcam CD93 Compact Disc player
Français
Lecteur de Disque Compact Arcam CD93
Deutsch
Arcam CD93 Compact Disc-Spieler

Résumé du contenu de la page N° 2

Safety guidelines 8. Cleaning CAUTION ATTENTION Unplug the unit from the mains supply before cleaning. RISK OF ELECTRIC RISQUE DE CHOC ELECTRIQUE SHOCK DO NOT OPEN NE PAS OUVRIR The case should normally only require a wipe with a soft, damp, lint-free cloth. Do not use paint thinners or other chemical CAUTION: To reduce the risk of electric shock, do not solvents for cleaning. remove cover (or back). No user serviceable parts We do not advise the use of furniture cleaning sprays or inside.

Résumé du contenu de la page N° 3

Using this handbook This handbook has been designed to give you all the Contents information you need to install, connect, set up and use the Arcam CD93 compact disc player. The CR-314 remote control Safety guidelines................................................... 2 handset supplied with this equipment is also described. Important safety instructions...................................2 Safety compliance .................................................2 Safety Using this handbook ........

Résumé du contenu de la page N° 4

Installation Positioning the unit Connecting to a power supply Always place the CD player on a level, firm surface. Placing Wrong plug? your player on a set of dedicated sorbothane isolation feet Check that the plug supplied with the unit fits your supply and will isolate the unit from its surroundings as well as absorbing that your mains supply voltage agrees with the voltage setting the vibrations created within the player itself. You will generally (230V) indicated on the rear panel of

Résumé du contenu de la page N° 5

Using your CD player COMPACT DISC PLAYER CD93 24 BIT / 192 kHz UPSAMPLING TECHNOLOGY TRACK LOAD PLAY STOP PAUSE POWER 1 2 3 4 5 6 7 POWER SKIP TRACK 1 7 Press this button to switch the CD player on and off. When first To start a CD with a track other than the first, press or powered up with no CD installed the display shows: to locate the desired track. To select another track during play, press or . The track is played automatically after selection. --NO DISC-- CDs with text LOAD 2 Load

Résumé du contenu de la page N° 6

Using the remote control CR-314 Remote Control Note that greyed-out buttons on the remote control are DVD- specific and are not used with the CD player. CD/DVD 0–9 keypad Ensure that CD mode is selected using the CD/DVD This allows direct access to individual tracks on the disc. toggle button. The ‘CD’ LED above the CD/DVD To select a track, press the corresponding keypad button. button is lit briefly when CD mode is selected. For tracks greater than 9, enter the digits in sequence. For exam

Résumé du contenu de la page N° 7

Technical specification NOTE: All specification values are typical unless otherwise Digital to Analogue conversion stated. High performance 192kHz 24-bit sample rate converter and multiple 24-bit digital to analogue conversion Continual improvement policy Laser pick-up 3 beam Arcam has a policy of continual improvement for its products. Laser wavelength 780nm This means that designs and specifications are subject to change without notice. Numerical aperture 0.45 Signal to noise ratio 114dB R

Résumé du contenu de la page N° 8

Guarantee Worldwide Guarantee It should be sent carriage prepaid by a reputable carrier -– This entitles you to have the unit repaired free of charge, during NOT by post. No responsibility can be accepted for the unit the first two years after purchase, at any authorised Arcam whilst in transit to the dealer or distributor and customers are distributor provided that it was originally purchased from therefore advised to insure the unit against loss or damage an authorised Arcam dealer or dist